Consider a CDMA system with 4-bit chipping sequences.

https://www.analog.com/en/analog-dialogue/articles/introduction-to-spi-interface.html

Design a datapath to solve the following equation: K is the input P=(1+ 102/128) K + 32 Define how many bits are needed to work with.

How did the cyclic redundancy check (CRC) decoder wind up with a result that is in direct opposition to itself?

Write a program that acquires data from a data source and calculates and displays the Discrete FourierTransform associated with that data. In this case, the Arduino will generate a signal, that is sampled by the ADC and then sent to the computerover the serial port. The  Arduino  code is : int lookup_index = 0; #define SIN_FREQ 100 long sin_freq = SIN_FREQ; #define LOOKUP_ARRAY_SIZE 128UL #define PWM_RESOLUTION 8 #if PWM_RESOLUTION <= 8   #define PWM_t uint8_t #else   #define PWM_t uint16_t #endif PWM_t *lookup_array; // lookup array for sin(2pi f t) PWM_t lookup_array1[LOOKUP_ARRAY_SIZE] = {     127, 133, 139, 146, 152, 158, 164, 170, 176, 181, 187, 192, 198, 203, 208,     212, 217, 221, 225, 229, 233, 236, 239, 242, 244, 247, 249, 250, 252, 253,     253, 254, 254, 254, 253, 253, 252, 250, 249, 247, 244, 242, 239, 236, 233,     229, 225, 221, 217, 212, 208, 203, 198, 192, 187, 181, 176, 170, 164, 158,     152, 146, 139, 133, 127, 121, 115, 108, 102, 96, 90, 84, 78, 73, 67, 62,…

Explain how TLBs improve paging efficiency in (a)(i) and (a)(ii) below.

A digital counter is a device that generates binary numbers in a specified count sequence. The counter progresses through the specified sequence of numbers when triggered by an incoming clock waveform, and it advances from one number to the next only during the occurrence of a clock pulse. The counter cycles through the same sequence of numbers continuously so long as there is an incoming clock pulse. You are to build a 3-bit synci. us count-down counter, which is a counter that counts down goes throug.. Linnni states 111 to 000 and back to 111 to repeat the cou. are to use a positive-edge-tgered JK flip-flops. In the first step of the design, you ecu .- Flop inputs (1 column for each flip-flop input) The present state pur uv.. design and should enumerate the count sequence. The next state columns should specif wnicn slale wn cuo next, given the present state. For example, if circuit is in a present state of the nevt ate in a down-count sequence would be 0. You should design the FF…

Create an 8-bit byte Hamming ECC code MIPS software.   Your programmes work for 8-bit positive values because they're simpler.

Please give me correct solution.

Suppose we have two operands X and Y, where X = 0x34 and Y = 0xAF. (i) Convert X and Y into 8 bit binary. (ii) What is the result of X-Y ? (iii) What is the result of X AND Y? Give your answer in hexadecimal.