QUESTIONSCalculate the magnetic flux density at the following points:At a distance of 0.65 m from a long straight wire carrying 151) aA.At the center of a 350 turn circular coil of radius 0.24 m andcarrying a current of 3.6 A.b)Figure 1 shows a square coil of side 4.5 cm. A battery isconnected to the coil and produces a current of 6.8 A. Thecoil is placed in a uniform magnetic field of flux density 5.67mT as shown in Figure 1.A0oВCFigure 1Calculate the size and direction of the electromagnetic forcethat will act on side AB.Calculate the size and direction of the electromagnetic forcethat will act on side BC.Describe the motion of the frame immediately after thecurrent in the frame is switched on.c)The battery is removed from the coil and the coil is.nechanically rotated 90° clockwise. State the direction of theinduced current on side AB.North PoleSouth Pole

Hey, there are multiple questions posted; we are authorized to answer one question at a time, since…

Calculate the magnetic flux density at the following points: At a distance of 0.65 m from a long straight wire carrying 15 A. At the center of a 350 turn circular coil of radius 0.24 m and carrying a current of 3.6 A.

Calculate the magnetic flux density at the following points: At a distance of 0.65 m from a long straight wire carrying 15 A. At the center of a 350 turn circular coil of radius 0.24 m and carrying a current of 3.6 A.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

For problem 9 of the text, calculate the magnetic field in milliteslas using a value of V2 = 294.1 V (5 sig figs)
s & Noble ge Bookstore ex.bncollege.co NEXPECTED R HAS OCCU... an Subject System rs- rchpool.sona- ms.com an Subject Pool em Department... 5. A rectangular coil that has a length of 18.0 cm and a width of 6.5 cm containing 14 loops lies flat on your desk as shown on this page. A uniform magnetic field of magnitude 6.00 x 10-5 T points into this page. If a 6.00-A clockwise current flows through the coil, (a) determine the torque on the coil. N.m (b) which edge of the coil rises up? O O O O O Top Bottom None of these Right Left
Question 1. Plot a Graph with the data in Table 2, use Magnetic Force as the vertical axis and Current as the horizontal axis. Perform a linear least squares fit on the Graph, record the slope, intercept, and correlation coefficient in the Table 3. [Refer to Appendix 3_ Graphical Analysis of Experiment Results.docx]. Assume the horizontal copper trace on the Magnetic Force Board perfectly perpendicular to magnetic field, determine the magnitude of the magnetic field B, show your calculation in Table 3. Current (A) Table 2 0 0.25 0.5 0.75 1 -0.5 -1 Table 3 Mass of Magnet Assembly (gram) (Measured from scale) 0.000 0.039 0.080 0.122 0.162 -0.094 -0.222 Graph: Measure magnetic force versus Current Slope: Intercept: Correlation coefficient: Calculate magnetic field strength from the slope of your graph: Magnetic Force FB (Newton) 0 0.3822 0.784 1.1956 1.5876 -0.9212 -2.1756
An electron is sent through a mass spectrometersimilar to the diagram shown below. The electron startsfrom restandis accelerated East byan electric potential difference of 120 V. It then passes into a uniform magnetic field of magnitude 0.12T [North]. The electron follows a curve path, changing direction by 180° before it strikes a sensor.What is the displacement of the electron from the time it enters the magnetic field to the time it has changed direction by180°?(note: diagram below shows positive chargesentering the mass spectrometer)
What is the magnetic field at point P shown below if a=3.39mm, b = 6.81mm, and the current 1=5,075A? Define positive as out of the page. Assume 3 significant digits and units of Tesla. b Pl —a—
Ex. 3 : Find the percent increase in the magnetic field B when the space within a current carrying aluminium. The susceptibility of aluminium toroid is filled with is 2.1 x 10-5.
A single circular loop of radius 0.23 m carries a current of 2.6 A in a magnetic field of 0.95 T. Find the angle the plane of the loop must make with the field if the torque is to be half its maximum value. Express your answer using two significant figures.
Criterion A: Knowing and understanding i. state scientific knowledge. (Max. 2 points) A wire loop is moved from outside the magnetic field until it is fully inside the magnetic field. The initial magnetic flux is 0 Wb, and the change in magnetic flux is 2.5 Wb. The magnetic field has a strength of 0.031 T. Calculate the area of the wire loop. The following equations may be useful: AP = D = BLA Round your answer to 3 significant figures. BA 2.5 Wb A 0.031 T A = m² || ||
A straight wire of length 45 cm is moved an angle of 30° to a uniform magnetic field of 2.0 x 106 T with speed of 3.5 ms'. Calculate the induce e.m.f produced in the wire. If the wire is connected to circuit of resistance of 2.0 Q, determine the amount of charge will flow in the circuit. Suggest one way by which this amount of charge may be increased. With the help of a diagram, explain your answer.
The plane of a square coil of wire is perpendicular to the direction of a magnetic field. The coil has N turns, a length and width of L, and a total resistance of R. Show how to find an equation for the rate of change of B needed to produce some current, I. (Find ?̇ as a functionof the variables given)
Figure 1: CRT with coils in Helmholtz configuration. The hot cathode emits electrons which are then accelerated through potential difference Vacc. When the electrons enter the magnetic field B, which is perpendicular to their velocity, they move on a circular path with radius r. The magnetic field is due to coils in Helmholtz configuration (2 coils separated distance that equals their radius). The magnetic field due to one of the coils with radius R, at a point on the axis distance z away from the center of the coil, was found using the Biot-Savart law: HOIR?N B1 2(R2 + z2)ž
B INSTRUCTION Solve the following problems. ANSWER ONLY TWO OUT OF THREE QUESTIONS. Show your complete solutions. NOT FOLLOWING OF INSTRUCTIONS will be a deduction of 10 POINTS from the total score. 1.A proton enters a magnetic tield of flux density 1.5 Wb/m² with a vetocity of 2.0 x 107 m/s at an angle of 30° with the field. Compute the force on the proton. 2.A steady current of 2 A in a coil of 400 turns causes a flux of 104 wb to link (pass through) the loops of the coil. Compute the average back emf induced in the coit it the current is stopped in 0.08 seconds. 3. A coil of 50 loops is pulled in 0.020 seconds from between the poles of a magnet, where its area intercepts a flux of 3.1 x 10-4 Wb, to a place where the intercepted flux is 0.10 x 10-4 Wb. Determine the average emf induced.