A wire loop is moved from outside the magnetic field until it is fully inside the magnetic field. The initial magnetic flux is 0 Wb, and the change in magnetic flux is 2.5 Wb. The magnetic field has a strength of 0.031 T. Calculate the area of the wire loop. The following equations may be useful: A¢ = P; - Þ; ¢ = B1A Round your answer to 3 significant figures. BLA xA 2.5 Wb A = 0.031 T A = m? ||

A wire loop is moved from outside the magnetic field until it is fully inside the magnetic field. The initial magnetic flux is 0 Wb, and the change in magnetic flux is 2.5 Wb. The magnetic field has a strength of 0.031 T. Calculate the area of the wire loop. The following equations may be useful: A¢ = P; - Þ; ¢ = B1A Round your answer to 3 significant figures. BLA xA 2.5 Wb A = 0.031 T A = m? ||

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter8: Electromagnetism And Em Waves

Section: Chapter Questions

Problem 2Q

See similar textbooks

Similar questions

me: 3. a. Draw Electric and Magnetic Field lines: Please differentiate between them. b. What would the separation between these objects, one carrying 1 C of positive charge and the other 1 C of negative charge, have to be if the electrical force on each was precisely 1 N? used in Hydrogen. ar the absorbed I I oton? Bus vrs. (6 rints) WLLS? I What is the esiste une light bulbs in ohms? D. What is ne pow consumed by the light bulb i c. If tw identic slide projectors are connected in par Vit Jurce nat is the total current draw c + project draw current 5/04/2023 peres when operating on uss th state Souce? same 1
Apparently my homework is incorrect, can you help? What else could the answers be? Please help answer in format as: A.) B.) C.)
B INSTRUCTION Solve the following problems. ANSWER ONLY TWO OUT OF THREE QUESTIONS. Show your complete solutions. NOT FOLLOWING OF INSTRUCTIONS will be a deduction of 10 POINTS from the total score. 1.A proton enters a magnetic tield of flux density 1.5 Wb/m² with a vetocity of 2.0 x 107 m/s at an angle of 30° with the field. Compute the force on the proton. 2.A steady current of 2 A in a coil of 400 turns causes a flux of 104 wb to link (pass through) the loops of the coil. Compute the average back emf induced in the coit it the current is stopped in 0.08 seconds. 3. A coil of 50 loops is pulled in 0.020 seconds from between the poles of a magnet, where its area intercepts a flux of 3.1 x 10-4 Wb, to a place where the intercepted flux is 0.10 x 10-4 Wb. Determine the average emf induced.
1. A tesla is an SI-derived unit for the strength of a magnetic field. A scientist measures a magnetic field of strength 12.4 microteslas. Express this value in the base unit of teslas, writing your answer in standard notation. 2. Express the value 12.4 microteslas in the base unit of teslas, but write your answer in scientific notation.
A proton moving at a speed of 2.25x 106 m/s enters a uniform magnetic field of 0, 750 T at a 43,2-degree angle Calculate the pitch-the distance it travels along the magnetic field within one period, in meters. Use exponential format and 3 SF
Then the ions enter to velocity selector region. In this region both electric and magnetic fields are applied. Next theyenter into the mass spectrometer region. In this region there is magnetic field different than the previous region. Depending of the charge of the ions, they travel in a circular path with a well-defined radius either to the left or to the right. 1.The mass difference between two isotopes is sometimes just a neutron mass. The spectrometer should separate them very well. For such an isotope combination, the difference in radius should be around 1 cm. That is . In order to achieve this, choose a magnetic field with a magnitude in Tesla (maximum magnetic field you can obtain from a conventional magnet is around 2.5 T so be far away from this value) and choose the direction also. Then determine the velocity of isotope you need. Last calculate radius r of a smallest isotope. 2.In order to produce this magnetic field, determine the current and number of turns, radius and…
Determine the direction of the vector U, B, or F that is missing from the pair of vectors shown in each scenario. Here, u is the velocity vector of a moving positive charge, B is a constant and uniform magnetic field, and F is the resulting force on the moving charge. 1. 4. OB F ta V F O 2. 5. B TE ↑> V F Answer Bank - 3. 6. F OV TE F Į
Determine the direction of the vector v, B, or F that is missing from the pair of vectors shown in each scenario. Here, v is the velocity vector of a moving positive charge, B is a constant and uniform magnetic field, and F is the resulting force on the moving charge. 1. 4. OB THE F 2. 5. teo B 7 F Answer Bank 3. 6. 7 F
Q1) An infinite long wire carries current I = 4 A upward is placed parallel to the longest sides of a rectangular loop that carries I2 = 12.5 A moving clockwise. If the distance between the infinite wire and the nearest side is 0.2 m and the rectangular loop has dimensions of 0.1 mX 0.3 m. Perform the following task. 1.1. Draw a model that illustrate the set up of the question and show all the forces that is associated to the two wires.
Electric Magnetism Worksheet 1 -6 5. The value of the line integral of B around the closed path in the figure below is 3.77 x 10° Tm. What is the value of I3? Give proof of your answer. 1 = 6.0 A 1 = 2.0 A CS Scanned with CamScanner
Question 1. Plot a Graph with the data in Table 2, use Magnetic Force as the vertical axis and Current as the horizontal axis. Perform a linear least squares fit on the Graph, record the slope, intercept, and correlation coefficient in the Table 3. [Refer to Appendix 3_ Graphical Analysis of Experiment Results.docx]. Assume the horizontal copper trace on the Magnetic Force Board perfectly perpendicular to magnetic field, determine the magnitude of the magnetic field B, show your calculation in Table 3. Current (A) Table 2 0 0.25 0.5 0.75 1 -0.5 -1 Table 3 Mass of Magnet Assembly (gram) (Measured from scale) 0.000 0.039 0.080 0.122 0.162 -0.094 -0.222 Graph: Measure magnetic force versus Current Slope: Intercept: Correlation coefficient: Calculate magnetic field strength from the slope of your graph: Magnetic Force FB (Newton) 0 0.3822 0.784 1.1956 1.5876 -0.9212 -2.1756
Figure 3 shows a straight wire carrying a current in upwarddirection. The wire is placed near a wire loop. For each case described below, answer the following questions:a. What is the direction of the magnetic flux through theloop?b. Is the magnitude of the flux through the loop increasing ordecreasing with time?c. What is the direction of the magnetic field produced by theinduced current in the loop?d. What is the direction of the current induced in the loop?1. Case 1: The current is increasing.2. Case 2: The current is decreasing.3. Case 3: The current is constant but the loop is being pulledaway from the straight wire.