A sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-head apparatus. The total head was kept constant at 30 cm and the amount of water collected in 5 seconds was 40 cm^3. The test temperature was 20 deg C. Calculate the hydraulic conductivity. Provide a diagram a.5.0 x 10^-2 b.3.47 x 10^-2 c.2.0 x 10^-1 d.6.7 x 10^-1

A sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-head apparatus. The total head was kept constant at 30 cm and the amount of water collected in 5 seconds was 40 cm^3. The test temperature was 20 deg C. Calculate the hydraulic conductivity. Provide a diagram a.5.0 x 10^-2 b.3.47 x 10^-2 c.2.0 x 10^-1 d.6.7 x 10^-1

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.17P

See similar textbooks

Similar questions

Refer to the constant-head arrangement shown in the figure. L Graduated flask Porous stone Soil specimen For a test, the following are given: •L=18 in. • A = Area of the specimen = 3.5 in.2 • Constant-head difference = h = 28 in. • Water collected in 3 min =21.58 in.3
A constant head test is performed using a permeameter in the laboratory. The graduated cylinder collects 892 cm3 of water in 112 seconds. The soil specimen diameter = 18 cm , th elevation of water in upper-most piezometer is 181 com , the elevation of water in lowest piezometer is 116.6 cm and the piezometer inlets are evenly spaced at 16.7 cm on center. Compute the hydraulic conductivity, k and choose the correct answer below based on that. O A. 2.1 x 10^-3 cm/second O B. 1.5 x 10^-2 cm/second O C. 2.91 x 10^-2 cm/second O D. 2 x 10^-2 cm/second QUESTION 10 Given: -Applied stress on a soil = 122 kPa %3D -Influence Factor = 0.4 Compute the change in stress at 10 m below the edge of 25 m dimeter oil tank and select the correct answer from below: O A. Change in stress = 44 kPa O B. Change in stress = 49 kPa O C. Change in stress = 40 kPa O D. Change in stress = 42 kPa %3D
Refer to the constant-head arrangement shown in Fig 5. For a test, the followingare given:• L =18 in.• A = area of the specimen = 3.5 in.2• Constant-head difference = h = 28 in.• Water collected in 3 min = 21.58 in3Calculate the hydraulic conductivity (in./sec).
PROBLEM 1: A sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-head apparatus. The total head was kept constant at 30 cm and the amount of water collected in 5 seconds was 40 cm?. The test temperature was 20°C. the Calculate coefficient of permeability? a. 0.261 cm/s b. 0.960 cm/s c. 0.204 cm/s d. 0.178 cm/s
For a constant head laboratory permeability test on fine sand, the following values are given: Length of specimen, L = 16inches Diameter of specimen, D = 3inches Head difference, h = 23inches Water collected in 120 seconds = 0.057cu.in Void ratio, e = 0.38 a. Determine the hydraulic conductivity (in/min) of the soil. b. Determine the discharge velocity (in/min) through the soil. c. Determine the seepage velocity (in/min) Please answer this asap for upvote. Thank you in advance
In a constant-head permeability test. A test gives these values: •L= 25 cm •A = 160 area of the specimen cm2 • Constant-head difference, h =1m • Water collected in a period of 5min and 40sec= 1 Liters Calculate the hydraulic conductivity in cm/sec.
For a constant head laboratory permeability test on fine sand, the following values are given: Length of specimen, L = 15inches Diameter of specimen, D = 3inches Head difference, h = 22inches Water collected in 120 seconds = 0.057cu.in Void ratio, e = 0.37 a. Determine the hydraulic conductivity (in/min) of the soil. b. Determine the discharge velocity (in/min) through the soil. c. Determine the seepage velocity (in/min) {νs=νn}. Note: Your answer must contain 5 numbers after the decimal point. (Example: 0.00504, 0.00899, 0.02345, 0.00200) these values must be used to solve succeeding questions. Please answer this asap. For upvote. Thank you very much
2. Situation 2 - For a constant laboratory permeability test on a fine sand, the following data are given: Length of specimen = 16 cm Diameter of specimen = 96 mm Constant Head Difference = 50 cm Volume of water collected in 4 min = 420 cc Void ratio of the soil specimen = 0.55 a. Determine the hydraulic conductivity of the soil in m/min. Round off to four decimal places. b. Determine the discharge velocity in m/min. Round off to four decimal places. c. Determine the seepage velocity in m/min. Round off to four decimal places.
1. For a constant head laboratory permeability test on a fine sand, the following values are given: Length of specimen, L = 10 inches Diameter of specimen = 2.5 inches Head difference, h = 22 inches Water collected in 2 minutes = 0.044 in %3D Soil specimen The void ratio of the specimen is 0.34. Determine the conductivity, k, of the soil in in/min. b. Ps ne a. Determine the discharge velocity through the soil in in/min. Determine the seepage velocity in in/min. Measuring hurket C.
The results of a constant-head permeability test for a sand sample having a sectional area of 10000mm2 and a length of 200 mm are as follows: (1) Constant head difference 400mm (2) Time of collection of water = 30 seconds (3) Volume of water collected = 600 cm3. The hydraulic conductivity is: Oa. 1.0 mm/sec Ob. 1,7mm/sec c. 2.9 mm/sec O d. 0.5mm/sec
A constant-head test was conducted on a sample of soil 15 cm long and 60 cm^2 in cross-sectional area. The quantity of water collected was 50 cm^3 in 20 seconds under a head difference of 24 cm. Estimate the hydraulic conductivity in cm/s with a porosity of 35% from the result of test. a.2.6 x 10^-6 b.4.3 x 10^-3 c.7.0 x 10^-6 d.3.47 x 10^-2
For a falling head permeability test, these valueare given: Length of the soil specimen = 200 mm Area of the soil specimen = 1000 mm2 Area of the standpipe = 40 mm2 Head difference at time, t = 0 min is 500 mm Head difference at time, t = 3 min is 300 mm1. Determine the hydraulic conductivity of thesoil in cm/sec.2. What was the head difference at time, t =100 sec?