[Problem MS-P] An experimental setup in the laboratory is shown (All dimensions are in mm). Two 50 x 50 mm soil samples A and B are placed under constant head. The permeability of sample A is half that of sample B. If 300 ml of water flows through the sample in 5.5 minutes, determine the equivalent hydraulic conductivity (in cm/s). A 6.11 x 10-2 B) 3.67 (D) 6.11 x 3.67 x 10-4 10-2 Water 412 140 A 70 B Datum 287

[Problem MS-P] An experimental setup in the laboratory is shown (All dimensions are in mm). Two 50 x 50 mm soil samples A and B are placed under constant head. The permeability of sample A is half that of sample B. If 300 ml of water flows through the sample in 5.5 minutes, determine the equivalent hydraulic conductivity (in cm/s). A 6.11 x 10-2 B) 3.67 (D) 6.11 x 3.67 x 10-4 10-2 Water 412 140 A 70 B Datum 287

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Hydraulic Conductivity

Section: Chapter Questions

Problem 6.7P

See similar textbooks

Similar questions

A constant head test is performed using a permeameter in the laboratory. The graduated cylinder collects 892 cm3 of water in 112 seconds. The soil specimen diameter = 18 cm , th elevation of water in upper-most piezometer is 181 com , the elevation of water in lowest piezometer is 116.6 cm and the piezometer inlets are evenly spaced at 16.7 cm on center. Compute the hydraulic conductivity, k and choose the correct answer below based on that. O A. 2.1 x 10^-3 cm/second O B. 1.5 x 10^-2 cm/second O C. 2.91 x 10^-2 cm/second O D. 2 x 10^-2 cm/second QUESTION 10 Given: -Applied stress on a soil = 122 kPa %3D -Influence Factor = 0.4 Compute the change in stress at 10 m below the edge of 25 m dimeter oil tank and select the correct answer from below: O A. Change in stress = 44 kPa O B. Change in stress = 49 kPa O C. Change in stress = 40 kPa O D. Change in stress = 42 kPa %3D
Length of soil sample for constant head permeability test is 30 cm, Area of specimen is 177cm, constant head difference is 50 cm, total volume of water collected in 5 min is 350cm'. Calculate the hydraulic conductivity of the soil. A) 2.85x10'cm/sec D) 1.09x10 cm/sec 8) 1.09x10 cm/sec 9 3.95x10 cm/sec Answer A Submit
Question 2 * The permeameter in a permeability test setup involves a soil sample 200 mm diameter and a length of 30 mm. The height of water is kept constant at 400 mm. In a duration of 4 min, water was collected in the graduated flask having a volume of 420 cu. cm. Determine the following. Flow Rate o Hydraulic gradient o Hydraulic conductivity
← Darcy' Law A sand sample of 35 m² cross sectional area and 20 cm long was tested in a constant head permeameter. Under a head of 60 km, the discharge was 120 ml in 6 min. The dry unit weight of sand used for the test was 1120 g. and GS = 2.68 Take Sw = 1 g/ cm³ The hydraulic conductivity (in cm/sec) is × 10-³ X
A constant head permeability test was carried out on a sample of sand. The diameter and the length of the sample were 10 and 20 cm. respectively. The head of water was maintained at 35 cm. If 110 cm3 of water is collected in 80 seconds, compute the hydraulic conductivity of the sand.
A sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-head apparatus. The total head was kept constant at 30 cm and the amount of water collected in 5 seconds was 40 cm^3. The test temperature was 20 deg C. Calculate the hydraulic conductivity. Provide a diagram a.5.0 x 10^-2 b.3.47 x 10^-2 c.2.0 x 10^-1 d.6.7 x 10^-1
A sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-head apparatus. The total head was kept constant at 30 cm and the amount of water collected in 5 seconds was 40 cm^3. The test temperature was 20 deg C. Calculate the hydraulic conductivity. a. 6.7 x 10^-1 b. 3.47 x 10^-2 c. 5.0 x 10^-2 d. 2.0 x 10^-1
For setup shown in the figure, the cross-sectional 70 mm area of the soil is 2200 mm2, knowing that in 240 seconds 40 mm 0.8 Liter of water flows through the samples. 25 mm Determine: 1- Elevation, pressure and total heads in points A, B, C and D. 2- Estimate the coefficient of permeability for each sample. 90 mm 30 mm 100 mm Sample I Sample 2
PART IV: PERMEABILIT Y PROBLEM A For a constant head laboratory test on a fine sand, the following are the given values : • Length of the specimen • Di ameter of the specimen 14.0 inches 3.25 inches He ad difference 25.0 inches Water collected in 2.50 mins Void ratio A. Compute for the hydraulic conductivity of the soil in in/sec. B. Determine the discharge velocity through the soil in in/sec. c. Determine the seepage velocity in in/sec. 0.065 cubic inches 0.45
A constant-head permeability test is performed in a laboratory where the soil sample is 25 cm in length and 6 cm2 in cross section. The height of water is maintained at 2 ft at the inflow end and 6 in. at the outlet end. The quantity of water flowing through the sample is 200 ml in 2 minutes. (a) Make a sketch of the described conditions. (b) What is the coefficient of permeability in millimeters per minute?
ll Ooredoo ? 2:38 PM O 100% Annotation 20... 山 A soil sample was collected near the Quriyat dam got the following properties: Coefficient of permeability k = 2.5x 105 m/sec, cross-sectional area = 45 cm?. A quantity of water 650 mL passed down for 15 minutes under an effective constant head of 450 mm. On oven drying, the test specimen has a mass of 500 g. Take Gs = 2.65, calculate a. Length of the soil sample in mm. b. Seepage velocity. Paragraph I Not allowed to type here
8. A soil sample in a constant-head apparatus is 6 in diameter and 12 in long. The vertical distance from headwater to tailwater is 24 in. In a test run, 5 ft3 of water passe through the sample in 60 sec. Determine the coefficient of hydraulic conductivity.