Answered: An RL circuit has a resistance of 20…

An RL circuit has a resistance of 20 ohms, and inductance of 1.5 H and applied emf of 12 volts, and an initial current of 6 amperes. FInd the current in the circuit at any time t.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: Q2) For the circuit in the figure, the capacitance is 0.5, the resistor is linear with v-i…

A: It is given that the resistance has a linear characteristic v=2i. So we have vi=2. And by ohm's law…

Q: Electrical Engineering --question 1-- Calculate the theoretical voltages across the resistor and…

Q: 10. The sketch (right side) shows a simple RC circuit. The capacitor is initially uncharged, and at…

A: (a) In the given RC circuit, The capacitor will be entirely depleted and the potential value across…

Q: Consider the R-C circuit. we idealise the emf to be constant and have zero internal resistance. We…

A: as stated, the capacitor is initially not charged. and it is conneced in series with the resistance…

Q: R1 = 82 SW1 + 18V C = 1/6F R2 = 122

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: A 12 volt battery is connected to a series circuit in which the inductor is 12 henry and the…

Q: In the circuit shown in Figure, the switch is activated at t = 0 s for position 2 of position 1,…

A: Case 1: When switch is connected to position 1 Although it is given that switch is connected to…

Q: A series RLC circuit has a resistance of 20 ohms, a capacitance of 102 Farads, an inductance of 10…

A: In the question, A series RLC circuit, Resistance R= 20 ohm Inductance L= 10H Capacitance C= 10-2 F…

Q: a series circuit consisting of a resistance r an inductor l and a capacitor c, is connected to a…

A: We will apply KVL in loop to find diffrential equation relating current in RLC series circuit.…

Q: An RC circuit has an emf of 5 V, a resistance of 10 ohms, a capacitance of 10 – 2 F, and initially a…

Q: Design a single circuit element containing one inductor, one capacitor and one resistor with v(t) of…

A: Steps: Possibilities of elements are Resistor, Inductor, and Capacitor Since voltage contains a dc…

Q: For the three circuits given in the figure, the source voltage is sinusoidal with a peak value of 1V…

A: Given the three circuits as shown below: For the three figures, it is provided with a sinusoidal…

Q: 200-volt electromotive force is applied to an RC series circuit in which the resistance is 1000 ohms…

Q: In this problem you will calculate the inductance of an inductor from a current measurement taken at…

Q: Draw the inductance and resistance voltages on an oscilloscope screen in accordance with their…

A: The formula for Ohm's law mentioned in the last line is incorrect. The actual formula is V=IR. The…

Q: RC circuit equation Suppose a battery with voltage V is con- nected in series to a capacitor (a…

A: a) I'(t)+I(t)RC=0dIdt+I(t)RC=0 Arranging them, dII=-dtRC∫dII=∫-dtRCln…

Q: Q1/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

A: In this network shown as per given question, Initial switch at position a for long time. At the…

Q: Given a series RC circuit that has a resistance of 12MΩ and a capacitance of 47µF, and attached to a…

A: Given : a series RC circuit what will the voltage drop across the capacitor be when 5 time…

Q: Suppose that at t=0, we connect an uncharged 10{μF capacitor to a charging circuitconsisting of a…

A: Given values are = Initially, We connect an uncharged 10μF capacitor to a charging circuit…

Q: A resistance of 20 Q and an inductance L are connected in series with a constant voltage of 100V.…

Q: With reference to the source voltage, show the values of v, i, vr, vc in the time plane, the phasor…

A: The impedance for capacitor is written as -jXc where Xc=1ωC and ω=2πf. The total current is the…

Q: Rs Vs R2: Figure P5.47 8 For the circuit of Figure P5.47, assume Vs 100 V, Rs = 4 k2, R¡ = 2 k2, R2…

A: To find the voltage across capacitor (vc) of the following circuit:

Q: For the network shown in figure (Q1), the switch has been in position "a" for a long time. At t-0,…

A: Initial Switch at position a Before time t=0 For long time, inductor act as short circuit. At…

Q: A 100- volt electromotive force is applied to an RC series circuit in which the resistance is 200…

A: Given

Q: 2) An inductor L and a capacitorC=1 µF are completely discharged and used to build up the circuit in…

A: For t=0, the switch is connected to position 'A' for a long time. In this position of the switch,…

Q: 10. In the figure, suppose the switch has been closed for a time interval sufficiently long for the…

A: The voltage across a capacitor will not change suddenly unless an impulse source is applied. Under…

Q: 5. RC Charging Circuit is shown in the figure. Find the differantial equation and its solution of…

A: By applying KVL, V=RI+ 1/C ∫I dt By differentitaing, 0=R dI/dt+ IC 0=R dQ/dt + Q/C dQ/dt et/RC +…

Q: The circuit shown in the figure consists of ideal batteries ɛ, =20V and E2 =20V, resistors R =6002,…

A: Given circuit, Now, E1+E2-qc+qc-iR=040-2q10mF-dqdt×600=0 By solving above equation, q=q01-e-tς…

Q: If a circuit consisting of a resistor and induction in series has a DC current of 500mA following…

Q: when there is in a circuit both of the inductor and the capapcitor, why no need for the inital…

A: When an inductor and a capacitor are connected in series, the inductor acts as a short circuit,…

Q: Q.15: The switch has been in position "a" for a long time. At t=0 the switch is moved to position…

A: In an electric circuit the transients are due to energy storing elements. Since the energy store in…

Q: 5.56 The circuit of Figure P5.56 is used as a variable delay in a burglar alarm. The alarm is a…

A: Draw the circuit just after the switch is closed.

Q: An 8 μF capacitor is a 200 V DC in series with a 0.5 MΩ resistor linked to the source. According to…

A: Given data: C=8×10-6 μF Vs=200 V R=0.5×106 Ω Solution: Note: As per our policy, I have attempted…

Q: 4) The arms of a four an arm bridge a, b, c and d supplied with a sinusoidal voltage have the…

A: In this question we need to find value of R2 and the frequency at which bridge is balanced

Q: V R2 ww R1 C1

Q: 16. Consider a simple RC circuit which has a resistor of 2 ohm and capacitor of 3F. If the initial…

A: We are authorized to answer only one question at a time since you have not mentioned which question…

Q: Q2) The uncharged capacitor in the circuit shown in figure is initially switched to terminal (1).…

A: we gave given in circuit;input voltage V=400Vresistance respectively R1 and R2 are 100kΩ…

Q: Q.15: The switch has been in position "a" for a long time. At t=0 the switch is moved to position…

Q: A circuit containing a 10 Ohms resistance is in series to 250 microFarad capacitance with a source…

A: Circuit will reach steady state in 5T sec where T is time constant in seconds. For RC circuit time…

Q: ** 18. The following questions refer to the circuit represented by the diagram at right. Think of R,…

A: According to the question we have to calculate, a) Immediately after the switch is closed,…

Q: An RL cireuit (with L-0.8 H) has the following VR(t) response to a square wave. The VOLTS/DIV and…

A: Series RL circuit

Q: Using a simple series circuit with a capacitor of capacitance C and a resistor, R connected across a…

A: Intial condition :- Capacitar is uncharge,VC(0-)=0 voltWhen switch is closed- or, when supply is…

Q: A resistor of resistance 20 ohms is in series with an inductor of inductance 2H. At t = 0, it is…

A: Given data Resistance is R = 20 ohms Inductance is L = 2 H Source voltage is Vs = 50 V Expression…

Q: An RC circuit has an emf of 100 volts, a resistance of 5 ohms, a capacitance of 0.02 farad, and an…

A: 1st we will find out voltage across the the capacitor then we will find out the charge on capacitor…

Q: An RC circuit has an emf given (in volts) by 400 cos 2t, a resistance of 100 ohms, and a capacitance…

A: The Kirchhoff's voltage law in the loop is given as: Rdqdt+qC=Edqdt+qRC=ERdqdt+q100 Ω10-2 F=400cos2t…

Q: Q.15: The switch has been in position "a" for a long time. At t-0 the switch is moved to position…

A: Given: The switch has been in position "a" for a long time. At t=0 the switch is moved to position…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

An RL circuit has a resistance of 20 ohms, and inductance of 1.5 H and applied emf of 12 volts, and an initial current of 6 amperes. FInd the current in the circuit at any time t.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Using the series circuit in Figure 3 consisting of a voltage source V, the resistor R and the fully uncharged capacitor C, how to find the value of the capacitance C considering as known data the time constant of the circuit T and the value of the resistor R? V ww R
Problem 3 -10t The current flowin through a 5 H coil is given by 12e7 A. Find an expresion for the voltage, power, and stored energy. Sketch the waveforms to scale for the current, voltage, power, and energy from t = 0 to t = 500 ms.
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from an 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA.
A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the final value of current, the value of current after 4 ms, the value of the voltage across the resistor after 6 ms, the value of the voltage across the inductance after 6 ms, and the time when the current reaches 15A.
For the circuit below, determine the current in each branch and the potential difference in the inductor immediately after switch S isclosed. After a long time the switch S is then opened. What are the currents in each branch and the potential difference in the inductor at that moment?
A resistance and inductance are connected in series in a circuit containing an impressed voltage of 100V. The differential equation of E = Ri + Ldi/dt. Find the current when t=0.02s if R = 10 ohms and L = 2 henry.
5. An alternating current bridge is arranged as follows: The arm BC and DA consists of non-inductive resistance of 800 Q each. A balance is obtained when resistances of the arms DE and CD of non-inductive variable resistances of 200 N, 1k n respectively. The arm EC of a capacitor of 1 µF capacitance. The alternating current source is connected to A and C and the telephone receiver to B and E. Calculate the resistance and inductance of arm AB. Also find Q factor, when supply frequency is 1500HZ.
An R-C series circuit has a supply voltage of 100 V. The resistance is 200 ohms and the capacitance is 0.0001 Farad. Solve for the current "i" at any time "t". Solve for the charge "q" at any time "t".
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.
A resistance of 12 ohms and capacitance of 0.01 farad is connected in series with a 200 volts battery. Find the charge after 0.5 second and the current after 0.4 second