Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE.Note!SHOW YOUR COMPLETE SOLUTION NEATLY AND IN ANORDERLY MANNER. A series RLC circuit has a resistance of 20 ohms, a capacitance of 10² Farads, an inductance of 10Henrys, and an applied voltage of 110 cos 10t volts where tis time in seconds. Assuming no initial currentand charge when voltage is first applied, find the subsequent current in the system.

In the question, A series RLC circuit, Resistance R= 20 ohm Inductance L= 10H Capacitance C= 10-2 F…

A series RLC circuit has a resistance of 20 ohms, a capacitance of 102 Farads, an inductance of 10 Henrys, and an applied voltage of 110 cos 10t volts where tis time in seconds. Assuming no initial current and charge when voltage is first applied, find the subsequent current in the system.

A series RLC circuit has a resistance of 20 ohms, a capacitance of 102 Farads, an inductance of 10 Henrys, and an applied voltage of 110 cos 10t volts where tis time in seconds. Assuming no initial current and charge when voltage is first applied, find the subsequent current in the system.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: A coaxial cable used in a transmission line responds as a distributed capacitance to the circuit…

Q: Q1 (True/False): A) The current through the capacitor is inversely proportional to the derivative of…

Q: 7. Calculate the gravimetric capacitance of a carbon-based electrode with an aqueous electrolyte…

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: Q1/ An impulsive voltage E is applied at t=0 to a series circuit containing inductance L and…

A: Laplace transform allows one to write differential equations in the time domain as linear algebraic…

Q: A ceramic capacitor is to be constructed to have a capacitance of 0.01µF and to have a steady…

A: Given: C=10 micro farad V=2.5kv E=10 meha volt per metre

Q: Assignment No. 5 Inductance, Capacitance, and Mutual Inductance Problem 5.1 The current in a 150 µH…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: A capacitance of 5 uF, if the current given in the graph below is applied, what would the voltage on…

A: Voltage across capacitance C=5uF At t=30us

Q: Use MATLAB to generate a plot of this charge as a function of time, where t = time = 0 to 0.8, qo =…

A: clc;clear;close all;t=0:0.001:0.8;qo=10;%intial…

Q: The capacitance of a multi-layer parallel plate electrode system is 4.25 picofarad Sum of the…

A: Let the absolute permittivity, relative permittivity and permittivity of free space be ε, εr and εo…

Q: A parallel plate capacitor of capacitance Co has plates of area A with separation d between them.…

Q: An RC circuit with a capacitance of 5⋅10-2 farad, and a resistance of 4Ω, has an EMF of E(t)=…

Q: Q3) an LRC circuit is set up with an inductance of 1/5 henry, a resistance of 1 ohm, and a…

A: For a series LRC circuit with L=15 H, R=1 Ω, C=56 F; the capacitor has an initial charge of q0=2 C…

Q: The capacitance of a multi-layer parallel plate electrode system is 4.25 picofarad. Sum of the…

A: Let the required area be A Absolute permittivity across any dielectric= ε ε=εrεo.......(where εr and…

Q: A circuit supplied by 8V, 50HZ, is shown in Figure C5 below, is used to find the unknown value of…

Q: Suppose a capacitive touch screen that uses the mutual-capacitance design, as shown, is touched at…

A: Given mutual capacitance at a point (x , y) without a touch is C’mxy Mutual capacitance with touch…

Q: Suppose that R = 444 kN and C = 722 µF in the circuit shown below. After the switch on, at t=0,…

A: We know the capacitor voltage formula for RC circuit .we will find out time for given capacitor…

Q: 1. A cylindrical capacitor is formed using two different circular metal plates and a dielectric…

A: Given parameters: A parallel plate capacitor with two circular plates Dielectric constant, k For…

Q: The voltage across a capacitor in a series RC circuit is given by the equation vc = 250(1 – e-25t)…

Q: Problem 8. A waxed paper capacitor has two parallel plates, each of effective area 800 cm². If the…

Q: A- The current flowing through an inductor is given by i(t) = 3+21 A and the voltage across it is 24…

Q: c) An ac bridge was made up as follows: arm ab, a capacitor of 5µF in parallel with 20k2 resistance,…

Q: Prob 1. Given a parallel plate capacitor with parameters E, = 2, d = 3 nm and A = 1 mm². a. Find the…

A: An arrangement of electrodes and an insulating substance or dielectric constitute parallel plate…

Q: (a) A parallel plate capacitor consists of plates with area of cross section of 280 cm², (1) What is…

A: From the Parallel Plate Capacitor...

Q: Rs ww (+) Rp ww

Q: A resistance of 10 ohm, an inductor of 300 mH and a capacitor of 50 uF are connected in series. If…

Q: Consider an LRC series circuit with a resistance of 2.5 ohms, capacitance of 0.1 farad, an…

Q: If a current i(t)=5sin(10t) mA flows through an inductor of inductance L=10 H, then find out the…

A: Method 1:It is known that current flowing through the inductor is a sinusoidal wave. It can be…

Q: 100 µF 15 mA 6 kO 0.3 H 60 mH 24 V 250 µF 3 k2 4 kO 2 ΚΩ

Q: Compute the equivalent capacitance of the network

Q: In the RC circuit shown in below, the battery has fully charged the capacitor, so Q0 = C%. Then at t…

A: Given ε =20 VC =1.02 μF

Q: The differential equation for the instantaneous charge q(t) on the capacitor in LRC-series circuit…

Q: HA A coaxial capacitor with inner radius 5 mm, outer radius 6 mm and length s00 mm has a dielectric…

A: To find the displacement current, we need to know E in the dielectric space between the cylindrical…

Q: Q.6: For the circuit shown beside, the switch in position "1" for long period enough for…

Q: capacitor consists of two circular plates of radius a separated by a distance d (assume d a. (A)…

Q: The capacitor is discharged through a resistor with the resistance R = 10000 Ohm with a relaxation…

Q: and Cd = 10 µF. If Cb and Cc are connected in parallel and the parallel combination is connected in…

Q: A parallel-plate capacitor was measured to have a capacitance of Co. What would be the new…

Q: PROBLEM 2: In the circuit shown, capacitor C1 has an initial charge qo = 300 × 10-6 Coulombs. If the…

Q: 4. When a capacitor, charged to a p.d. of 300 V, is connected to a voltmeter having a resistance of…

Q: A paper dielectric plate capacitor is to be experimentally tested. The metal plates and the paper…

Q: Att<0, a 360-nF capacitance is charged to an unknown voltage Vj. The capacitance is in parallel with…

A: Applying KCL at node gives diffrential equation in terms of capacitor voltage. Solving differential…

Q: Given an initially charged capacitance that begins to discharge through a resistance at t=0, what…

A: The given capacitor is initially fully charged. The charge that will remain on its plate after the…

Q: C a R The switch is placed at position a. The capacitor is being charged. The switch is placed at…

Q: 3V 20 HH 20

A: find the relation between qK , qL, qM...?

Q: What is the potential energy of a capacitor if it's connected to a 20V power supply, and has a…

A: 1) Given Power supply of 20 vCapacitor of 20 μF

Concept explainers

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.

Question

Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE.

Note!
SHOW YOUR COMPLETE SOLUTION NEATLY AND IN AN
ORDERLY MANNER.

A series RLC circuit has a resistance of 20 ohms, a capacitance of 10² Farads, an inductance of 10
Henrys, and an applied voltage of 110 cos 10t volts where tis time in seconds. Assuming no initial current
and charge when voltage is first applied, find the subsequent current in the system.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A series circuit consisting of 10 ohm resistance and 60 mH inductance is connected to a 220-volt, 50-hertz source. Determine the voltage drop across the inductance.
Consider the Capacitance = 10uF, Vpeak of +13v during the positive half cycle and -7v during the negative half cycle. If we have a charging time of 18ms, calculate the Forward Resistance of the circuit in ohms. Calculate the Vout during the negative half cycle. Calculate the Vout during the positive half cycle. Calculate the Discharging time of the circuit in seconds.
Describe the behavior of the voltage across the resistor with time as thecapacitor charges. Explain the reason for this behavior.
A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the final value of current, the value of current after 4 ms, the value of the voltage across the resistor after 6 ms, the value of the voltage across the inductance after 6 ms, and the time when the current reaches 15A.
QUESTION 5 A 20 ohms resistor is connected in series with a capacitor of 0.01 farad and an emf in volts given by 40e-3¹ +20e-6. Assuming that the charge and current on the capacitor are zero at t=0, determine the charge and current at any time.
Calculate capacitance Cand voltage U over resistance. What is the peak value of resistance's voltage? Voltage source e(t) = ésin(wt + 45°). Resistance R-50, circuit's total reactance X-50, inductance L =50mH, ê -40V and frequency f =50Hz. R L Give the answers to one decimal place. Do not write numbers in the complex number form! Absolute value of voltage source (RMS value): V Total impedance of circuit (absolute value): Capacitance: μF Absolute value of current (RMS value) supplied by voltage source: Phase angle of current: degrees Peak value of resistances voltage: 22 A
A resistance of 20 ohms and an unknown capacitance are connected in parallel to a 110-Vac, variable frequency source. When the frequency is 60 Hz, the current drawn by the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A.
give definition and explanation about Capacitance meter
The network Nc shown below in Figure 1.99(a) contains a combination of scaled capaci- tors in series and parallel connections. Using the vahues as shown, you are asked to do the following. (a) Calculate the value of the terminal capacitance Cab at terminals a-b. (b) To obtain an equivalent capacitance Ceq of 1.5F, Nc is to be placed either in series with a capacitance Cz as shown in Figure 1.99(b) or in parallel with Cx as shown in Figure 1.99(c). Determine which connection is correct and calculate the value of C; that will produce the value of 1.5F for Ceg- 4F 2F 3F 1F C OF (a) N. N. 2. (b) (c) Figure 1.99 (a) Capacitor combo Nc (b) Nc in series with C, (c) Ne in parallel with C,