Answered: A sinusiodal voltage having maximum…

A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resistor. Find the rms value of current in the resistor. (Unit: A) Submit Answer

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: (a) In a satellite communication, the power delivered to a matched receiver, P, is given by the Frii...

A: Note: We are authorized to answer one question at a time since you have not mentioned which question...

Q: 4. Consider the data below From (bus) To (bus) x (inductance) B (susceptance) 1 2 0.25 1 4. 0.4 1 0....

A: Given The data flow From(bus) To(bus) X(Inductance) B(susceptance) 1 2 0.25 1 4 0.4 1...

Q: Q3 / calculate the voltage across AB in the network shown in fig.(3) and indicates the polarity of t...

Q: Find vo using Superposition in the circuit:

A: Here, we have given an electrical circuit having no. of resistors, one voltage source and two curren...

Q: R1 R2 1K 0.33K A + R3 E1 0.5K 9V

Q: sketch the output waveform. show complete analysis.

A: The given circuit is a biased negative clamper.During the positive half of the input, the capacitor ...

Q: Q5 / Find the current in the 20 resistance of the network shown in fig.(5) 2V 4V T 3 12V lovT Les

A: A mesh is defined at a loop which does not contain any other loops within it. To app...

Q: Form graph shown below. Drive the energy as a function of time. If the resistance 10k2 Charge (C) Ti...

Q: A thyristor controlled Full Wave rectifier outputs 400 Vdc when fired at an angle 0 deg. Find the an...

A: To solve above problem, one should know what rectifier circuit is and how it works. To charge a batt...

Q: A certain communication system is composed of 16 different symbols or messages. The probability of e...

A: According to the question, the probability of he 16- different messages are given as M1– 1/128 M...

Q: 2. A current source in a linear circuit has is = 8cos(500nt – 25°) %3D (a) What is the amplitude of ...

Q: Assuming a rate of 3 cents per kwh,how much will I pay for the loss with 7657.8881 watts due to the ...

A: The solution is given below

Q: 5. a. Convert the following expressions into a sum-of-products (SOP) form: (A +B)(C+B) (A +BC)C b. C...

Q: A. Two inductors whose self-inductances are given as 75mH and 55mH respectively, are positioned next...

A: In this question ,inductance related questions are given......We have to find out mutual inductance ...

Q: Find out Z transform of y (n) = a"u(n)

A: Given function, yn=anun

Q: Q4:A. Design common-base configuration circuit. IE= 1.3 mA and Av= 250.

A: The Common Base Amplifier is a bipolar junction transistor (BJT) architecture with a common base ter...

Q: The following results were obtained from the No-load, Locked-rotor and Stator Resistance tests perfo...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: b. Q =-3KVAR ,P = 5kW %3D Determine the Complex Power, Apparent Power, Current, Voltage and Power fa...

A: (b) It is given that: Q=-3 KVArP=5 KW

Q: Nos. 1 and 2: Sketch the output waveform. Show your complete analysis. 1. R E 2. +Vipi R { vo Vi SIT...

A: Solve the problem

Q: Calculate the output voltage v, for the given ideal OP-AMP circuit. 10k 2 9+15V 5kΩ 2V -15V

A: Given circuit is :

Q: a 3phase,4-pole,24slots alternator has its armature oil shot pitch by one slot. its pitch factor wil...

Q: R1 R2 1K 0.33K A R3 + 0.5K Е2 9V

Q: 3. The diagram in Figure P2.1 shows the electrical connection of two devices. The current ix and the...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: QIU Form graph shown below. Drive the energy as a function of time. If the resistance 10ka Charge ) ...

A: The graph given is shown below: R=10kΩ

Q: Use Thevenin's theorem to find the current flowing in the 142 resistor of the network shown in the f...

A: Please find the detailed solution in below images

Q: Q5 / Find the current in the 20 resistance of the network shown in fig.(5) 4V T š 12V lovi les 6V

Q: Find out Z transform of y (n) = a" u(n)

A: This question belongs to signal and system . It is based on z transform of discrete unit step signal...

Q: Apply DeMorgan's Theorem to the following expressions 1. ((A + B)' + C')' 2. ((A' + B) + CD)' 3. (A ...

A: In this question we need to apply Demorgan theorem in the given expression.

Q: A coil has X, = 1000 Q and 5 N internal resistance. Its Q is equal to ?

A: The quality factor of an inductive coil is given by : Q = XL/R

Q: What is the output waveform of the circuit? 100 uF PT1 PT2 12V 220 V/60 Hz/0 Deg 1k Ohm 5 V Select o...

Q: In Fig. 35.15, the d.c. level of Ig is (tran- sistor is of silicon) B = 90 %3D RB 240 k2 RE 2 k2 VEE...

Q: In an AC to DC rectifier circuit, the output DC signal of the rectified wave was measured to be Vpc=...

A: AC to DC rectifier- A rectifier circuit convert AC into DC form with the help of four diode system i...

Q: For a three-stage system with an input power Pin= -10dBm and power gains of the three stages as Ap1=...

Q: ΗW Determine the current I in circuit shown in Fig. 102 10v 6A 102 12 30 42 24v

A: In this question we need to find a current i we use source transformation to find the current i.

Q: R2 560N R1 R3 2200 3300 V1 12V R4 3300 R5 1k0

Q: A 5-hp 230-volt shunt motor takes 18 amp when operating at full load. The shunt field resistance is ...

Q: RIXC A resistor of resistance R=1000 2 is maintained at 17 °C and it shunted by 100 uH inductor. Det...

A: we have given A resistor of resistance R=1000Ωtemprature T=17o=17+273=290kshunted inductor L=100μHso...

Q: 1. Calculate the following performance quantities for the low frequency response of an amplifier cir...

A: Given the circuit, as shown below: We need to calculate: a) Critical frequencies for the input RC c...

Q: E 10V Given: R= 2 kN D1.Si, rg = 2 0, rR = 220 kn R3 = 6.8 kn D2:Si, rg = 5 0,r = 560 kN R2 = 1.2 kn...

A: We need to find out the current and voltage for given circuit.

Q: 50kVA, 13200/240V 60Hz

Q: Q\Design a decade Counter as an Asynchronous Counter

A: Please refer the attached images for the complete answer..

Q: For the given network diagram find the current and voltage across R1, L1, R2 and C2 using any method...

A: Brief description: In the above given AC circuit we need to compute the value of current & volta...

Q: 10.6 Determine V, in Fig. 10.55. + ll 20 Ω 20 2 0.2V j10 2 60/0° V ell

A: The given circuit is,

Q: Problem 3. Determine what K will make the following characteristic function stable (no poles on the ...

A: Here, we have given a characteristic function, for which we have to calculate the range of K. So, th...

Q: Apply the E-shift operation to the resistive network shown in Figure 1.79 and calculate the value of...

A: This question belongs to network theory . It is based on the E shift concept in the circuit . By usi...

Q: Gonsider the following System 2 ]a a) ineshple the slabliy of te splem. b) investiyede Hhe anhrollab...

Q: find the power supplich by R YMA Current Saurce R (YmA) R=12 lkr

Q: Q7/ Calculate the current (I) in the circuit shown in fig.(7) 125 A a04 L 20A 0.042 30A 20A 0.ola 0....

A: In this question we will find unknown current I..

Q: What is Vo? 1k Ohm Vo =12 V Vz=5V 3k Ohm

Q: * find the voltage V 62 20 -15V 102 + V 3.366 O 5.264 O 5.555 O

A: In this question we will find voltage V using KVL... voltage law states that for a closed loop serie...

Question

A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resistor.
Find the rms value of current in the resistor. (Unit: A)
Submit Answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
Find the average and rms value of the waveform shown in Figure-2. Em 3x ot- Figure-2
3. The secondary voltage can rise above its rated value when the load is a. resistive. b. capacitive. C. inductive. d. an RL series combination.
2. A triangular voltage source has a peak value of 10 V. What is the computed RMS value of this source? a. 3 V b. 4 V c. 5 V d. 6 V 3. In Question 2, if the source is measured by an analog meter, will it show the correct RMS value? a. Yes b. No
5 The voltmeters in the figure measure RMS voltages. If V, = 23 V and V, = 14.5V what is V3? %3D C R eee V2 V3 23 V None of them 8.5 V 4.5V 37.5 V O 14.5 V
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
Determine the rms voltage across each resistor and the rms current. Make sure to graph the rms voltage and current.
QUESTION 11 An inductor is connected in parallel with a 6540 resistor and a function generator. The applied voltage is 42V RMS and the total current is 67mA RMS. Find the magnitude of the current through the inductor. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in mA but do not enter the unit.
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
Determine the rms current I as shown in figure 2. Source voltage is already in RMS value(Answer must be in polar formand should be in 4 decimal places).
6. Determine the rms current I as shown in figure 1. Source voltage is already in RMS value (Answer must be in polar form and should be in 4 decimal places). -j4 N j1.5 N B 4 N 200/30° V -j2 N= jI N