In a single-phase diode-bridge rectifier, the input current can be approximated by a triangular waveform every half cycle with a peak of 10A and based of 60 degrees. a) Calculate the RMS current though each diode. b) Calculate DC-side current (average current at the output). c) Draw the waveform of capacitor current. Label all the key points.

In a single-phase diode-bridge rectifier, the input current can be approximated by a triangular waveform every half cycle with a peak of 10A and based of 60 degrees. a) Calculate the RMS current though each diode. b) Calculate DC-side current (average current at the output). c) Draw the waveform of capacitor current. Label all the key points.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Similar questions

How is a solid-state diode tested? Explain.
Determine the value of RL that will establish maximum power conditions for the Zener diode.
A single phase – half wave controlled rectifier with freewheeling diode is supplying a load consisting series connected a resistor and an inductance from a 70.7V (RMS), 50HZ sinusoidal AC source. The firing delay of the thyristor is 90° and the load values are R=10Q, L=0.1 H. Define the load current expression and draw the load current by calculating for first two periods. And calculate the average values of the load voltage and current.
Negative Peak Clipper with bias circuit uses a germanium diode, with an input peak to peak voltage V=20 V and bias voltage V 2.7 v. a) What is the function of the circuit b) Draw the circuit diagram. c) Draw the input and output waveforms. Input Output
Sketch the I-V characteristic curve for a real diode and label the main parameters and regions.
3 Given the bridge-type full-wave rectifier circuit shown 220V 60Hz 220V:Es Es D1 D2 D3 D4 The load resistor is 220 and the transformer average current is 300mA. Determine: (a) Average value, RMS value, and frequency of load voltage VRL. (b) Average current and PIV of each diode. RL
A silicon diode is used in the positive clipper of the figure below. Explain and sketch the output wave shape if the input is a) A sine wave with a peak value of 5V. b) A square wave with a peak value of 5V.
Write down the types of biasing condition for a diode with figures.
Draw the changes in Vi and Id of the ideal diode half-wave rectifier circuit in the figure. The frequency of the sine signal here will be taken as 50Hz. (Changes in Vi and Id will be drawn!!!)
Discuss the biasing and saturation voltage of a diode. Suggest how one can unidirectional DC output. convert AC to the
Create a Half-Wave Rectifier circuit. Use a resistor of 1000 Ohms. Input Voltage should be 95VAC - 65Hz Plot both the Input voltage and output voltage. Determine the Voltage drop across the diode by subtracting the output voltage to the input voltage peaks. Create a Bridge-Type Full Wave Rectifier Circuit. Repeat the steps done on the Half-Wave Rectifier circuit.
The diode from the following characteristic curve in Figure 1 was changed to zenerdiode. Determine: the function of zener diode in reverse biased. Briefly explain the differencebetween conventional diode and zener diode.