Air flows through the turbine at a mass flow rate of 1.6 kg/s. Air leaves the turbine at a temperature of T2 = 0°C. Calculate the work out of the turbine. Report your answer in kW. Do it by hand. Use Cp = 1.01 kJ/kg-C and Cy = 0.72 kJ/kg-C. th=2kg/s 7,200 C P₁= 5 MPa Turbine 소란 Throttling Valve P100 kPa 3 P2100 kPa Wout

Air flows through the turbine at a mass flow rate of 1.6 kg/s. Air leaves the turbine at a temperature of T2 = 0°C. Calculate the work out of the turbine. Report your answer in kW. Do it by hand. Use Cp = 1.01 kJ/kg-C and Cy = 0.72 kJ/kg-C. th=2kg/s 7,200 C P₁= 5 MPa Turbine 소란 Throttling Valve P100 kPa 3 P2100 kPa Wout

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The inlet temperature of an air compressor is T₁=300°K and the outlet temperature is T2-500°K. The compressor operates at a mass flow rate of 0.093kg/sec and the heat lost during the compression is 10kJ/kg. Assume that the air is an ideal gas with Cp=1.004 kJ/(kg°K). Calculate the mechanical power needed to be provided to the compressor shaft. Present your answer in kilo- Watts (kJ/sec).
The centrifugal compressor of a gas turbine receives air at 1bar and 300K. At the discharge ofcompressor, the pressure is 4bar, temperature is 480K and velocity is 100m/s. The mass rate of flowinto the compressor is 15kg/s. Determine the power required to drive the compressor.
A centrifugal fan supplies 4.7m3/s of air at a total static pressure of 325Pa. If the fan efficiency is %06 and rotates at a speed of 950rpm and supplies air with a velocity of 12m/s, determine the fan total pressure, air power, and fan power?
In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine is used to power the compressor. In the figure below a turbine runs on steam and powers a compressor on air. Air can be considered a perfect gas with k = 1.34, R = = 300K and a mass flow 0.28 kJ/kgk = 1bar, T₁ = and Cp 1.02 kJ/kgK. The air enters the compressor at p₁ rate of mdot = 5.9 kg/s and exits at p2 = 5.2 bars. The steam enters the isentropic turbine at P3 = 2 MPa, T3 = 320°C and exits at p4 = 100 kPa. State 2 Isentropic Compressor State 1 Air-perfect gas T₁ = 300K P₁ = 1 bar W Answer: tubine = ? State 4 Isentropic Turbine State 3 Steam T3=320°C P3= 2MPa What is the enthalpy at state 2? Please enter your answer in kJ/kg
The compressor of a jet engine tested at sea level on a stationary test bed on a day when the atmospheric temperature and pressure is 298 K and 101kPa, respectively. When running at its design operating point, the masss flow rate through the compressor is measured as 15 kg/s and the rational speed is 6200 rpm. Determine the mass flow rate and the rational speed when the compressor is operating at the design operating point during high altitude cruise with an onlet stagnation temperature of 236 K and an inlet stagnation pressure of 10.2 kpa. The design pressure ratio of compressor is 20. If the compressor isentropic efficiency is determined from the test to be 85=, calculate the power input at the cruise condition. Assume for air that y=1. 4 and Cp=1005 kJ/kg-K throughout.
Identify what is the system in this problem and write the general energy balance equation (no need to solve) A turbine is driven by a system that enters the turbine at the ff. conditions: 200 kg/h, 39 atm, 501 deg C, 49 m/s linear speed. The steam exits at a point 8 meters below the inlet stream of the turbine with the following conditions: atmospheric pressure, 290 m/s speed. 69000 W of shft work is delivered by the turbine while 100 kcal/h heat is lost. What is the specific delta H?
2. A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079ft/cu. ft and discharges it with a density of 0.304 lb/cu. ft. At the suction, P 1 = 15 Psia; atdischarge, P 2 = 80 psia. The increase in the specific internal energy is 33.8 BTU/lb and the heattransferred from the air by cooling is 13Btu/lb. Determine the work on the air in BTU/min and inhp. Neglect kinetic energy. 3 decimal in final answer pls
An air compressor has a suction volume of 0.35 cubic meter/sec at 28 deg. C and 101.325 Kpa and discharges 700 kpa. Determine the amount of power saved by the compressor in two staging?
The diffuser in a jet engine is designed to decrease the kinetic energy of air entering the engine compressor. Clearly define the type of transformation between inlet and outlet. Air enters the inlet at 100 kPa at 20 °C and a velocity of 340 m/s and exits at 350 kPa and Cp ? Calculate the 90 °C. Assume that air is a calorically perfect gas. What is P/c, velocity at the outlet Aout Ain Assume that air is a calorically perfect gas. What is the ratio
12 kg of air per minute is delivered by a centrifugal air compressor. The inlet and m3 kg т outlet conditions of air are: V1 = 12 ", P1 = 100 KPa , v1 = 0.5- and V2 = 90", P2 = 800 KPa , v2 = 0.14 m. The increase in enthalpy of air passing kg and heat loss to the surroundings is 700 KI kg K] min through the compressor is 150- Find the work in KW.
8. A radial type Boeing 747 blower is designed to deliver 1.3 m3/sec of air at a pressure of 107 KPa when operating at an altitude of 4000 m where the temperature is -10 °C and the pressure is 60 KPa. It rotates at 18 000 RPM and is to have an adiabatic efficiency of 72%. It is to be tested at sea level (P: 101 KPa and t=21 C) at a speed of 14 000 RPM. Assuming that the efficiency at the design point does not change, determine for the design under test conditions the power required to drive it in KW. (61KW)
An ammonia refrigerator produces 30 tonnes of ice from ant at 0 °C in 24 hours. The temperature range of the compressor is 25 °C to -15 °C. The vapour is dry saturated at the end of compression. Assume a coefficient of performance to be 60% of the theoretical value. Calculate the power required to drive the compressor. Latent heat of ice = 135 kJ/kg. Properties of ammonia are as follows:Temperat ureEnthalpy (kJ/kg)Specific entropy (kJ/kg-K)(oC) Liquid Vapour (hf) (hg)Vapor (Sf) (Sg)Liquid25 -15298.90 1465.84 112.34 1426.541.1242 0.45725.0391 5.5490