(e) A 3-phase double circuit line is shown in the given figure. The diameter of each conductor is 2 cm. Determine the capacitance and charging current per km length of the line, assume that the line is transposed and the operating voltage 220 kV. 5 m- 3 m - 7.5 m - 3 m

Q: A P-N junction mimics a closed switch when it: Select the correct response: has a wide depletion reg...

A: 1) ANSWER IS D - HAS A LOW JUNCTION RESISTANCE D)IT HAS A LOW JUNCTION RESISTANCE THE PN JUNCTION WI...

Q: Q1. Write down the nodal equations for all nodes. 34 20 ww 24 V 22 ww

A: A nodal analysis is a method that provides a common process for analyzing circuits using node voltag...

Q: R3 R R1 R2 A R R R4 Ra Vo Vi R D B- +

A:

Q: When checking a diode, low resistance readings both ways indicate the diode is: Select the correct r...

A:

Q: 2. Two capacitors in parallel, 2-µF and 4-uF are connected in series with a 3-µF capacitor. The comb...

A:

Q: Q3.(4.w) AparalleLimpedance Crcuit has V=33V, I= 75-2 m A. Palo.5", Calculale (s,pand@) pozwecandp.f...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: ard Check propertres of The fallowina systen

A:

Q: R = 10 mA 1 = 0 vdt) 10 μF 2 kN

A:

Q: The following information is given in connection with test performed on a 50 kva, 4600/230 volts 60H...

A:

Q: Problem7) Suppose that N(t) is a zero-mean stationary narrowband process. The autocorrelation functi...

A: GIVEN: (a)   Rz(τ)=EZ*(t)Z(t+τ)              (b)   Rz(τ)=N0δ(τ)                      V=∫0TZ(t)dt FIN...

Q: A three-phase 4-pole, 144 slots with 10 conductors per slot, star connected alternator it runs at a ...

A: In this question,  We need to Calculate the RMS value of the induced emf per phase and the line volt...

Q: Problem8) Determine the signal space representation of the four signals są(1), k = 1, 2, 3, 4, shown...

A:

Q: An audio signal has a baseband that ranges from 0.7 kHz to 5.25 kHz. If this signal is to be digitis...

A: Given, Range of audio signal is 0.7 kHz to 5.25 kHz.  

Q: Example: The current in a circuit of: a- the rms current. b- the frec when t=3 msec.

A:

Q: Draw the equivalent circuit of Induction motor and explain its different parameters.

A:

Q: What is the advantage of the JK flip flop over the SR flip flop?

A: Generally for an SR flip-flop when both the inputs are both 1's , the output is invalid state . But ...

Q: The load current in a system is 100 A. The short-circuit current for the smallest fault is 1000 A. A...

A: we have given The load current in a system is 100 A The short-circuit current for the smallestfault ...

Q: Problem 4 The magnetic circuit shown in the figure has two windings and two air gaps. The core can b...

A:

Q: What is the transistor bias circuit arrangement that provides, but requires voltage, Q good stabilit...

A: To further stabilise the collector current, this sort of transistor biassing setup, also known as se...

Q: E, fov For the circuit showwn in figure,ind: D Totel current CIt)

A:

Q: Problem3. Find Vo in the following cireuit, using Thevenin's theorem. 2 mA 2 ΚΩ 2 kN 6 V(+ 6 kN 3 Vo...

A:

Q: 6) Find Reg Reg = 28 Kn 30KA Req 7 yokn 24kn ww. 18KA 20KN

A:

Q: Xe and x, denote the even and odd parts of x,

A: Even signal- When any signal is mirror image/symmetrical  to y axis or vertical axis then that signa...

Q: 2V

A:

Q: A simple one-pole system has transfer function H(s) = What is the magnitude of the frequency respons...

A: Given, Transfer function of simple one pole system Hs=11+τs

Q: Question 6- Calculate the drift velocity of an electron in a conductor is? The conductor (copper) nu...

A: Given a copper conductor having, Free charge per unit volume, n=8.46×1028 Cm3 Current density, J=382...

Q: 2. Generating station at Musandam has the following load cycle. (Refer the data sheet below). Determ...

A: In this question,  We need to determine the maximum load,  Unit generated by per day We know 1kWH= 1...

Q: Intrinsic semiconductor material is characterized by a valence shell of how many electrons? Select t...

A: Intrinsic semiconductor material means pure semiconductor it has not added doping material. Semicond...

Q: Complete the missing information from the table below for the Delta-Delta connection transfer shown ...

A:

Q: Calculate the voltage across the 2-ohm resistor. Express it in polar form. Show your complete solut...

A:

Q: Consider the following circuit with two DC voltage sources with voltage sources X and Y and resistor...

A: Given circuit:

Q: The figure below shows a combination of six resistors with identical resistance R. What is the equiv...

A: Given

Q: 2. a) Draw nominal t model of Transmission Line.

A:

Q: Q-4) Find the number of poles in the left half-plane, the right half-plane, and on the jw-axis for t...

A: Transfer function- It is define as the mathematical terms which shows the relation between the outpu...

Q: A point charge Q=10 nC is located at the origin. Find the amount of flux in the region of the sphere...

A:

Q: 1 (1) A plant in a unity feedback system is given by K G(s) s(s + 10)(s + 20) Find the value of K to...

A:

Q: Find the polarization in dielectric material with ᶓr = 2.8, if the electric flux density is 3x10- 7 ...

A: Polarization- Polarization is a property applied for the transverse wave which mark the geometric or...

Q: R1 1k R2 R3 3.3k 5.6k R4 VS1 VS2 2.2k 15V 5V

A: The give circuit diagram is shown below:

Q: 60 50 A 40 B 30 40

A: Given response of the system 

Q: transform of X(t)

A: Fourier transform- It is representation of any functions ( basically aperiodic function) which is in...

Q: Draw the output voltage waveform. Show in step by step.

A: Diode is forward biased when anode voltage is greater than cathode voltage. And diode is reverse bia...

Q: Find the canonical sum of products and product of sums expression for the function F = X1 X2 X3 + X1...

A:

Q: Q2. A Mealy sequential circuit has one input (X) and two outputs (Z1 and Z2). The circuit produces a...

A: MEALY CIRCUIT A mealy circuit finite state machine whose output depend on the present state as well ...

Q: What is the RC Time Constant for the following circuit

A: Time constant of RC circuit is Req×C. Where Req  is equivalent resistance is from capacitor terminal...

Q: The transfer function of an inverting op-amp amplifier is _____. A. The ratio of the input impedanc...

A:

Q: writ Overview about LED brightness control?

A: A light-emitting diode (LED) is a semiconductor device that emits light through which electricity pa...

Q: Find Vca, Vad

A: The required voltage between the terminal can be calculated by using the kirchhoff's voltage law.

Q: Example: The c of: a- the rms cu when t=3 msec.

A:

Q: Solve for Vd and Id for this figure. Show complete solution

A: In this question,  We need to determine the Vd and Id  as shown in the circuit.  Assume forward bias...

Q: A complete circuit is shown (see figure), Determine the terminal voltage Vab on the 5.0 V battery. 1...

A: Apply KVL in the circuit in anticlockwise direction. -5+1.6i+5i+1.4i+12+9i=07+17i=0i=717i=0.411 A Th...

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.