Two ac generators supply the same voltage. However, the first generator has a frequency of 1.2 kHz, and the second has a frequency of 5.7 kHz. When an inductor is connected across the terminals of the first generator, the current delivered is 0.15 A. How much current is delivered when this inductor is connected across the terminals of the second generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. Number MI Units 42 0000 Vo sin 2x f₁t Circuit 1 4 121 0000 Vo sin 2x f₂t Circuit 2

Two ac generators supply the same voltage. However, the first generator has a frequency of 1.2 kHz, and the second has a frequency of 5.7 kHz. When an inductor is connected across the terminals of the first generator, the current delivered is 0.15 A. How much current is delivered when this inductor is connected across the terminals of the second generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. Number MI Units 42 0000 Vo sin 2x f₁t Circuit 1 4 121 0000 Vo sin 2x f₂t Circuit 2

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
2, In a circuit, the capacitance of a capacitor is 3.2 microfarads and the rms voltage of the generator is 50 volts. Frequency (a) 100 Hz and (b) what is the rms current in the circuit when it is 1000 Hz?
The ripple factor for pure dc is Answer:
what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
An alternating current varying sinusoidally with a frequency of 50 Hz has anrms value of 20 A.a) Determine the instantaneous value at 0.0025 seconds.b) Determine the instantaneous value, 0.0125 seconds after passingthrough a positive maximum value.c) At what time, measured from a positive maximum value, will theinstantaneous current be 14.14 A?
The rms value of the voltage in a 60 cycle circuit is 115 volts. write the equation for the sinusoidal wave
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
In DC choppers the wave forms for input and output voltages are respectively a. both discontinuous b. discontinuous,continuous c. both continuous d. continuous,discontinuous
2.14 The current waveforms of la capocitov are avesage peak cursend *atings of 1, =500 A of shown in Fiquse Determine square (rms), and capacitor. Assume, The root mean half sine -wave t = loo us -300 AS t3 Soo Ns f, -250HZ T2 200
The below figure shows the waveform of the voltage and current in a purely inductive AC circuit. Voltage Current Using the voltage phasor as the reference, the current phasor Lags by 90° Is in phase with the voltage Leads by 90° Lags and then leads by 160°
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…