For the three circuits given in the figure, the source voltage is sinusoidal with a peak value of 1V and a frequency of 80HZ. is the sign. OFor these circuits, a) the inductance VL voltage for the circuit b) the resistance VR voltage for the circuit and c) By analytically obtaining the time domain solution of the capacitor VC voltage for the circuit Write your statements clearly. B) Obtaining solutions for the initial conditions of the circuits for IL(t=0)=0.1V and VC(t=0)=0.2V Write the expressions. C) Discuss the similarities of the voltages VL, VR, and VC. D) Discuss the differences in the time variation of the instantaneous power dissipated on L, R, and C.

For the three circuits given in the figure, the source voltage is sinusoidal with a peak value of 1V and a frequency of 80HZ. is the sign. OFor these circuits, a) the inductance VL voltage for the circuit b) the resistance VR voltage for the circuit and c) By analytically obtaining the time domain solution of the capacitor VC voltage for the circuit Write your statements clearly. B) Obtaining solutions for the initial conditions of the circuits for IL(t=0)=0.1V and VC(t=0)=0.2V Write the expressions. C) Discuss the similarities of the voltages VL, VR, and VC. D) Discuss the differences in the time variation of the instantaneous power dissipated on L, R, and C.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Similar questions

1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
A chopper circuit has an inductive load of 2ohm resistance and 10mH inductance. If the source voltage is 20 V and the frequency of the chopper is set to 100Hz and the on-time to 5 ms. Determine the average voltage and current, maximum and minimum load currents.
4) Determine the value of voltage across resistor and capacitor5) Convert in rms values
please solve value of Capacitor with 0.1V Ripple. And draw output ripple waveform. Explain it one by one for me thanks..
1.Enumerate five formulas for four series connected capacitances across Vt source and draw the circuit. 1. Enumerate five formulas for four parallel connected capacitances across Vt source and draw the circuit.
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV
A capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open, the plate to the left of the capacitor has charge "Qo". The switch is closed the load and current vary sinusoidally with time. Represent graphically the load "Qo" and the intensity of current "I" as a function of time "t", and explain why the current leads the load by a phase difference of 90°.
Determine and sketch the output voltage waveform for the circuit shown if the sinusoidal signal at the input has a peak-to-peak voltage of 30 volts with V=5volts. Identify the circuit.
Find the DC value and RMS value from this image in below. , I want the solution in a detailed picture with a white paper and a clear font. Thank you.
Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of 5kohms in series with a capacitor of 10 nanofarad is connected across a 16v sinusoidal supply. Calculate the output voltage at a frequency of 60Hz and again at frequency of 120Hz. This is the example/guide that might help.