Calculate dimensions and power requirements for Flocculator to treat 30000 m3/d wastewater flow. Flocculator should be 4 m deep and maximum 10 m wide. Use following information: μ = 1.003*10-3 Ns/m2 ρ = 999.1 kg/ m3 CD = 1.8 G*t = 3.5*104 Vp = 0.67 m/s 4paddle,4board configurations

Q: contains a fl gravity of 110 kN/ m² oil of specific der 1.30 anc pressure 170

A:

Q: The diameter of pipe (cast iron) is constant equal to 15 cm and total length of pipe is 180 m. It is…

A: in given question ,  diameter of pipe is 15 cm and velocity at exit is 5 m/sec , hence pipe is…

Q: 4. A discharge is made to a stream as given in the figure. Please calculate minimum dissolved oxygen…

A: we by using stretcher equationDt=KD×LKR-KD10-KDt-10-KRt+DOi10-KRtwhereDt=D.O deficite in mg/l after…

Q: 4. Using the figure below, find the time it takes for tank 2 to increase water level by 2m. (C =…

A:

Q: A single pipe of length 1500mand diameter 60 cm connects two reservoirs having a difference of 20 m…

A:

Q: Calculate the BOD, Initial Sample D.O. = 8.1 mg/L 5-Day Sample D.0. = 2.1 mg/L Vol. Of Sample in 300…

A: The given data is: Initial Sample D.O=8.1 mg/L 5-Day Sample D.O=2.1 mg/L Vol. Of Sample in 300 mL…

Q: A small drop of water at 20°C is in contact with the air and has diameter 0.2 mm. What is the excess…

A: GIVEN Small drop of water  Temperature = 20°C Diameter, d = 0.2 mm = 0.0002 m To Determine Excess…

Q: 10 psig H To Free jet 1 in. dia. 3 ft 2 in. dia. 25.9 ft/s 35.9 ft/s 15.9 ft/s

A: To find out the velocity at Point 2.

Q: QI - A main pipe consist of 4 segments of equal length (500m for each segment), supplying 4…

A: L1=1000 mD1=1 mL2=1500 mD2=0.5 m

Q: A liquid refrigerant (sg = rate of 28.5 Ñ/h. Calculate the volume flow rate. 1.08) iş flowing at a…

A:

Q: A pump with an efficiency of 80% is used to draw groundwater from a well for irrigating a flat field…

A: given- base period B=120 daysdelta ∆=144 cmwater application efficiency=80%

Q: Convert the following air pressure readingsfrom cm H2O to Pa.a. 1.5 cm H2Ob. 3.7 cm H2O

A:

Q: Figure shows a lawn 40 cm sprinkler with unequal arms. The jets issuing out of the sprinkler arm of…

A:

Q: 1. In a test to determine the discharge coefficient of a 50 mm by 12.5 mm Venturi meter the total…

A: Venturimeter is used to measure discharge into pipe. in venturimeter some loss is  occurred due to…

Q: Q.2.19 Figure shows a lawn 40 cm sprinkler with unequal arms. The jets issuing out of the sprinkler…

A:

Q: Water flows through a 28 cm (length) rotameter (Type A) with an internal diameter of 25 mm at the…

A: As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly repost other…

Q: Reservoir A is the source of water supply is at elevation 180 m., B is the junction at elevation 120…

A: Given Data:Reservoir A Elevation =180m                  B Elevation = 120mPopulation of town D =…

Q: Q1: Find the distance Z shown in the Figure below. O=30° {1 Bar=100 (KN/m2) and pw = 1000 (Kg/m³)}.…

A: "Since, you have asked multiple questions, we will answer first two questions for you (because they…

Q: Figure shows a lawn 40 cm sprinkler with unequal arms. The jets issuing out of the sprinkler arm of…

A:

Q: Benzene is flowing in a straight 80 mm diameter UPVC pipe with velocity is 3.33 m/s. Determine the…

A:

Q: Oil of specific gravity 0.802 and kinematic viscosity 0.000186 m /s flows from tank A to tank B…

A:

Q: A = 26.0 degrees, b = 13.33 cm, c = 7.00 cm

A:

Q: The flow from a lawn sprinkler is 140 L/min, B₂ = 180° as shown in the figure below and the total…

A: step 1-

Q: Q.13 Figure shows a lawn 40 cm sprinkier with unequal arms. The jets issuing out of the sprinkler…

A:

Q: Q.10.19 Figure shows a lawn 40 cm sprinkler with unequal arms. The jets issuing out of the sprinkler…

A:

Q: Oil (sg-0.87) flows from A to E as shown. The head loss is assumed to be as follows: A to B = 0.45…

A:

Q: e of water equal to 3.5x10" f water is applied according every 10 dave 4 12 brs ber

A: For 10 days we need 3.5×106m3sVolume=3.5×106m3s×10days×24hrsday×3600sechr=3.024×106m3

Q: Problem 7 - 68 Oil having sp. gr. of 0.9 and viscosity v 0.0002 m²/s flows upward through an…

A:

Q: SITUATION 4. AN OIL WITH SG = 0.86 FLOWS THROUGH A PIPE 30in. IN DIAMETER AT 700gpm 5. Determine the…

A:

Q: Figure shows a lawn 40 cm sprinkler with unequal arms. The jets issuing out of the sprinkler arm of…

A:

Q: Water is transported through a pipe over a distance of 500m. The flowrate is 0.03 m³/s and the…

A:

Q: Water entering through 5 ft long and 1 inch diameter pipe has a flow rate of 100 kg/min at a…

A: Given: Length, L = 5 ft Diameter, D = 1 in Mass flow rate, m = 100 kg/min Temperature, T = 100°C…

Q: Make computations of a ramp pump where the Source Elevation = 50 meters. Target User Elevation = 85…

A:

Q: 20. Determine COLD & HOT capacity of storage tank (m3), for a hospital building having 100 occupants…

A: Given:- The hospital building consists of 100 occupants in a 300 bed The cold water rate demand =…

Q: A lake has a surface area of 50,023 m2 and an overall lake depth of 25.7 m. A single river…

A: below solution is correct

Q: Below, a jet wa diameter of 2 ntaining a hole of diameter 8 cm. A portion ed towards the…

A:

Q: Q.11.13 Figure shows a lawn 40 cm sprinkler with unequal arms. The jets issuing out of the sprinkler…

A:

Q: Q3: In venture meter, the volume water through 10 second is 500ml.the total head of water for points…

A: Given :

Q: Q.13.4 Figure shows a lawn 40 cm sprinkler with unequ 1 arms. The jets issuing out of the sprinkler…

A:

Q: A horizontal venturimeter 9 cm x 4 cm is installed in a 9 cm water pipe. A differential…

A:

Q: 1- Calculate the steady discharge (Q) and the power consumption (P) for a pipe connected between two…

A:

Q: Determine the discharge in gallons per minute of water through a 50 mm wrought iron pipe (f = 0.025)…

A: As per Darcy Weisbatch equation, head loss through a pipe is given by, HL=4flv22gd HL=82 KPa=82×1000…

Q: If a 136.51 g Al rod (c=0.900 J/g°C) is at 100.0°C and placed into 250.0 g of water at 21.8°C, what…

A: Given: The mass of the Al rod is 136.51 g. The specific heat of the Al rod is 0.9 J/ g°C. The…

Q: 1. Water flows in a 400 mm diameter pipe at the rate of 500 liters per second. The pipe has a length…

A:

Q: O Solids - Volumes an... G Gmail 2 Google Drive Yahoo A pump draws 24 liters per second of water…

A: This is a bernoullis eqn based problem. Apply bernoullis eqn at C and 1.THE PRESSURE HEAD CAN BE…

Q: Q.19 Figure shows a lawn 40 cm sprinkier with unequal arms. The jets issuing out of the sprinkler…

A:

Q: Design the pipe that will connect two reservoirs for a water distribution system of a certain sitio.…

A: Head Loss - When water flow from source to its end point in a pipe it follows Energy Equation i.e…

Q: Water is transported through a pipe over a distance of 500m. The flowrate is 0.03 m³/s and the…

A: GIVEN DATA:-⇒diameter (d)= 100 mm or 0.1 m⇒distance (L)= 500 m⇒Flowrate (Q)= 0.03 m3/s⇒Pressure drop…

Q: Example 8.2. The head of water over the centre of an orifice of diameter 30 mm is 1.5m. The actual…

A:

Q: Water flows steadily through the large tanks shown in the figure below. Determine the water depth…

A: Given data  da=0.03 mdb=0.05 mhb=2 m

Integrated Solid Waste Management

Integrated Solid Waste Management (ISWM) is a thorough waste suppression, compost, removal and recycling Program. An effective ISWM system considers how to suppress, manage and recycle solid waste in a manner that is most efficiently to protect human health and the surrounding. ISWM system requires evaluation of public wants and demands and then selecting and merging the most effective waste management activities for the proposed demands. The main ISWM activities for solid waste management are Waste prevention, Recycling and Composting, and Combustion and Removal and waste collection in a properly planned, constructed, managed and mitigated landfill areas. Each of these requires careful designing, financing, accumulation, and delivery of activities.