Add the energy grade line (EGL) as a solid line and the hydraulic grade line (HGL) as a dashed line to the figure below. Enter the corresponding numbers in the table. Assume steady incompressible flow from left to right. At point A, the pressure head P/y = 8 ft and the velocity is V=8 ft/s. The first turbine extracts AH = 10 ft, and the second turbine extracts AH = 5 ft.

Add the energy grade line (EGL) as a solid line and the hydraulic grade line (HGL) as a dashed line to the figure below. Enter the corresponding numbers in the table. Assume steady incompressible flow from left to right. At point A, the pressure head P/y = 8 ft and the velocity is V=8 ft/s. The first turbine extracts AH = 10 ft, and the second turbine extracts AH = 5 ft.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

63. Water is flowing out of a small hole located at a depth of h below the freesurface of a large reservior. Find the equation of the stream leaving the hole in thecoordinate shown in the figure. [Ans.: y = x2/4h].
Solve and draw also the figures. i. Water is flowing through a pipe of 100 mm diameter under a pressure of 19.62 N/cm² (gauge) and with mean velocity of 3.0 m/s. Find the total head of the water at a cross-section, which is 8 m above the datum [Ans. 28.458 m] ii. A pipe, through which water is flowing is having diameters 40 cm and 20 cm at the cross-sections 1 and 2 respectively. The velocity of water at section 1 is given 5.0 m/s. Find the velocity head at the sections 1 [Ans. 1.274 m ; 20.387 m ; 0.628 m³/s] line. and 2 and also rate of discharge. The water is flowing through a pipe having diameters 20 cm and 15 cm at sections 1 and 2 respectively. iii. The rate of flow through pipe is 40 litres/s. The section 1 is 6 m above datum line and section 2 is 3 m above the datum. If the pressure at section 1 is 29.43 N/em², find the intensity of pressure at section 2. [Ans. 32.19 N/cm²]
Assume 4 kg/s of fluid are moving through an insulated pipe under these conditions: v1 = 6 m/s and u1 = 40 J/kg. (a) Find E1, in W (whole number) . (b) If the fluid flows through an upward bend of the pipe until v2 = 2 m/s and u2 = 45 J/kg, through what vertical height did the fluid travel? (2 decimal places) Local g = 9.75 m/s2.
For the following questions, Circle the correct answer Q1. We have a steady fully rough turbulent flow of water with constant density in a cylindrical pipe of constant diameter. The height of the uniform roughness elements in the pipe is k.. . . For a fully developed rough turbulent flow in the pipe, the condition ku. -> 70 is the same as k,> 66,. [True/False] V avg The wall shear stress T-pfU/8. It is applicable only for steady fully rough turbulent flow in the pipe. [True/False] The shear stress distribution is linear with the radial distance from the pipe centerline only for laminar flow. [True/False] The head loss per unit length is quadrupled when the discharge is doubled. [True/False] The piezometric pressure drops uniformly along the pipe because the flow is steady along the pipe [True/False]
A horizontal jet of water 30 mm diameter is impinging on a vertical fixed plate. If the force exerted by the jet is 282.5 N, find the velocity of the jet. [Ans. 20 m/s]
b Water flows around the vertical two-dimensional bend with circular streamlines and constant velocity as shown in the figure below. If the pressure is 62 kPa at point (1), determine the pressures at points (a) (2) and (b) (3). Assume that the velocity profile is uniform as indicated. = Esc Type here to search L 1 A 30 @ 2 W S 4x F2 # 3 E 4₁ D O $ 4 R F F4 % 5 2m 99+ FS T G A 6 4 m 1 m Y H (3) (2) (1) * F7 & 7 V = 10 m/s U PrtScn FB 8 Home 9 K 9 End F10 ) 0 L 36°F Clear PgUp F11 P PgDn 40 + (1) 7:00 PM 11/21/2022 Del Backsp
Water enters the piping arrangement shown in the figure at a volumetric flow rate Q1=0.4 m^3/s. The water flow is then divided into pipes of diameter [Theta2] = 5 cm and [Theta3]= 10 cm. If the average speed of the water in pipe 2 is [V2] = 25 m/s. What is the flow rate Q3 in m^3/s in the pipe of diameter theta 3? And at what speed does the fluid leave through pipe 3 in m/s?
The water circulates throughout the building in a hot water heating system. If the water is pumped at a speed of 1 m/s through a 6 cm diameter pipe in the basement under a pressure of 200 kPa, sadwhat will be the velocity ( Select] and pressure [ Select ] v in a 3 cm diameter pipe on the 2nd floor that is 5 m above the basement? b. from basement to 2nd floor, what happens to the speed of the water? [Select] c. from basement to 2nd floor, what happens to the pressure of the water? [ Select ]
Q1: Water flows through the elbow. It exits to the atmosphere at section 2. The inlet and exit pipe diameters are D;=10 cm and D2=3 cm, respectively. At a weight flow rate of 169,9 N/s. The elevation difference between the inlet and outlet sections is 25 cm. Neglecting the weight of water and elbow, estimate the force [N] on the flange bolts at section 1. (NOTE: pwater=998 kg/m?)
Help me please
two points; (D) gauge 10. A Terran T-280 SCV (space construction vehicle) examines a typical vespene geyser field, which normally contains 20 circular openings, each of which has a radius of 0.10 m. The geyser mouths (according to a sonar probe) are connected to a main geyser “pipe" 0.80 m in radius. If the speed of the vespene gas is 3.0 m/s through the main pipe, what is its velocity as it exits through one of the geyser mouths? spaads The
1) Consider the wave of small wave elevation in water of infinite depth. By linearization the water fluid flow can be described by velocity potential o which satisfy linear equations. i. For the wave described by: o ekz sin(kx – wt) and 3 = acos(kx – wt) show that: a. The potential energy in a wave length is Apga?/4. b. The kinetic energy in the wave length is Apga?/4 as well.