In the circuit given below, V=4 kV, X=2 , R=1 , and f=50 Hz. Determinee(t) V2V cos(wt + a)+RFigure 1: Problem 1swr=0Find the rms symmetrical facult current

Voltage V=4 KV = 4000 V. Inductive reactance X=2 Ω. Resistance R=1 Ω. Frequency f = 50 Hz. Circuit…

Answered: In the circuit given below, V=4 kV, X=2…

In the circuit given below, V=4 kV, X=2 , R=1 , and f=50 Hz. Determine 9 SW1=0 e(t) = V2V cos(at + a) R Figure 1: Problem 1 Find the rms symmetrical facult current

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: r is connected in parallel with a load of S= 60C of 60 Hz. Calculate the capacitance value that 95…

A: Since you have asked a multiple question we will solve the first question for you, If you want any…

Q: The 60-Hz ac source of a series circuit has a voltage amplitude of 120 V. The resistance, capacitive…

A: Given data: R=490ΩXL=230ΩXC=960 Ω V=120V

Q: C. Draw a general sine wave V vs t and I vs t plot for a purely resistive and a purely inductive…

Q: 4- A Circuit of zero lagging power factor behaves as a. A capacitive circuit b. An inductive…

A: Given A circuit of zero lagging power factor Power factor is defined as the cosine of angle…

Q: A resistor, a capacitor, and an inductor are connected in series with a function generator. The…

A: If n number of resistor having resistance R1,R2.....................Rn is connected in series then…

Q: QUESTION 5 A resistor, a capacitor, and an inductor are connected in series with a function…

Q: Q4. Determine the equivalent inductance and equivalent current of the inductive circuit in Figure…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

Q: Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an…

A: The given circuit isWe need to find The formula for the total impedance, Ztot.The formula for the…

Q: Determine the rms current in the figure for Vrms = 16 V and C = 74µF

A: For the given circuit the RMS current needs to be calculated by converting the capacitance into…

Q: What is the length of No. 30 AWG (10-mil diameter) constantan wire at 20°C required for a 200-…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: For the given data to limit 20Vrm

Q: Problem E Provide steady-state waveforms for the cap voltage and output voltage on the same…

A: Need to obtain the output waveform and the waveform across the capacitor in the given astable…

Q: 2. A series RL circuit has voltage and current equations of e = 141.42 sin 2n30t + 141.42 sin 2n90t…

A: For series RL ckt..impedance Z=R+jXL .. Where R is resistance and XL is inductive reactance..

Q: The 60 Hz AC source and 240 V rms voltage provides a power of 5000 VA

Q: For the following voltage and current phasors in rms Voltage magnitude in (V) is 136 and phase angle…

A: According to question:

Q: Ohmic components have a V-I curve O Non-linear VI curve. O Parabolic VI curve. O Sinusoidal VI…

A: Ohmic components obey Ohm's law. As per Ohm's law, the current flowing through a ohmic component is…

Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…

A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz

Q: The source in the circuit shown is a sinusoidal source. The supply voltages across various elements…

A: Given a series RLC circuit, Voltages across each elements are as, Resistance voltage, VR=3 V…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in series with a function…

Q: 15. You are working on a power factor correction installation, and you notice with a clip-on ammeter…

Q: R An RC parallel circuit. A 110-V, 60.0-Hz, AC line is connected in parallel to a resistor of 1000 Q…

A: Given detailsThe supply voltage is .The supply frequency is .The value of the resistance is .The…

Q: The rms value of the resultant current in a wire carries a dc current of 10 A and a sinusoidal…

A: Given- dc current- Id=10 A, ac current- Ia=20 A, To Find- The rms value of the resultant current…

Q: A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power…

A: The power factor for series RL circuit can be written as, p.f=cosθwhere…

Q: shown in the Vps low is Write the FORMULA for the total impedance of the circuit Zut= R²+ cL- Write…

Q: what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms

A: The solution can be achieved as follows.

Q: The below figure shows the waveform of the voltage and current in a purcly inductive AC circuit.…

A: Consider the given waveform.

Q: The below figure shows the waveform of the voltage and current in a purely inductive AC circuit.…

A: Correct option is LAGS BY 90° we can see that the initiation of current is very much slower than…

Q: QUESTION 4 A resistor, a capacitor, and an inductor are connected in series with a function…

Q: 1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the…

Q: Prob I and Vc For the following RMS phasor circuit, a coworker has determined values for 50 Ohms 50…

A: In this question, Find the value of current in the resistance R2 and active and reactive power in…

Q: The phasor of the impedance of an AC circuit has no vertical component. What does this mean? there…

A: Consider in case of a pure inductive circuit the current lags the voltage by an angle of 90 degree.…

Q: Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at…

A: In this question, We need to choose the correct options If power P= 425W And power factor = 0.47…

Question

In the circuit given below, V=4 kV, X=2 , R=1 , and f=50 Hz. Determine
e(t) V2V cos(wt + a)
+
R
Figure 1: Problem 1
swr=0
Find the rms symmetrical facult current

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data :

VIEW

Step 2: Calculation :

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
Previous solution was incorrect...
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
Determine the rms current in the figure for Vrms = 16 V and C = 74µF V f=10 kHz
Please answer the questions on the figure!
C. Draw a general sine wave V vs t and I vs t plot for a purely resistive and a purely inductive circuit and show leading lagging parameters and clearly mark the phase difference.
....please solve this urgent for me..
The output voltage waveform of a four quadrant chopper is shown in figure. In the waveform, Vdc is input voltage, D is duty cycle ratio and T is cycle time. DT T. The RMS value of ripple component in output voltage is (A) Vác 2V VD-D (В) V(2D-1) (C) de de (D) V de VD- D? yd
6 to 8
Please disregard the question on the picture. Here's the right question, at what frequency will the value of the impedance be twice that at 25Hz (refer to the given in question #20).
The rms value of the resultant current in a wire carries a dc current of 10 A and a sinusoidal alternating current of peak of value 20 A is-