Determine the electrical current (12) and voltage (V2). Assume that the diode comes on when a forward bias voltage of 0.7V is applied. +6.4V GND 10 kohm 12 V₂ 40 kohm O a. Current is 0.1425mA and voltage 5.7V O b. Current is 0.1mA and voltage 4.0 V O c. Current is 0 mA and voltage 4.0 V Od. Current is 0.1mA and voltage 1.4 V

Determine the electrical current (12) and voltage (V2). Assume that the diode comes on when a forward bias voltage of 0.7V is applied. +6.4V GND 10 kohm 12 V₂ 40 kohm O a. Current is 0.1425mA and voltage 5.7V O b. Current is 0.1mA and voltage 4.0 V O c. Current is 0 mA and voltage 4.0 V Od. Current is 0.1mA and voltage 1.4 V

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Similar questions

How is a solid-state diode tested? Explain.
What is the difference between a diode and rectifier?
What is CEMF?
Determine the state of diode for the circuit shown and find ID, VD. Assume simplified model for the diode. 4k02 2V 1k02. Off, 0.00mA, 0.4V O Off, -0.005mA, 0.0v On, 0.48mA, 0.6v On, 0.55mA, 0.7v Option 5
Consider the circuit in the figure below 4:1 120 V rms ooooo gll reelee D₁ L a. What type of circuit is this? b. What is the total peak secondary voltage? D₂ c. Find the peak voltage across each half of the secondary. d. Sketch the voltage waveform across RL. e. What is the peak current through each diode? f. What is the PIV for each diode? RL 1.0 ΚΩ
u= 6sinot V. V. For the circuit of Figure, we have known E=3V, Use the ideal diode model to analyze the circuit and draw the waveform of the output voltage. 6V cot Uj E
What will be the value of the reverse saturation current for a Si diode operating in forward bias mode. The following information is given: Diode current 3 A Voltage across diode 0.25 V. Temperature is 300 K.
Draw the corresponding output waveform of the double diode partial limiter below using simplified diode model. Indicate all the necessary voltage levels and use Silicon diodes. 20 VP-P 1KQ M D1 9V D2 4.5V VOUT
d). Determine the minimum value of RL to ensure that the diode is “on”.
0:- Consider the circuit in Figure a) What type of circuit is this? b) Find and Sketch the voltage waveform across RL, assume the diodes are practical. c) If 100uf capacitor parallel with the resistor, calculate the ripple is connected factor I O o D
Determine vo and the required PIV rating of each diode for the configuration in the following figure.
Given an input square wave with +15V and -15V peaks, and bias voltage V of 3V. Diodes are ideal. Resistor value of 330ohms. Draw the output waveform, solve, explain and clearly indicate voltage peak level. HA C V₁ R 10