Given that:R1=7688, R2=6232, R3=1272, Vs=7.5 V,The circuit shown below is at a steady state before the switch closes at time t=0, Find Vc(inf) for t>0R1 2VsVR22250 mFv(t)R32Select one:O a. none of the aboveO b. 6.228678O c. ZeroO d. 0.000494O e. 3.076619

Answered: Image /qna-images/answer/ae7918e9-8f8b-4331-96f9-9ab9af0fcc95.jpg

Given that: R1=7688, R2=6232, R3=1272, Vs=7.5 V, The circuit shown below is at a steady state before the switch closes at time t=0, Find Vc(inf) for t> R1 2 VsV R22 250 mF v(t) R32 Select one: O a. none of the above O b. 6.228678 O c. Zero O d. 0.000494 O e. 3.076619

Given that: R1=7688, R2=6232, R3=1272, Vs=7.5 V, The circuit shown below is at a steady state before the switch closes at time t=0, Find Vc(inf) for t> R1 2 VsV R22 250 mF v(t) R32 Select one: O a. none of the above O b. 6.228678 O c. Zero O d. 0.000494 O e. 3.076619

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: differential equations A circuit with a 10 ohm resistor and a 4.6 henry inductor is connected in…

Q: The circuit shown below is at dc steady state before the switch opens at t = 0. Find the voltage…

Q: + C1 Vc 1F 2 ohm R3 V1 10V 1 ohm L1 1 ohm 1H

Q: The switch S₁ remains open at all times and the switch S2 closes at t= 0. From the figure, determine…

Q: Refer to the following figure, if VCE(sat) = 0.1 V, IC(sat) is equal to - 10 v 4.7 kn VIN Poc- 200…

Q: $1 R1 R4 R5 V R2 R3 R6

Q: Problem 4 A voltage source of 90V is connected to a load through a switch. The load is a combination…

Q: For the following circuit, V₁=12V, V₂=5V, C=5mF, R₁=R₂=2 №2, and R3 = 4 Q. Calculate: a. Time…

A: Note :As per guidelines I am doing first 3 sub parts.

Q: E = 12 V C = 150 µF R = 50 R, = 150 R1 E Initially the capacitor is uncharged, and the switch has…

A: Given

Q: There is a load formed by the series connection of the resistor R0 and the inductance L0 between the…

Q: the final voltage V at the capacitor's terminals at the end of the transient. Report your result in…

Q: The switch in the circuit shown in figure beside has been in position "a" for a long time, and then…

A: In this question we need to find a voltage VC(t)

Q: The capacitance specified in the circuit below is limited to 1-10nF. find the capacitance and RL…

A: XL=ωLXL=2π×10×103×30×10-3XL=1884.95 ΩXC=1ωCXC=12π×10×103×4×10-9XC=1052π×4XC=3978.87 Ω

Q: For the circuit below with switch U1 closing at time t=0 and the initial current in inductor L1…

Q: After a long time of operation (steady-state) on the position 1, the switch is set to position 2 at…

A: Circuit diagram is given as,

Q: Q2/ For the network shown in figure (Q:), the switch has been open for a long time before closing at…

Q: Each of the two circuits in the figure below has a switch that affects their time constants. For…

Q: Q2. Find the steady-state current in the RLC-circuit, given R = 0.2 , L = 0.1 H, C = 2 F and E = 220…

A: In this question we need to find the steady state current of the given circuit

Q: + (d) Find an expression for the maximum current in the inductor over one cycle of the external AC…

A: Given that, Vac (t)= V0 Cos(Ωt+ϕ) R, L, C, Ω and ϕ are arbitrary positive constants. Here we have…

Q: series RL circuit consisting of a single resistor a single inductor is being supplied by a 20 volt…

A: In this question we will find inductance value in series RL circuit...

Q: The switch in the figure is closed on a at time t= 0. What is the ratio &/E (a) just after t = 0 and…

Q: Consider the circuit shown below left. ww 100 Ω 5 V SW1 500 mH ww 100 02 ww Rth Vth SW1 a ell 500 mH…

Q: (suteh) Consider the Circuit below: RI=200r R2 35mH 1000 For parts a-c assume the switch S is in…

A: Note: As per the guideline will be solving only first 3 subparts. Please repost for remaining. Time…

Q: For the circuit in Figure 3 the switch is in the left position for several minutes: (a) Find the…

A: When switch is in the left position for a long time, the capacitor will behave as open-circuit as…

Q: A voltage (t) = 100 cos(60t+20°) V is applied to a parallel combination of a 28-k resistor and a 44-…

Q: S E R₁ C₁ R3 R₂ C2- R4 R5

A: R1 = 2R, R2 = 2R, R3 = 3R, R4 = 2R, R5 = 3R, C1 = 6, C2 = 6 Vc1(0-) = Vc2(0+) = 0 V Circuit diagram

Q: An LC circuit like the one in the Figure contains an 25.1-mH inductor and a 224-µF capacitor that…

Q: my question is for the correct follow up answer and not explanation and NOT THE ORIGINAL ANSWER.…

Q: A 12 volt battery is connected to a series circuit in which the inductor is 1/4 Henry and the…

A: Resistor (R):The resistor in the series circuit introduces resistance to the flow of electric…

Q: The figure shows the voltage across L 100H, then the current through the inductor at t 1.5 s is (…

Q: An open circuit contains a switch S, capacitor C, voltage source AVS and three resistors R1, R2, and…

A: In the given question we need to calculate the rate of change of energy.

Q: 8) 9) For the circuit in Figure 2, there is no initial energy stored on the capacitor or inductor.…

Q: For the circuit below assume steady state conditions. The inductor and capacitor are considered…

Q: Calculate the time constant for the circuit. Then Derive the nature response of the voltage Vc…

A: The circuit is as shown below :

Q: Given the following image of a practical inductor, what is true? Practical HEFF inductor Rpc RAC L…

Q: 32 Ω 4 M μF 25 S μF 16 Ω A In the circuit above the switch S is initially open. The battery has been…

Q: Draw the circuit given in the figure in its simplest form, determine the variables that do not…

A: To solve the above problem, one should understand the basic Boolean expression identity: Some basic…

Q: A second order system has damping ratio 0.2. The nature of step response will be a. straight line b.…

A: Given data, A second order system with Damping ratio, ζ=0.2

Q: S1 R3 R4 4 12 V1 R5 C1 10V 1F

A: Solve the problem

Q: 1.Utilize an appropriate R-C circuit powered by a 120 V DC source. This RC circuit will be the…

A: Approach to solving: In this problem, the following are given:Vs = 120 V DCVon = 70 V --- turn on…

Q: V₁ 010-et 015.et R 100 ww + VR(t) Now, we can write the solution for I (t) for t>0. Further, can you…

A: In d.c. analysis, under steady state condition, the current through an inductor will not change…

Q: The switch in the circuit in Figure-Q4 is moved from position A to B at t=0. Find (a)capacitor…

Q: A circuit with a battery, 2 resistors, a capacitor, and a switch is built as shown in the figure.…

Q: Find the mathematical expression for the voltage across the capacitor from the previous figure, if…

A: a) Switch is set at position 1 at t=0sec. This forms a simple series RC circuitR=100KΩC=0.05pFTime…

Q: Q1/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

A: For the network, the switch at position a. For. Long time. At time t= 0, the switch moves position…

Concept explainers

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).

Question

Given that:
R1=7688, R2=6232, R3=1272, Vs=7.5 V,
The circuit shown below is at a steady state before the switch closes at time t=0, Find Vc(inf) for t>0
R1 2
VsV
R22
250 mF
v(t)
R32
Select one:
O a. none of the above
O b. 6.228678
O c. Zero
O d. 0.000494
O e. 3.076619

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The Capacitor value is 0.08 F.
The switch S is closed at t = 0. Which statements about the following RL circuit are true? (Assume a DC source and that the inductors have no resistance.) Circle all answers that apply. L L R (A) Immediately after the switch is closed, the source sees an equivalent resistance of R/2. (B) Immediately after the switch is closed, the source sees an equivalent resistance of 2R. (C) Immediately after the switch is closed, the source sees an equivalent resistance of 3R/2. (D) At t = infinity after the switch is closed, the source sees an equivalent resistance of R. (E) At t = infinity after the switch is closed, the source sees an equivalent resistance of 2R. (F) At t = infinity after the switch is closed, the source sees an equivalent resistance of 3R/2.
Lecture Review Assignment Draw a circuit with only one resistor and capacitor that is equivalent to this circuit. What is the time constant of this RC circuit? R₁ www After a long time of charging, what is the charge on the capacitor 1 and current in resistor 1? V S C3 V = 6.0V R₁ = 250 25Ω R₂ = 330 33N R₂ C₁ C₂ C₁ C₁ = 12µF C₂ = 23µF C3 C3 = 46µF
The circuit contains two capacitors in series and two resistors in parallel with each other connected to an ideal source with e = 50V. Initially, the capacitors are empty, then at t = 0 the switch is closed. Given R1 = 7.02, R2 = 82, C = 6.0F, and C2 = 8F а. what is the voltage, as a function of time, across C1 and C2? b. What is the current, as a function of time, through R1 and R2? Ce R2
A circuit containing a 10 Ohms resistance is in series to 250 microFarad capacitance with a source of 40Volts. The switch is turned on at t = 0. What is the time will reach the the steady state value?
Q2/ For the network shown in figure (Q2), the switch has been open for a long time before closing at t=0. Determine an expression for the inductor (L=20mH) current İL(t) for t20. 300 L 36V iL (2othH 5oonF 12 ISA losr
The capacitor in the circuit is initially uncharged and the switch S is suddenly closed at t=0. Find the current on resistor R, at to Take R-3R/2 and R₂-4R. A) MER B) -15 28 O 815 D) -15 35 R₁ R₂
1, Q.35: For the circuit shown in figure beside, the switch has been in position "a" for a long time. At t=0 the switch moved to position "b". Find the capacitor current as a function of time. 502 1002 502 50V 502 1002 2LF: 100V ww- HH ww
Please show me how to approach this problems with clear step be step work to solve the following
b) What is the current at t = 0.008 s? (In [A]) c) What is the voltage at t = 0.008 s? (in [V]) Hint: What relationships exist between voltage and current when the current in an inductor is interrupted?
Q2) Find k and for the system shown in Figure 2 by using = 0.5 and steady-state error (ess) 0.1 for a unit ramp input. R(s) Figure 2 k s(s+B) C(s)
Please show working out and answer for the below question. You are investigating the electrical testing circuits and find that, in an inductive circuit, the relationship between instantaneous current i (amps) and the time t (secs) is given by: i = 12.5(1-e-t/CR) Determine the time taken for current to rise from 0 to 1.9 amps with resistor value of 220 and capactor value of 0.000008