Instructions: fill out the table above with the information provided by the drawing on the right side of this sheet.

Q: A dam of 21.5 m height and has free board of 1.5 m. A flow net is constructed containing following…

A: A dam of 21.5 m height and has free board of 1.5 m.Number of potential drops = 12Number of flow…

Q: If the efficiency of particles of diameter 0.05 mm and specific gravity 2.65 is 88%, then find the…

A:

Q: A soil sample weighs 1270g. After oven drying, volume and weight of soil reduced by 10% % and 25%…

A:

Q: A water sample having a pH of 10 at 25°C contains the following ions: Na* = 56 mg/1 Mg²+ = 24 mg/1…

A:

Q: a. the design block shear strength of the connection b. the allowable block shear strength of the…

A: All data is given in the figurethe bolts are 3/4-inch in diameterNeed to finda. the design block…

Q: k. Pf The Maximum Moment is 12765.9 kft W= 200 #/FT. Draw the Shear and Moment Diagram for the…

A:

Q: a. Compute the internal forces in bars BC and CD. Indicate if they are in compression or tension.…

A: A truss member is given belowNeed to find a. compute the internal forces in bars BC and CD. Indicate…

Q: The table below gives information on the accumulated rainfall (in inches) and discharge (in cfs) for…

A: a) Cumulative ass curve for rainfall and the hydrograph.b) volume of infiltration loss.

Q: A metal bar AB of length L is held between rigid supports and is heated non-uniformly in such a…

A: For a  metal bar AB held between rigid supports and is heated non-uniformlyLength= LChange in…

Q: Determine the potential evapotranspiration from an area month of June using Penman's formula. The…

A: T

Q: Water flows through an expansion pipe as illustrated in Figure 1. Q ((A) S 2 m v(s) (B) Figure 1:…

A: The velocity along a streamline s is given by  V = 2t ( 3-s ) m s-1              Where t= seconds…

Q: Two pieces of wood, 60 mm by 120 mm each are glued together along the 40° joint. The permissible…

A:

Q: A sample of dry cohesionless soil was tested in a triaxial machine. The angle of shearing resistance…

A: For a sample of dry, cohesionless soil was tested in a triaxial machine1. Angle of shearing…

Q: A railway line is laid so that there is no stress in the rails at 8°C. The rails are 30 m long. Take…

A:

Q: Please complete Problem 9.10 Compute the vertical normal stress, oz, at points A, B, and C in Figure…

A:

Q: Why do we use Heavy Timber (HT) for construction? What would be the benefits of using HT? What are…

A:

Q: Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to…

A:

Q: A 1m diameter commercial steel pipe that is 2km in length carries water (20°C) from reservoir A to…

A: Length of the pipe, L = 2 km = 2000 m,Diameter of the pipe, d = 1 m,Difference in elevation between…

Q: 1 5. Urban Design In Washington, D.C., 17th, 18th, 19th, and 20th Streets are parallel streets that…

A:

Q: Route the following upstream inflow hydrograph through a downstream flood control channel using the…

A:

Q: No. 2 P 30° 15° 40° 20⁰ Find the magnitude and direction of the resultant of the two forces shown…

A:

Q: 2.21 Following are the results of two consolidated-drained triaxial tests on a clay: Test I: 82.8…

A:

Q: 7-2. Estimate the maximum amount (by weight) of material that could be separated for recycling from…

A: physical composition of residential MSW excluding recycled matarials and food wastes discharaed with…

Q: TI The piece of plastic is originally rectangular. Calculate the shear strain Yxy at corners A and B…

A: For small angles.

Q: H D N G O P -ye- E Ze Xe LL F B y A X For the diagram above, given that coordinates G=(0, 0, 0.04),…

A:

Q: Equilibrium discharge obtained from a 4 hr S-hydrograph is 250 m3/s for a catchment. The area of…

A:

Q: Consider the beam shown in (Figure 1). The members are pin connected at E and F. Suppose that P =…

A: Using static equilibrium conditions, summation of moment at F = 0, ( Because, there are only…

Q: A pretensioned beam is to carry a superimposed dead load of 600 plf and live load of 1,200 plf on a…

A:

Q: The velocity potential function for a source varies as A 1 B C D log

A: To check velocity potential function for a source varies as

Q: How can a balance be struck between meeting mandatory life safety requirements, managing…

A: Achieving a balance between meeting mandatory life safety requirements, managing construction costs,…

Q: For a catchment of area 4400 ha, the maximum flood flow will be. Dicken's formula and take CD= 6).…

A: For a catchment area,Catchment area,A=4400 hectare (ha)Dicken's coeffiient,To find maximum flood…

Q: Determine the Cb for beam: Solve for Reaction forces, Mmax (moment and shear diagram), and then Cb.…

A: A simply supported beam is given we need to find out the reactions and shear force and bending…

Q: In fact, AASHTO assumes constant accelerati procedures. Although this is not entirely true, dis can…

A:

Q: A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between…

A: Given:- Reading of manometer=X=0.5 m Specific gravity of flowing fluid=S= 0.8 Specific gravity of…

Q: The block is analysed in Cartesian system. The value of P is such that normal strain = 0. Modulus of…

A: The block is analysed in Cartesian systemThe value of P is such that normal strain

Q: Determine the mean barometric reading in mmHg.

A: The objective of the problem is to determine the mean barometric reading. The goal is to find the…

Q: If one proportioned a concrete mix and determined that 10.50 ft^3/yd^3 of coarse aggregate was…

A: Volume of coarse aggregate = 10.50 ft^3/yd^3Oven dry specific gravity = 2.70We have to…

Q: The actual velocity in the contracted section of a jet of liquid issuing from a 5 cm diameter…

A: 1. Diameter of the orifice = 5 cm2. Actual velocity in the contracted section = 7.5 m/s3. Head…

Q: A 250 ml sample of water has an initial pH of 10. A 50 ml of 0.02N H₂SO4 is required to titrate the…

A:

Q: A soil sample is having liquid limit of 60% and plastic limit of 25%. This soil can be classified as…

A: liquid limit of 60% plastic limit of 25%This soil can be classified as

Q: Disinfection of 20 MLD water is done with 30 kg chlorine to achieve 99% efficiency in a contact time…

A:

Q: A reservoir is located at the outlet of a 150 sq. mile watershed. Water budget data are: Mean annual…

A:

Q: A metal bar AB of length L is held between rigid supports and is heated non-uniformly in such a…

A: For a  metal bar AB held between rigid supports and is heated non-uniformlyLength= LChange in…

Q: (a) determine the average shear stress and shear strain in each of rubber blocks (b) determine the…

A:

Q: A simple of dry sand is subjected to a triaxial test. During the test if deviator stress and cell…

A:

Q: The amount of chlorine residual remaining when gases start evolving during disinfection and when…

A: The amount of chlorine residual remaining when gases start evolving during disinfectionand when they…

Q: 2. A strip footing will be used to support a load-bearing wall with a load (P/b) of 3500 lbs/ft. The…

A: P/b = 3500 lb/ft = 145 pcf = 120 pcf D = 2.5 ft Qg = 2000 psf

Q: Speeds of 20 vehicles were observed as follows (in mph): 35.1 44.0 45.8 44.3 36.3 54.0 42.1 50.1…

A:

Q: Based on the expression dp/dz = -pg, at what elevation is the absolute pressure 70% of the pressure…

A:

Q: find a and B B.

A: A figure is given belowneed to find

Budget Estimating

The term budget signifies a plan over the long run, generally, a year that covers the financial expenses and revenues of any organization. This budget plan is known to estimate the growth and success of any organization. Civil engineering companies utilize project budgets for estimating project costs, construction costs, and other direct and indirect costs related to the project being undertaken. Project budget is a detailed statistical tool primarily used by project managers to estimate the overall project cost. The project budget is in the form of a document that includes all the costs which are incurred during the project undertaking and after the completion of the project. Large commercial projects have the project budget estimate in the form of large detailed pieces of documents which include every cost estimate regarding man and materials. Labor costs, material procurement costs, construction costs, and operational costs are some of the costs that are incurred during the project execution and planning phase.