Base station antenna height (h,) 200 m Mobile antenna height (h,) 3 m Frequency (f) 500 MHz Distance between antennas (d) 10 km Average angle of slope 0m 10 miliradians Terrain undulation height An 50m (near bottom of undulation) %3D Base station gain (G,) and mobile (G.) 10 dB and 2dB Power transmitted (P,) 50 dBm Mobile is located in a suburban area. Find the predicted power received using Okumura model. II II II

Base station antenna height (h,) 200 m Mobile antenna height (h,) 3 m Frequency (f) 500 MHz Distance between antennas (d) 10 km Average angle of slope 0m 10 miliradians Terrain undulation height An 50m (near bottom of undulation) %3D Base station gain (G,) and mobile (G.) 10 dB and 2dB Power transmitted (P,) 50 dBm Mobile is located in a suburban area. Find the predicted power received using Okumura model. II II II

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A rectangular waveguide has a dimension of (3X2) cm is used to transmit a signal of 9 GHz. Determine cutoff wavelength for dominant mode.
This question is about Frequency Modulation (FM) and the Phase-Locked Loop (PLL). suppose a FM signal, 20sin(2à × 9 × 107t + 5sin1.2à × 10ªt) is applied to a 50-Q antenna. Determine: i) The carrier frequency. ii) The transmitted power. iii) Modulation index mf. iv) Intelligence frequency fi. v) BW (using Carsons rule)
A 162-MHz carrier is deviated by 12 kHz by a 2-kHz modulating signal. The maximum deviation of an FM carrier with a 2.5-kHz signal is 4 kHz. Compute the bandwidth occupied by the signal, by using the conventional method and Carson’s rule. Sketch the spectrum of each signal, showing all significant sidebands and their exact amplitude.
A 1-MHz carrier with an amplitude of 1 volt peak is modulated by a 1-kHz signal with m=0.5. Sketch the voltage spectrum.
In a microwave resonator, the resonant frequency is .... Given the form, the resonance mode is __________.
A carrier of 16 cos (2710't) volts is amplitude modulated by a modulating signal of 8 cos(2710³t) volts. Determine: 2. The total power and the transmitting efficiency over 50 2 load. 3. The upper and lower amplitude and frequency and the total bandwidth. 4. Plot the amplitude spectrum of this AM-DSB.
Q1. A link is operating at f=60GHz & 500 MHz bandwidth. The Tx & Rx antennas are square-shaped with 2m and 50cm in dimension, respectively. The Tx-RX distance is 500m. The aperture efficiency is 0.9 for Tx and 0.5 for Rx. The Tx power is 30 dBm and the receiver threshold is -100 dBm with Te-900k for Tx and 700K for Rx.. Calculate (a) the received power (b) the path loss (c) the link margin, and (d) the received SNR.
Q3/ If the modulation is 100 percent calculate the impedance of the and the total power when the carrier signal ve = antenna 40sin(30000nt) and Psb 50watts .
What is the power density at a rangeof 6km radiated by a particular antenna ifits gain is 30dBd and transmitter poweroutput is 30W? (Gain must be withrespect to the isotropic radiator)
A satellite at an altitude of 37654 km transmits a signal of 17 GHz to a ground station directly below it. The following data is given. • Total atmospheric losses = 40dB • Transmit antenna gain = 55dBi • Receiver antenna gain = 60dBi • Signal to noise ratio of received signal = 6dB • Receiver signal noise power = 25pW • Receiver sensitivity = -90dBW I. Calculate the power transmitted. II. Find the Fade Margin for the link and comment on your result.
Pls don't just directly copy the answer from other post.(i) Sketch the spectrum at point (a) and (b) of the receiver. (Label all magnitudes and frequencies ofthe axes.)(ii) What must the bandwidth of the channel be required for the system?(iii) Design a transmitter to multiplex the signal m1(t) and m2(t) for the receiver. (Show clearly all thedetails.)
A 10Vp carrier signal is amplitude modulated by two different frequencies 5 KHz and 10 KHz with amplitude of 4Vp and 7.5Vp respectively using an DSBFC. If the system is connected to the 100Q antenna, (a) what is the modulated carrier power and AM wave total power? From DSBFC, different transmitters with different modulation schemes were used to evaluate the performance in terms of power and bandwidth and compare to conventional AM. (b) Complete the table below and provide your solution. Use 3 decimal places. AM WAVE TOTAL POWER (mW) MODULATED CARRIER BANDWIDTH TYPE OF % POWER SAVED POWER (mW) (kHz) MODULATION DSB-SC O mW (b1) (b2) (b3)