Find the current passing through the 41 ? by Supen position?

Q: Q2. a) A four-pole, 415 V 50Hz induction motor supplies its rated power to a constant load. The…

A: Given dataNote: “Since you have posted question with multiple sub parts, we will provide the…

Q: The figure shows the vector field and the divergence of the vector field. What color describes the…

A: In the given questions we need to identify the source of vector field.

Q: Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor m Non- linear, Load…

A: The given circuit is shown below.

Q: A base station is placed in the center of the first floor of a building. Propagation on that floor…

A: We are given a base station which is placed in the center of the first floor of a building.…

Q: Use the complex translation theorem to derive the modified z-transform of f(t) = e ^-at * cosωt

A: In the realm of signal processing and system analysis, translation theorems act as powerful tools…

Q: Answer the following questions a) What assumption do we make for an ideal op - amp? b) Explain what…

A: we need to explain:a) What assumption do we make for an ideal op - amp?b) what is slew rate? and why…

Q: An abc phase sequence three-phase balanced wye-connected source supplies a balanced delta-connected…

A: Asked to find the line current?The circuit diagram is,

Q: 1) Consider the circuit diagram shown below. 1 v. 1+0 252 1H 0.1 F a) Find an expression for I(s).…

A: In this question, we need to determine the expression of the current I(s) , i(t) and transfer…

Q: (a) Create a matrix called D_to_R composed of two columns, degrees and radians (8 to 180). Use your…

A: According to the question, we need to write MATLAB code to convert from the degree to radian.

Q: Create the circuit implementation and truth table for the following Boolean equation: F =…

A: Given function is Asked to find the truth table and logic diagram for the above expression.

Q: . Determine 1₁, 12,13 and 15 using only current divider formula when I4 =4A.

A: In the given circuit the value of the current needs to be calculated by using the current division…

Q: Draw a state diagram for digital system which is represented by the following dynamic equations x(k+…

A:

Q: Consider the signal x(t) = 3/ 2 cos ( (2π/ 7) t − 4/5)  + 9/11 cos (( 4π /15) t + 5π/ 6 ) .…

A: The Nyquist rate, also known as the Nyquist frequency or critical frequency, is a fundamental…

Q: Q1.2 Ď (10.0 m) 25.0° C (12.0 m) 53.0° B (15.0 m) 30.0° X A (8.00 m) Consider the vectors shown.…

A: Vector is a mathematical quantity that has both magnitude and direction. In contrast to scalar…

Q: An 880-MHz base station has a 3-dB gain antenna. Cell phones have 0-dB gain antennas. Propagation is…

A: We are given that an 880 MHz base station has a 3-dB gain antenna.Also, it is mentioned that…

Q: 4.25. Let X(jw) denote the Fourier transform of the signal x(t) depicted in Figure P4.25. (a) Find…

A:

Q: Carbon Hollow +T 12T 121 2a 2b F TI Figure P2.4: Carbon resistor for Problem 2.4.

A: Given Data:A resistor made up of a hollow cylinder surrounded by a layer of carbon with,The length…

Q: Inverse Laplace transform is s²3s + 4 S³

A: Given data:Required information:

Q: Let the following periodic signal: DO x(t) = [8(t-3m) + 6(t - 1 - 3m) – 8(t – 2 – 3m)]. M1-6 Be the…

A: The Fourier series is a mathematical tool that represents a periodic function as the sum of…

Q: Convert the transfer function s+1/s^3+2s^2+15s+5 To state space representation

A: Given:A transfer function, ,To do:Convert the transfer function to state space representation.

Q: MHZ For the circuit shown below, if the delay time of each stage is considered to be 50 ns, the…

A: Given:a circuit,if the delay of each stage to be considered as 50 ns. we need to compute:The…

Q: If you have 3-phase power and you need to step down (or up) in 3-phase voltage, how many…

A: The objective of the question is to determine the number of single-phase transformers required to…

Q: 100sin(200t) V 30 Ω Μ 50 Ω Ε 50 με 0.1 Η welr 5 (1)

A: Given Data:An AC circuit with,Supply voltage The angular frequency To Find:The voltage across the…

Q: •) Describe the Hall effect. Draw a iagnam to illustrate your answer.

A: In the captivating world of Electronics and physics, where electricity and magnetism play an…

Q: Are electric fields conservative?

A: The objective of the question is to determine whether electric fields are conservative or not. A…

Q: The type of the feedback in this circuit is:

A: In the given question we need to discuss about the type of feedback in system.

Q: Derive an expression for vo/vs for the circuit shown below. Rs ww Ust {√₂ gm Vz Yo RL Vo

A:

Q: In the piece of circuit given below i₁ = 3A and 1₂ = -4A. What is the value of i3 O i3 = 7A O i3 =…

A: KCL stands for Kirchhoff's Current Law, which is a fundamental principle in electrical circuit…

Q: Q3. Design a DC/DC buck converter (as shown in Figure Q3) for an input voltage of 12V and an output…

A: According to Bartleby question answer rule i have to attempt first three sub parts only That is why…

Q: The current flowing through an element is A S Os 4s Calculate the charge entering the element in…

A: For the value of given current expression, the charge through the element needs to be calculated.

Q: 3. Determine the amount of power dissipated in the 3 kº resistor. 10 mA († + V 5ΚΩ 3 ΚΩ 10-3V/0

A: Given a circuit,we are required: to determine the power dissipated in 3 k resistance. .

Q: 3- What value of VIN will place D1 at its transition point? 1 ΚΩ m VIN 1.5 V D1 D2 470 Ω

A: In this question, we need to determine the voltage VIN for diode D1 at its transition point. Assume…

Q: The voltage across and current through a certain deviceare given byυ(t) = 5 cos(4πt) V, i(t) = 0.1…

A: The objective of this question is to calculate the instantaneous power and the average power for a…

Q: (in amperes) when 100 volts is applied to a circuit is given I = 5e-2t sin(t), where t is the time…

A: In this question, we need to determine the current at time t= 0.5 s. current expression is given.

Q: 3. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

A: Using a simple Krichhoff's law, we can solve this question and we know that in parallel branches the…

Q: An abc-sequence set of voltages feeds a balanced three-phase wye-wye system. If Van = 440230 Vrms…

A: In this question, we need to determine the average power at the load. We know, Complex power S= VI*…

Q: d) Determine Vasa, loo. Vo for a voltage divider bias circuit, where R₁=2.1MQ, R₂-270K, RD=2.4KQ, Rs…

A: We need to find out drain current and drain voltage and gate to source voltage for given problem.

Q: 2) A system is given d²y(t) dt² +6 dy(t) dt + 8y(t) = 2x(t) a) Find the impulse response of the…

A:

Q: In the network shown in figure, the switch closes at t=0. The capacitor is initially uncharged find…

A: In the given questions we need to calculate the voltage and current through capacitor.

Q: modulation is used. Calculate (a) the frequency of the carrier crystal oscillator and (b) the phase…

A: A transmitter must operate at a frequency of 160 MHz with a deviation of ± 4 kHz.It uses two…

Q: R B Y R 400V, 60Hz IR Ze=550° Figure 4: Star Unbalanced Load IR ZR Is ly Zx ZR = 30 < 0° 0 Fault…

A: A balanced load refers to a situation in an electrical system where the connected loads are evenly…

Q: What unit do we use to report coupling constants (aka J-values)? a) MHz b) Hz c) ppm d) %

A: In nuclear magnetic resonance (NMR) and magnetic resonance spectroscopy (MRS), a coupling constant…

Q: 1. For the amplifiers shown below, assume gm = 4mA/V. Calculate a) The input resistance, Rin b)…

A:

Q: 7.10. A carrier of amplitude 1 mv is 50% amplitude modulated by a sinusoidal waveform of frequency…

A: Amplitude modulation (AM) is a technique used in communication systems to encode information on a…

Q: 2.) Aşağıdaki devrede Vo 1 bulunuz? (Find Vo in the circuit below) 5V(+ 2 ΚΩ ww 6 ΚΩ 8 ΚΩ 2 ΚΩ 1 ΚΩ…

A: In the given circuit, we are required to determine: output voltage V0.

Q: Consider the following three CS stage ring Oscillator. If the number of stages is increased to nine,…

A: A ring oscillator is a type of electronic oscillator commonly used in digital circuits for…

Q: R₂lk. { K Imm www R2=1002, B₂=2202 11 E = 20 Volt Fig-13-1 For the circuit shown in Figure (3).…

A:

Q: Use a convolution integral to obtain the inverse transform of 3 H(s)=(?)

A: In the given question we need to calculate the Laplace transform by convolution integration.

Q: Determine the value of I, in the circuit shown in (Figure 1).

A: Given:A circuit, with, we need to determine:the value of current Ix.

Q: Determine the magnitude of the towing force FBF� if the resultant force has a magnitude FR�� = 6…

A: The objective of the question is to find the magnitude of the towing force F_B given that the…

Gradient of a Scalar Field

Consider a room or a place where the temperature is denoted by a scalar field T, such that at each point (x, y, z), the temperature is given as T(x, y, z). It is independent of time, in which the temperature rises most quickly. The gradient of T will show the direction at that point by moving away from (x, y, z). How far will the rise in temperature in that direction be determined by the gradient magnitude? Consider a surface that has a height above sea level at point (x, y) which is given by H(x, y). At that point, pointing in the direction of the steepest slope or grade is the gradient of H. The magnitude of the gradient of the vector gives the steepness of the slope at that point. How a scalar field changes in another direction can be measured by the gradient by taking a dot product rather than just the direction of the greatest change?