For help with math skills, you may want to review:The Vector Cross Product 1The Vector Cross Product 2Part AWhat is the strength of the magnetic field at point P in (Figure 1)? Assume that I = 6.0 A, r₁ = 0.70 cm, andT2 = 1.4 cm.Express your answer with the appropriate units.FigureP1 of 1ΜΑB = ValueUnitsSubmitPrevious Answers Request Answer?× Incorrect; Try Again; 2 attempts remaining

Given data:Find:the strength of the magnetic field at point P

For help with math skills, you may want to review: The Vector Cross Product 1 The Vector Cross Product 2 What is the strength of the magnetic field at point P in (Figure 1)? Assume that I = 6.0 A, 7₁ = 0.70 cm, and T2 = 1.4 cm. Express your answer with the appropriate units. Figure 1 of 1 HA B = Value Units Submit Previous Answers Request Answer ? × Incorrect; Try Again; 2 attempts remaining

For help with math skills, you may want to review: The Vector Cross Product 1 The Vector Cross Product 2 What is the strength of the magnetic field at point P in (Figure 1)? Assume that I = 6.0 A, 7₁ = 0.70 cm, and T2 = 1.4 cm. Express your answer with the appropriate units. Figure 1 of 1 HA B = Value Units Submit Previous Answers Request Answer ? × Incorrect; Try Again; 2 attempts remaining

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter24: Magnetic Fields

Section: Chapter Questions

Problem 103A

See similar textbooks

Similar questions

Question 1. Plot a Graph with the data in Table 2, use Magnetic Force as the vertical axis and Current as the horizontal axis. Perform a linear least squares fit on the Graph, record the slope, intercept, and correlation coefficient in the Table 3. [Refer to Appendix 3_ Graphical Analysis of Experiment Results.docx]. Assume the horizontal copper trace on the Magnetic Force Board perfectly perpendicular to magnetic field, determine the magnitude of the magnetic field B, show your calculation in Table 3. Current (A) Table 2 0 0.25 0.5 0.75 1 -0.5 -1 Table 3 Mass of Magnet Assembly (gram) (Measured from scale) 0.000 0.039 0.080 0.122 0.162 -0.094 -0.222 Graph: Measure magnetic force versus Current Slope: Intercept: Correlation coefficient: Calculate magnetic field strength from the slope of your graph: Magnetic Force FB (Newton) 0 0.3822 0.784 1.1956 1.5876 -0.9212 -2.1756
What is the magnetic field at point P shown below if a=3.39mm, b = 6.81mm, and the current 1=5,075A? Define positive as out of the page. Assume 3 significant digits and units of Tesla. b Pl —a—
Determine the direction of the vector U, B, or F that is missing from the pair of vectors shown in each scenario. Here, u is the velocity vector of a moving positive charge, B is a constant and uniform magnetic field, and F is the resulting force on the moving charge. 1. 4. OB F ta V F O 2. 5. B TE ↑> V F Answer Bank - 3. 6. F OV TE F Į
Electric Magnetism Worksheet 1 -6 5. The value of the line integral of B around the closed path in the figure below is 3.77 x 10° Tm. What is the value of I3? Give proof of your answer. 1 = 6.0 A 1 = 2.0 A CS Scanned with CamScanner
Criterion A: Knowing and understanding i. state scientific knowledge. (Max. 2 points) A wire loop is moved from outside the magnetic field until it is fully inside the magnetic field. The initial magnetic flux is 0 Wb, and the change in magnetic flux is 2.5 Wb. The magnetic field has a strength of 0.031 T. Calculate the area of the wire loop. The following equations may be useful: AP = D = BLA Round your answer to 3 significant figures. BA 2.5 Wb A 0.031 T A = m² || ||
Magnetic field strength B is expressed by the MKS unit Tesla (T) which also equals to Group of answer choices Weber/meter2 (Wb/m2) Weber.meter (Wb.m) Weber (Wb) Weber/meter (Wb/m)
Estimates: since the force it takes to separate one magnet from your refrigerator is nearly the same as the force it takes to separate two magnets stuck together, that force F is 5 N and the area of a refrigerator magnet is 8 cm?. Assume that when these magnets are stuck together or to the refrigerator, they are separated by an effective distance d = 25 um. Use the formula derived above to estimate the magnetic field strength of the magnet. Express your answer to one significant figures and include the appropriate units.
Write pages. Partial creu Question 1: Magnetic Fields A point charge of value q = 3.10μC has a speed of = 1.75 x 107-0.81 x 107k when it is at the point (0 cm, 0 cm, 0 cm). What is the magnetic field vector in component form at position (1cm, 1cm, 0cm)? Answer Magnetic Field Vector Ho 4π 10-7 T m² c.m S
If the magnetic field at the center of a single loop wire with a radius of 2.4cm is 0.014T, calculate the magnetic field if the radius would be 6.8cm with the same current. Express your result in units of T with 3 decimals.
A solenoid used to produce magnetic fields for research purposes is 2.7 m long, with an inner radius of 68 cm and 3.4 x 104 turns of wire. When the current is 300 A, what is the magnitude of the magnetic field inside of the solenoid, in Tesla? Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement.
This problem is in 3D. P is the center. Out of the page is a distance z from P. Let this z be 0.04 m. Calculate the "net" magnetic field at z provided that 1 = 358 A, a = 0.03 m, and b = 0.05 m. Use μ = 1.257x10-6 Wb/Am b NOTE: You will use here the right hand rule and superposition of magnetic field. Out of the page is +, while into the page is -. Final answer in FIVE decimal places. Ignore the effects of the straight wire at the bottom. Include the SI unit. Add your answer
A cube magnetized with the magnetization vector in the figure has a magnetic permeability μ and a side length a. In this case, find the following. a) Find B (vector) b) Find Jms and Jmv