What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines B. Inductance and capacitance in the loads C. Ideal transformer connected in the system D. Power produced by generator

What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines B. Inductance and capacitance in the loads C. Ideal transformer connected in the system D. Power produced by generator

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.11MCQ: For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the...

See similar textbooks

Related questions

Q: 1.a. For performing dielectric-strength tests on insulating materials, two transformers are…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: The working principle of ___ is based on electromagnetic induction.

A: An electrical machine is majorly classified in three types: Transformers Generators Motors…

Q: A single phase circuit with a given load 3 ohm resistance and inductive reactance of 4 ohms as…

A: The question is about active power, reactive power and apparent power, power factor.

Q: An ideal transformer has 500 turns on the primary and 300 turns on the secondary. The source…

Q: The primary of a certain transformer, with and open-circuit secondary, takes 1A at a power factor of…

A: Given I2=50Apower factor ϕ0=0.4power factor ϕ2=0.8

Q: A four- pole three phase , 50 hz star connected AC generator has 24 stator slots. There are 6…

A: Given frequency, f=50Hz

Q: Two single-phase transformers whose phase electrical equivalent circuits are given below are…

A: Since both the transformer are connected in parallel,we can draw the each transformer equivalent…

Q: Example 33.9. A 2000-kVA, 6,600/400-V, 3-phase transformer is delta-connected on the high voltage…

Q: R1 100 Ω V1 sine (A 60 Hz R2 10 10 Vrms 1:1 Calculate the magnitude (in RMS) of the voltage across…

Q: The conditions of an induction motor on load resembles those of transformer whose secondary is…

Q: A transformer shown in Figure 10 is needed that will cause an actual load resistance of 250 to…

A: (a) Redraw the given circuit diagram.

Q: 20. The alternating flux in the primary of a transformer is A. leading the magnetizing current. B.…

A: 20.

Q: 1. A 400-µF capacitor is connected to the terminal of a single-phase induction generator. The…

A: As per our company guidelines we are supposed to answer only first question. Kindly repost other…

Q: 37. A power-supply transformer has a tums ratio of 2:1 (a) what is the secondary voltage if the…

A: Given diagram is, Primary voltageVP=115 V , Turn ratio, N1N2=21

Q: 4. A 3-phase, star-connected alternator is rated at 1600 KVA, 13500 V. the armature effective…

Q: Three Phase Power Factor Improvement Suppose that a shop is served with a three-phase, 400 V…

A: Given: Before power factor correction: After correction:

Q: Q.1: The following data refer to a single-phase transformer: Turn ratio (1:5), R1=0.24 n, X=1 N,…

Q: DHA) a) Draw an equivalent circuit of a current transformer and derive expressions for ratio and…

A: a) Current transformers- These are those type of transformers, which are mainly used for measurement…

Q: 5.When combined with a CSD ,a brushless three phase se AC generator is often referred to as: (a)a…

A: The answer of the following questions are

Q: e star connected, 1500 kVA, 13 kV alternator has an armature res ous reactance of 8.0 ohms. When…

Q: Q1// What is the purpose of conducting experiments (o.c) and (s.c) on asingle phase transformer?

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: Why tertiary winding is used? Select one: a To connect static capacitors for reactive power…

A: To stabilize the system or winding , we use the tertiary will winding. It reduces the unbalancing in…

Q: A single phase transformer operates at 50 Hz, 200 V rms power supply. Find the number of turns in…

A: This question belongs to electrical machine . It is related to single phase transformer . It is…

Q: 5- The most effective factor on the leakage inductance of an iron-cored coil is: a) The geometry of…

A: The leakage inductance of the iron cored coil is due to the fact that the primary in not properly…

Q: Data obtained from short circuit & open circuit tests of 60 kVA, 3200-220 V are: Open circuit:…

Q: Three of a 15 kVA, 2200:220 V, 50 Hz transformer are connected in A-A to supply at 220 Volts…

A: The solution of the given problem is as follows- Let's analyse the system on per phase basis- Per…

Q: A system with an ideal transformer is shown below. Make sure that anytime sinusoidal quantitier are…

A: In the circuit, A ideal transformer with ratio 3:2 Find the primary and secondary current ? Output…

Q: Problem 1 A 3-phase, star-connected alternator generates 6,360 V per phase and supplies 500 kW at a…

Q: A substation delivers 693 kW, threephase power using an open-delta connected transformer bank. The…

A: It is given that: P=693 kWcosϕ=1

Q: A single-phase transformer has 500 primary and 1200 secondary turns. The dimension of the core is 30…

Q: 1) Calculate the maximum RMS current in p.u. that guarantees the equality of losses between the…

A: Given : KVA rating is 400 KVA PCP=6% Find the RMS value of current in PU For 12 pulse converter…

Q: Two single-phase transformers whose phase electrical equivalent circuits are given below are…

Q: Q.1: The following data refer to a single-phase transformer: Tum ratio (2:1), R-2.4 n, X-2.5 1,…

Q: Problem 2: Transformer circuit 1H R V mains 10 A transformer has a winding that has the equivalent…

A: NOTE: : Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: A 50 Hz current transformer has a secondary current of 5 A, and total impedance of secondary side of…

A: Given : A 50 Hz current transformer To find the maximum flux density in the core, ratio error and…

Q: Three single phases 20 kVA, 2200/220 V, 50 Hz transformers are connected to form a three-phase…

A: A single phase rating is 20 kVA, 2200/220 V. When a three phase transformer is design using three…

Q: A load of 200 kW at 0.85 power factor is to pe shared by two transformers A and B aving the same…

Q: The ideal three-winding transformer below has parameters: N1 = 100 turns, N2 = 200 turns and N3 =…

A: N1=100N2=200N3=300V1=23VV1 rms=162.634V

Q: A Wye-Delta transformer is connected to a 66 kV input three-phase transmission line. Each…

Q: Consider a 10 KVA, 200/400 V; 50 HZ: single-phase transformer has the following test resalts: O.C.…

A: According to question: The open circuit test gives core loss and is given as Pi=55W The full load…

Q: What is the relationship between primary induced emf( E1) and applied voltage (V1) of a Transformer?…

A: The relationship between primary induced emf( E1) and applied voltage (V1)

Q: A 40 kVA 6000/240-V distribution transformer has an impedance referred to the primary of 15+j80Ω.…

Q: determine (i) the core loss current(Ic) (ii) the power factor on no-load and (iii) the magnetizing…

A: Given,the measurement is taken while the secondary of transformer is open circuited. So we can say…

Q: The circuit of resistance is defined as a load circuit. A) Find the average power dissipated by the…

A: In the circuit the capacitor and resistance is connect to load. A) Find the average power…

Q: A 3-phase 400 V line-to-line wye-connected synchronous motor has Xs = 1.0 ohm/phase and a negligible…

A: 8jhkk

Q: An ideal 15-kVA transformer has 300 turns on the primary winding and 50 turns on the secondary…

A: Given Data: N1 = 300 N2 = 50 V1 = 2000 rating = 15 kVA

Q: 12.) The no-load current of a transformer is 4.0 A at 0.25 p.f. when supplied at 250-V, 50 Hz. The…

A: When transformer operating at no load, it draw very less current at poor power factor. Let No…

Q: A short-circuit test is carried out on a single-phase, 10 MVA, 66 kV/7.2 kV transformer T as shown…

A: Given information: The value of the rated primary current is:

Q: Question 3: Design an isolated transformer to energise Load at the below circuit. The Load power is…

A: Electrical machines can be either generator , transformers or motors. They can be either Ac machines…

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

What is the main direct cause of reactive power in AC system?
A. Resistance of transmission lines
B. Inductance and capacitance in the loads
C. Ideal transformer connected in the system
D. Power produced by generator

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An ideal transformer has no real or reactive power loss. (a) True (b) False
For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
1.a. For performing dielectric-strength tests on insulating materials, two transformers are connected in aA. parallel combination.B. cascade arrangement.C. polyphase arrangement. 1.b. In large power transformers, the unequal voltage distribution caused by voltage surges in the winding isprevented by the use ofA. static shields.B. series capacitors.c. low-voltage arresters.
talk about coreless transformer
10 A three-phase transformer is given. The number of turns of the high voltage winding is N1=850 and the number of turns of the low voltage winding is N2=34. The high voltage winding is energized with V1= 10 kV rms line-to-line and V2= 400 V rms line-to-line has been taken from the low voltage winding. What is the connection of the low voltage winding if the high voltage winding is Y-connected? Εισαγάγετε την απάντησή σας
. A 400/230V, 50Hz, single phase transformer has 200 turns on high voltage side. Find turns ratio, transformation ratio, and number of turns on low voltage winding. Also find the flux developed in the core
In a transformer that has 10 times more turns on the secondary side (side 2) than on the primary side (side 1), the magnitude of the voltage/EMF across the windings on the secondary side, E₂ will be... O a.... 10 times lower than the voltage/emf on the primary side, E₁. O b.... the same as the voltage/emf on the primary side. O c.... always zero regardless of the voltage on the primary side, E₁. O d.... 10 times higher than the voltage/emf on the primary side, E₁.
The net cross section of a transformer is 20 square inches. The maximum fluxdensity is 11 kilogausses. The frequency is 60 Hz. If there are 1,000 turns in theprimary, determine the primary induced emf.
A. What are the various causes of voltage drop in atransformer? B. A single phase transformer has arated secondary voltage of (230v).when Loaded by a purely inductive load to its rated Value of current ,its terminal voltage drops to (200 v). Calculate its regulation and efficiency.
Draw the phasor diagrams for the following 3-phase components: 1-Transformer: exact equivalent circuit of lagging load with V1 reference. 2- Alternator: leading pf, normal excitation, and maximum power. 3- Compensator: lagging pf, leading pf, and normal excitation.
C. Transformer problem.
-AL. Explain the operation of a single phase transformer at no-load. Draw the phasor diagram and describe the main eleetrical quantities involved.