A transmission line of characteristic resistance 50 Ω is loaded with a load impedance ZL = RL + jXL . The magnitude of the reflection coefficient at the load is measured to be 0.5. If the magnitude of the imaginary part of the load impedance is |XL | = 25 Ω , find the number of possible values for the real part RL of the load impedance. (a) 0 (b) 1 (c) 2 (d) 4

A transmission line of characteristic resistance 50 Ω is loaded with a load impedance ZL = RL + jXL . The magnitude of the reflection coefficient at the load is measured to be 0.5. If the magnitude of the imaginary part of the load impedance is |XL | = 25 Ω , find the number of possible values for the real part RL of the load impedance. (a) 0 (b) 1 (c) 2 (d) 4

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.32MCQ

See similar textbooks

Similar questions

Q) A source of 10 V and frequeney 1000 KHz with internal resistance of 10 Q is connected to the sending end of a transmission line which can be represented by a resistance of 70 2 in series with capacitance of 0.001 uF connected across the line at the receiving end. An inductive load of inductance 0.002 H and resistance 100 2 is connected across the receiving end of the line. Determine the load current.
For the pair of waveforms (input and output) captured in that picture, write the mathematicalexpression for Vout(t), using the phase of Vin(t) as the reference. Also, write the phasor expressions forVout and Vin. Vin = Yellow line Vout = Blue line Vin max = 2V Vout max = 440.0 mV phase = -78.7483
Reduce each of the following to rectangular form: a. Za = 5+j5+10∠30°; b. Zb = 5∠45°-j10; c. Zc = 10∠45°/3+j4; d. Zd = 15/5∠90°.
. The relation between impedance and admittance locus is Opposite Mirrored Inversely Reciprocally
Just answer iv iv) Determine the impedance from Ql (iii).
1. If the impedance of the circuit when expressed in polar form has a magnitude of _____ ohms and an angle of _____ degrees. Select the correct answer below: -5, 53 -5, -53 5, 53 5, -53 2. if the impedance is drawn as a phasor diagram, it would look like an arrow drawn _____ making an angle of _____ degrees from the positive horizontal axis. Select the correct answer below: a. diagonally on the 4th quadrant, 53 b. diagonally on the 4th quadrant, -53 c. diagonally on the 1st quadrant, -53 d. diagonally on the 1st quadrant, 53 3. if V1 is made the reference phasor, then its phasor diagram would look like an arrow drawn _____ making an angle of _____ degrees from the positive horizontal axis Select the correct answer below: a. horizontally to the right, 0 b. horizontally to the left, 0 d. horizontally to the right, 180 e. horizontally to the left, 180
QUESTION 50 RG180B/U is a coaxial cable with a nominal impedance of 95 02 and a capacitance per foot of 15.5 pF/ foot. Determine the inductance per foot of this cable. O a. 140 nH/ft Ob.45 nH/ft O c. 95 nH/ft O d.250 nH/ft
For the network in the given circuit, find Zin. Let w w = 100 rad/s and L = 50 mH. The value of Zin = < <-°. Please report your answer so the magnitude is positive and all angles are in the range of negative 180 degrees to positive 180 degrees.
Find the current I, in the circuit shown. ... 50 N 100 Q 60/0° V j80 Q -j40 Q Note: The current /, required is in MAGNITUDE only with 4 decimal places. Final Answer: I, = Blank 14-28.8468 A
I. Express the notations below in rectangular form. 13(cos(292.6°) + isin(292.6°)) 5. 6. 55.902cis63.345°
ASAP
Given the following impedance values Z1 = 3 + j4, Z2 = 5 – j3 %3D b. Z1 = -3 - j4, Z2 = 20/ 30º %3D c. Z1 = -3 + j4, Z2= -12e15 (2,)(Z.) for each letter. Submit your answer in rectangular form. Determine Z,+Z, a) +j b) +j c) +j