An alternating voltage is given by v=120 sin(320t + p) volts. Find (i) RMS value (ii) frequency. (iii) Phase angle () in degrees if the instantaneous value is 30 V at t 18 ms. (iv) Instantaneous value of voltage for the equation 120 sin(320t) at 18 ms. (v) Draw the waveform for the equation 120 sin(320t) at least one complete cycle showing important points.

Q: The following signal with maximum value of 1. Determine: a) Instantaneous value at t= 1800 ms. b)…

A:

Q: The average value of sinusoidal varying voltage is less than its r.m.s. value. Select one: O True O…

A: Given  Average of sinosoidal waveform is less then rms value True of false

Q: The average value of a sinusoidal current is 100 A. Its r.m.s. value is ............ (1) 63-7 A…

A: Given: Average value of a sinusoidal signal is Vavg=100 A.

Q: An alternating voltage has an average value of 6.5V and a period of 8ms.   Write down the equation…

A: Time Period T=8 ms = 0.008 s.The average value of a complete sinusoidal wave is 0. But over half a…

Q: (c) Write down the equation for a sinusoidal voltage of 50 Hz and its peak value is 20 V. Draw the…

A:

Q: A sinusoidal AC voltage source has the equation, e=311sin377t, find the maimum voltage Rm, the RMS…

A: The solution is given below

Q: A supply voltage has a mean value of 150V. Determine its maximum value and its rms value.

A: Given, Mean voltage of a supply, Vavg=150 V.

Q: An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

A:

Q: VT (V) IT(mA) RT (2) 10 9.7 V (V) V1=2.1 V2=3.2 V3=4.6 EV= R (2) I-V/R (mA) 220 I1= 12 13 330 470…

A: We will use ohm's law to calculate various unknown values and this fill the below table accordingly.

Q: For the circuit shown in the figure, A. If A = 8.0 s and B = 15.2 s, the average value of current is…

A: The RMS (Root Mean Square) value of a current waveform is a measure of the effective or equivalent…

Q: H.W: A sinusoidal waveform, 3v2cosw,t, is added to a second 4v2coswzt, determine the rms value of…

A: Part (a): When the angular frequencies for both the sinusoidal waveform are equal, these signals are…

Q: v(t)' +20V A1 12 6. 10 11 -5v

A:

Q: 4. The AC generator in the circuit shown below supplies voltage with amplitude 5.0 V at frequency…

A: Given V=5 V f=336 Hz

Q: 1. An alternating current varying sinusoidally with a frequency of 50Hz has an RMS value of 2OA. (i)…

A:

Q: 2. Determine the rms value for each of the waveforms shown in figure below. (a) e (V) hour 2 2 5 7…

A:

Q: A voltage waveform is given in volts as: v(t) = 0.06 sin (6500t-61⁰) 1. Calculate the RMS value of…

A: "Since you have asked multipart questions, we will solve the first three question for you. If you…

Q: supplies

A:

Q: An alternating voltage, v, has a periodic time of 20 ms and a peak value of 80V. When time t=0, v…

A:

Q: Л Ч -5 i(t) mA 10 Sinusoidal 5 10 15 1 (us)

A:

Q: A harmonic analysis of the current drawn by a CFL yields the following data. Find the rms value of…

A: We have an data of CFL lamp with harmonics as shown in table and corresponding currents of that…

Q: Average value of a sinusoidal voltage over a complete full cycle is . a. 2n V m b. (Vm) / Tt C. Zero…

A: Average value of a sinusoidal voltage is 0 as positive half and negative half cancel out each other

Q: An alternating current varying sinusoidally with a freq. of 50 c/s. has a r.m.s. value of 35 A.…

A:

Q: (5 minutes) A sine voltage signal is zero at t = 0.1s, and increasing to the succeeding zero at t =…

A: Given, Sine voltage signal with zero at t=0.1 s And increasing to the succeeding zero at t=0.3 s

Q: Suppose I have two peak phasor voltages, V, = 100245° and V, = 75Z-60°. Circle Your Choices: The…

A: In this question we will find RMS value , frequencies etc of given phasor...

Q: 5. What is the phase relationship between the sinusoidal waveforms given below for voltage and…

A: 5.The pair of voltage and current waveforms are given bya. v(t)=6sin(ωt−60∘) .i(t)=3sin(ωt+15∘)…

Q: Derive the formula for the RMS value for the following a)

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: Segments of two sinusoids are shown in the plot below. Determine the phase difference between the…

A:

Q: (c) State the relationship between the three waveforms in terms of leading or lagging phase. (d)…

A:

Q: RMS value of 20A. (i) Write down the equation for the instantaneous value (ii) find the value of (i)…

A: In this we will write current equation..

Q: Two ac generators supply the same voltage. However, the first generator has a frequency of 1.2 kHz,…

A:

Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm…

A: Please refer the attached images for the complete answer..

Q: A series circuit consisting of 17ohm resistance and 20mH inductane is connected across a 220V(RMS)…

A: The solution is given below

Q: Calculate the rms value of each of the following: (a) v(t) = 5 + 3 cos(10t +30°) V (b) 10°) A i(t) =…

A: (a) vt=5+3cos10t+300. (b) it=-3+7sin8t-100 A. (c) vt=15 V.

Q: Determine the rms value for each of the waveforms shown in figure below.

A: The root mean square value of any function represents it's effective value affecting the working…

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.