Question: If simplified, the next figure shall be: - (a) A and the series of three resistors. - (b) A and the parallel of three resistors

Q: a) The approximate approach. b) The exact approach.

A:

Q: At a temperature of 25°C (common temperature for components in an enclosed operating system),…

A: This problem belong to analog electronics . It is about calculation of thermal voltage at a…

Q: Determine the DC currents (1s. Ic and le) and dc junction voltages (VBE, VCE and Vca) In-Blank 1 mA,…

A: Given,  VBB = 3 VRB = 5 kΩRC = 232 ΩVcc = 18 VβDC = 65

Q: Nichrome ribbon resistor elements each has a resistance of 1 ohm. The element is made from sheet of…

A:

Q: What is the advantage of the Alkaline Cell as compared with the Carbon-Zinc Cell

A: A carbon zinc battery is composed of carbon rod and zinc case. There is presence of cadmium and…

Q: Shown below is a DC circuit that contains a number of switches. The resistance of each switch is…

A: We have to rank as per ammeter reading from highest to lowest.     Let we consider,  R= 1 ohm and…

Q: Which or which of the following is correct? I) Pp= resistivity of the p-type layer II) Pc= the…

A: which of the following is correct? i)ρP = resistivity of the P type layer ii) ρC  =  p type specific…

Q: A large proportion of the failures of modern electronic systems are of a(n) __________ nature.

A: ELECTRONIC SYSTEM Electronic systems have both inputs and outputs, with the outputs created by…

Q: . Which of the following lead-acid battery voltages has the highest value? A. Equalize voltage B.…

A: The correct Answer is  Option:A Equalize voltage.

Q: 2. Determine the nominal resistance values of these resistors, given their band colors, and also…

A: Carbon resitance or color code resistancs is calculated  as given below  by using table

Q: what can be observed in series wherein resistors with the same ohmic value

A:

Q: 1, between points (a and b) en's equivalent voltage and seguivalent resistance are

A:

Q: 1- For each type of connection, determine the voltage ratios: Viph aphv=vzph and a Lv= VII

A:

Q: For the plate shown in figure below find (a) ∑ A *

A:

Q: What is the Voltage between Outer Wires of the Three wire D.C distribution system. O a. three times…

A:

Q: In an outdoor substation the three bus-bar conductors are supported by units of post type…

A:

Q: Identify the elements considered for the Voltage Drop calculations in D.C distribution system. O a.…

A: Inductive reactance (XL) = 2πfL  Shunt admittance (Yc)= 2πfC In dc distribution, the frequency of…

Q: VI characteristics of solar PV

A:

Q: Discuss causes of insulation failures in high voltage engineering. High voltage engineering

A: according to the question we have to discuss about the cause of insulation failures in high voltage…

Q: In a PWM, what should be the duty cycle to get a voltage output of 4.5 V?

A: Consider the formula for the duty cycle. Duty2565 V=Vout

Q: When resistors with higher wattage ratings are require resistors are generally used to dissipate the…

A:

Q: 4.a. Find the value of Rv (in ohms) needed for a full-scale reading of 50 V. 4.b. Find the value of…

A: The solution can be achieved as follows.

Q: most of the circuits, determine all the voltages and currents necessary this usually involves: (Eth,…

A:

Q: Name four types of dependent sources and give the units for the gain parameter for each type.

A: Four dependent source are given by, Voltage controlled voltage source : In this dependent source is…

Q: 3. In the modified figure in this week’s slides, what is annual baseload in MWh?

A:

Q: On figure 1 below is load distribution on a two wire d.c. distributor fed from one end from a 400V…

A:

Q: For most of the circuits, determine all the voltages and currents necessary this usually involves:…

A:

Q: and the negative terminal at point B, compute the following a. The current in the 4-ohm resistor, I.…

A:

Q: Identify the type of bonding in the figure shown. a. Voltage Bonding b. Main Equipotential Bonding…

A: Bonding :  Bonding is the joining of two conductor to form Equipotential between them is called…

Q: A. Answer the following show your solution A certain battery has a 12.0-V emf and an internal…

A: A. Given emf = 12 V  Internal resistance Rin = 0.1 ohm  Load resistance RL = 0.5 ohm  a). Now find…

Q: Find the current in the 17 ohms resistor by using Wye/delta conversion. Provide a clear solution.

A:

Q: 2. Repeat problem #1 for ß = 140 using the exact approach. What levels are affected the most and…

A:

Q: Explain the characteristics of LDR? What is the use of Multimeter in the experiment?

A:

Q: Identify the elements considered for the Voltage Drop calculations in D.C distribution system. О а.…

A: For DC distribution, voltage drop across the element?

Q: n an outdoor substation the three bus-bar conductors are supported by units of post type insulators.…

A:

Q: 3] Find the resistivity -3 cm of arsenic ator at ic onize and the m

A:

Q: Q3) The self capacitance of each unit in a string of four suspension insulators is C. The shunting…

A:

Q: lain the operation of a full subtractor with necessary diagrams. What is the difference between half…

A: Full Subtractor : It is is a combinational circuit that perform subtractor it consist three bits. It…

Q: 3. Calculate the current through the Zener diode for the given values of load resistance in this…

A:

Q: Use the concept of equivalent resistance to determine the unknown resistance of the identified…

A: In this we will find equivalent resistance. ..

Q: 1)Compare the biot savart law with the ampere law. I need to explain the answer to this question,…

A: Biot savart law:   Biot savart law states that  The magneticc field produced by a constant electric…

Q: nichrome ribbon resistor elements each has a resistance of 1 ohm. the element is made from sheet of…

A: Given that  Resistance of nichrome ribbon resistor elements  is 1 ohm Thickness of nichrome…

Q: Explain V-I and PV characteristics of solar cell or PV systems

A: Solar cell converts light energy into electrical energy.

Q: In a 36KV overhead line, there are 3 units in the string of insulators. If the capacitance between…

A: Here, Value of K = 55% = 0.55 Line voltage = 33 kV

Q: 3.- For the following circuit, determine the following: (a) Currents in each branch. b) Potential…

A: solution (c) Electric potentials in each junction with respect to ground

Q: 1) The term Bi is defined as Select one: O a. Negative change in reference bus power to the power…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: resistance, connected in 2- A combination of two similar metals are called... 1- Ammeter has with…

A: Given : For a given electrical circuit the electrical measurements are current and voltages.   We…

Q: For the circuit shown in figure 4 Calculate the value of ITotal & IC1

A: In this question,  We need determine the total current  and current in the capacitor C1.  We are…

Q: Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the…

A: Given: C1=6 μFC2=10 μFC3=15 μFV=200 V