Determine the mean barometric reading in mmHg. Final depth = initial depth + effective rainfall -water removed - pan evaporation190mm = 200mm + 50mm -10mm - panevaporationLake evaporation= pan coefficient x panevaporation=0.7x50= 35mm

The objective of the problem is to determine the mean barometric reading. The goal is to find the…

Answered: Determine the mean barometric reading…

Engineering

Civil Engineering

Determine the mean barometric reading in mmHg.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: e amount of water evaporated from a water surface is estimated by the following except for A)…

A: Option (D) is correct option

Q: Water flow rate to Baze University Hospital complex is to be measured by using a Venturi meter with…

A: The given data is shown below: Manometric height=30 cmWater density=1000 kg/m3Mercury density=13600…

Q: = If you are given two sound intensities, 65 db and 68 db, what will be the sound intensity level…

Q: A pitot tube having a coefficient of 0.98 is used to measure the air speeds. With water in the…

Q: I need the rainfall intensity Vs Duration curve using excel

A: The objective of the question is to plot the rainfall intensity versus duration curve using the…

Q: As the engineer on the job, you are tasked to determine the pressure drop across an orifice (an…

A: Density of water = 1000kg/m3 h1 - h2 = 200mm = 0.2m

Q: What are the possible Conclusions and Recommendations in the picture attached? Obsornes Reynolds…

A: The Obsornes Reynolds Demonstration, as described by the provided data, represents an experimental…

Q: Q2: The table below represents the vertical coordinates of the hydrograph of a rainstorm over a…

A: Given data:- Mountain area, A=770 km2 Below table is given; 72 66 60 54 48 42 36 30 24 18 12 6 0…

Q: A 30-meter steel tape is 3 mm too long at 25°C with a pull of 60 N. A rectangle is measured with…

A: Given data:- The given 30 m steel tape. The given measured distance, L=145.49 m B=131.05 m The…

Q: A surveyor plans to measure an unknown distance on a flat ground surface. O to P was determined to…

Q: 3. A barometer at the top of the mountain 1300 ft. above sea level reads 780 mm of mercury. What is…

Q: ater (p = 1000 kg/m3) flows through %3D nturimeter with inlet diameter 80 mm a roat diameter 40 mm.…

A: Inlet Diameter = 80mm Area of Inlet Diameter = 0.785 x (80)2 = 5025.6 mm2 = 0.0050256m2 Throat…

Q: For an atmospheric pressure of 101 kPa (abs) determine the heights of the fluid columns in…

Q: A storm happened in Mosul city on 1st April 2021. Plot the Hyetograph and mass curve.

A: Intensity(i) of rainfall is defined as the depth of rainfall per unit of time. The mass curve of…

Q: Q) Meteorological measurements on a cloudy day give the following data: Height above ground, Z (m)…

A: Given data, Height above ground, Z (m) Wind speed, U (m/s) z1 = 1.01 u1 = 7.470 z2 = 10 u2 =…

Q: Gasoline (r.d%=0.68) is flowing. Calculate gage readings and flowrate. 0.6m D=300mm 3m 0.9m D=150mm

Q: Given an air with a known temperature and pressure of 4 degree Celsius and 105 KPa, respectively,…

Q: A line was measured using a tape that is suspended with a pull of 145 N on both ends. The mean…

A: Correction due to pull is given as Cp = (Pm - Po)L/(AE)

Q: Table below shows annual and monthly precipitation for rain gauge stations A, B and C. For station X…

Q: DATA SHEET Pipe Section Material Pipe Pressure at Length Dia. Reynolds Roughness Flow Velocity…

A: Calculating pressure; Pressure 'P'=ρgh=32.2×62.35×1bFx3×150 ft=301166.014×1bfft2=20.9143…

Q: A Venturi meter, 12 in. by six in., is installed in a vertical pipeline carrying water. A…

A: The system given is :

Q: A line was measured using a tape that is suspended with a pull of 145 N on both ends. The mean…

A: Given data: Total length of the line measured=119.631 m Coefficient of linear expansion=0.9 x10-6…

Q: The atmospheric pressure in kPa if a mercury barometer reads 700 mm. A B C D skippe 98.1 kPa 68.7…

A: Barometer reading h=700 mm It is needed to find the atmospheric pressure in kPa.

Q: The EGL and HGL of a system are shown below. Assume that the fluid is water and a = 1 in all…

Q: Find the discharge of water through a venturimeter with inlet and throat diameters 300mm x 150mm…

Q: determine the moment of inertia about the y axes for the shaded area. submit your solution via email…

A: assumed b,side of rectangle=40mm,d, depth of rectangle=60 mm D=diameter of quarter circle=2*20=40…

Q: A.Calculate the average rainfall (mm) over the area given in the figure using Theisen Method.( the…

A: Given values: Cell size = 500 m * 500 m Consider the given area and value of precipitation in each…

Q: Final answer also given. Please show all steps clearly

A: 25 December - CardiffDecember 25 is 359th day of the year. ....(Considering non-leap…

Q: Water can jump from a depth of 30 cm to 75 cm in a rectangular flume. The flume is 2.75 m wide. What…

A: Depth before jump (y1)=30cm Depth after jump(y2)=75cm

Q: List various forms of precipitation

A: ASKED: We are asked to list the various forms of precipitation. Precipitation refers to the…

Q: The optimal number of non-recording rain gauge is The optimal number of recording rain gauge is

A: Data is as shown

Q: Hour 2 3 4 7 8. Rainfall Height (mm) 6 10 15 18 24.5 26.5 28 29 5.

Q: A concrete dam cross-section is given in the Figure. Check the stability of the dam

Q: The height of Mount Mayon is 2463m. If the pressure at the base of the volcano is 753.02mmHg and the…

Q: Define Manometric efficiency

Q: 17. For the following data on speed and density, determine the parameters of the Greenshields'…

A: Detailed solution of the problem is attached belowExplanation:Step 1: Step 2:

Q: e Since Start of Rainfall (min) 60 120 180 240 300 360 420 Cumulative Rainfall (mm) 3 8 18 35 47 52

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

Determine the mean barometric reading in mmHg.

Final depth = initial depth + effective rainfall -
water removed - pan evaporation
190mm = 200mm + 50mm -10mm - pan
evaporation
Lake evaporation= pan coefficient x pan
evaporation
=0.7x50
= 35mm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Know the objective of the problem.

VIEW

Step 2: Determine the mean barometric reading.

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 9 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The yearly precipitation in California has normal distribution. Calculate the value of the 50 year annual precipitation with the following details: Mean = 127 cm Standard deviation = 19 cm 198 cm 174 cm 189 cm O 166 cm
Neglecting air resistance, determine to what height in meter a vertical jet of water could rise if projected with a velocity of 57 m/s?
Given the following data using Thornthwaite method: Month Temp (°C) Jan Feb Mar Apr May Jun Jul Aug S 19 24 15 28 25 24 15 18 2 %Sunshine 61 62 76 70 69 55 73 56 7 Estimate the potential evapo-transpiration for the month of July in mm/month.
Q2: The table below represents the vertical coordinates of the hydrograph of a rainstorm over a mountainous area of 770 km2 as a result of a 6 hour rainstorm. Derive the vertical coordinates of a 6 hour standard hydrograph and then determine: 1- The value of the vertical coordinate for 6 hours of a standard hydrograph at a time of 18 hours. 2-The value of the vertical coordinate of 6 hours standard hydrograph at the time of 36 hours 3-The value of the vertical coordinate of 6 hours of st and ard hydrograph at the time of 66 hours the time 72 66 60 54 48 42 36 30 24 18 12 60 (hour) discharge 42 50 70 100 145 205 270 350 400 360 215 65 40 (m3/s) flow 42 42 42 42 41 baseband 41 41 40 40 40 40 40 40 40 (m3/s)
Reynolds Number Observation The Discussion 1- Draw a chart with the volumetric flows on the x – axis and Reynolds numbers on the y – axis (if possible use excel). 2- How is it possible to change Reynolds number while keeping the flow rate constant? Discuss. 3- How is the parabolic velocity profile generated? Explain. 4 - What are the main differences between turbulent flow and laminar flow? 5- What are the main advantages and disadvantages of turbulent flow? 6- Increasing the flow velocity causes the flow to become more turbulent, why?
! Required information A manometer is used to measure the air pressure in a tank. The fluid used has a specific gravity of 1.40, and the differential height between the two arms of the manometer is 19.8 in. The local atmospheric pressure is 12.7 psia. The specific gravity of the fluid is given to be 1.40. The density of water at 32°F is 62.4 lbm/ft³. Determine the absolute pressure in the tank for the case of the manometer arm with the higher fluid level being attached to the tank. The absolute pressure in the tank is psia.
Calculate the values of AWD and ADT for summer and winter seasons only. Month 1 2 3 4 5 6 7 8 9 10 11 12 Weekdays in month (day) 22 20 22 22 21 22 23 21 22 22 21 22 Weekday vol. (veh)x10³ 170 171 185 180 172 168 160 150 175 178 182 176 Monthly vol. (veh)x10 200 210 215 205 195 193 180 175 189 198 205 200
10-A hydrograph resulting from two hour rain fall over an area of 370 km². Derive one hour unit hydrograph. 1 Time, hr Flow, m³/s 10 2 80 3 380 4 500 5 480 6 7 340 210 8 80 9 10