Answered: A double-circuit its capacitance to…

A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is 0.0452 ft. Determine 16' 16' a b 22' c' b' a'

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What are FACTS (Flexible Alternating Current Transmission Systems), and how do they enhance power…

A: Flexible Alternating Current Transmission Systems (FACTS) devices are advanced power electronics and…

Q: The maximum and minimum stresses in the dielectric of a single core cable are 40 KV/cm (rms) and 10…

Q: A 3phase 60hz line has flat vertical spacing. The conductor have a GMR of 0.0133m with 10m between…

A: A 3phase 60hz line flat vertical spacing. The conductor have a GMR of 0.0133m 10m between adjacent…

Q: L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm,…

A: First we will calculate impedance ssen by the source and than we will find current from source in…

Q: 11. The eddy current loss of a given solid core is 80 W at 50 Hz. What would be the loss of 60 Hz if…

Q: Number of parallel paths in a wave winding is equal to the number of magnetic poles True False

A: Number of parallel paths in wave winding is 2. In wave winding : A = 2 In case of lap winding…

Q: Problem 3.1: Determine the rms value of voltage induced in an 80-turn coil on a 30 cm × 25 cm…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1480 rpm,…

Q: What is the maximum current-carrying capacity of a wire or cable? A. Overcurrent B. Energy C.…

A: The objective is to determine the correct term for the maximum current capacity.

Q: L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm,…

A: According to the question we have to calculate how many times the inrush current will be the rated…

Q: The three conductors a,b,c of a 3 phase are arranged in a horizontal plane with Dab=2m, Dbc=2.5m.…

Q: DISCUSSION QUESTIONS What in. ..metrical snacing of conductors in a 3-phaea trancmicsion line ? 3.…

A: In this question we discuss why do we find line to neutral capacitance in a three phase system ?

Q: Sketch a single-phase voltage sag event and explain its characteristics. List three potential causes…

A: The frequently occurring voltage sags are single-phase events that are basically due to a…

Q: single conductor is arranged so that 13.5 inches of its length passes through a uniform magnetic…

A: In this question , we will find generated voltage ...

Q: Single phasing happens when one phase of a three phase source becomes unavailable. True False

A: Given A true or false question based on single phasing condition. Please find the answer below.

Q: What are FACTS (Flexible Alternating Current Transmission Systems), and how do they improve the…

A: Flexible Alternating Current Transmission Systems (FACTS) are a set of advanced power electronics…

Q: Electricity has composite demand. True False

A: To justify that Electricity has composite demand or not

Q: What is the relation between the voltage drop and the distance in radial and ring circuit?

A: Concept: Using a constant voltage system, electrical power distribution is performed. Radial…

Q: Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material…

A: we know that electrical gradient in a cable is given by g=Vx ln R2R1

Q: L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm,…

A: According to the context of the given question, it is required to determine the number of times…

Q: A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm…

Q: In the core conductor given below, the radius of each core is r. the GMR of this conductor as r.

Q: What are FACTS (Flexible Alternating Current Transmission Systems) devices, and how do they enhance…

A: Flexible AC Transmission Systems (FACTS) devices are a family of power electronics-based devices and…

Q: b) Two transmission line circuits (circuit A and circuit B) that run parallel to each other is shown…

A: The circuit can be redrawn as GMR of circuit…

Q: L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1420 rpm,…

A: The slip of the three-phase ASM is calculated as shown below: Ns=120fPP=4f=50…

Q: how to chang temperature flow to laminar flow

A: The Laminar Flow The Laminar flow number of the lower gas laminar in the tube is analyzed by very…

Q: The value of inductance per conductor in a three-phase line is time(s) the loop inductance for the…

A: As per the guidelines of Bartley we supposed to answer first question since the remaining question…

Q: For transferring electrical power at 220 kV, six conductors of ACSR Drake constitute a 60Hz double…

A: Considering complexity of the solution, we are answering the first t0w subparts, please repost your…

Q: The phase angle between magnetizing component current and core loss component current is 90° Select…

Q: One advantages of load balancing is that each phase conductor carries the ? current value

A: We need to tell about advantage load balancing is that each phase conductor carries the equal…

Q: (b) Determine the inductance per km/phase of a double circuit three-phase line as shown in the given…

Question

A double-circuit
its capacitance to neutral per mile.
line is shown below. The conductor radius is 0.0452 ft. Determine
16'
16'
a
b
22'
c'
b'
a'

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Forward Voltage Wave In Figure 1 below, a voltage source, Vs, drives a transmission line of impedance Zo through a source resistance Zs. Zs Z. To 00 Figure 1 (a) Prove that the forward voltage wave is VẸ Vs/2 regardless of the value of Zo. – (b) If the positions of Vs and Zs are swapped, do the results of part (a) still hold? Why?
The inductance effect is predominant in underground cables than overhead lines. Select one: True False
The maximum flux density in the core of a 250/3000V, 50Hz single phasetransformer is 1.2 Wb/m2. If the emf per turn is 8 volt, determine(a) primary and secondary turns,
A (x-2) X. 4A (ytz) Prxty) 2V Determine currents x,y and E.
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the ratio of C1/C=0.1 (Shunt capacitance per self-capacitance) is given. If the string is connected to line of voltage 33kV. a) What is the voltage distribution over the unit of string and what is the string efficiency? b) When the string is supplied by a Guard Ring and this lead to add a two air capacitance of value 0.2C, 0.1C respectively to the nearest to the conductor. Find the new voltage distribution and the new efficiency.
Derives and analyse relation of capacitance for 3-core cables ? proper explanation in details
Power system
A 30 kV single core cable has a conductor dimeter of 2 cm and a sheath of inside diameter 6 cm. Find the maximum (peak value) and minimum stress (peak value) in the insulation.
How can we solve this question by using inversion formuler like using the poles
q15
What is the relation between the voltage drop and the distance in radial and ring circuit?