A part made from hot-rolled AISI 1212 steel undergoes a certain amount of cold-work operation. If the ultimate strength of the material after cold work operation was 80 kpsi. (a) Determine the percentage of cold work (b) Obtain the yield strength after the cold work (c) Determine the hardness of the material before and after the cold work operation

A part made from hot-rolled AISI 1212 steel undergoes a certain amount of cold-work operation. If the ultimate strength of the material after cold work operation was 80 kpsi. (a) Determine the percentage of cold work (b) Obtain the yield strength after the cold work (c) Determine the hardness of the material before and after the cold work operation

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Help me please
Question-8. . A cylindrical metal specimen with a diameter of 16 mm and length of 88 mm is to be subjected to a tensile stress of 80 MPa; at this stress the resulting deformation is elastic. (a) If the elongation is less than 0.058 mm, which of the metals in the table can be considered as candidates? Why ? (b) If the maximum permissible diameter decrease is 0.0012 mm when the tensile stress of 68 MPa is applied, which of the metals satisfy the criterion in question (a) are the suitable candidates? Why ? Metal Shear Modulus / GPa Modulus of Elasticity / GPa 69 Poisson's Ratio Al 25 0.33 Cu 110 46 0.34 Mg 45 17 0.29 Ni 207 76 0.31 Ti 107 6.5 0.34 W 407 23.2 0.28
help
Determine the force applied to a hardness specimen that has Brinell hardness number as 974 and the surface area of indentation as 15 mm2. The force applied to the Hardness Specimen (kN)=
Draw the systematic diagram
i need the answer quickly
Do it ASAP
ANSWER Q4 PART B
please includde scetch
Consider dynamic (rapid) indentation of a rigid-perfectly plastic material by a sharp rigid cone of apex angle 90 degrees. The hardness value obtained from such a test is called the dynamic hardness of the material. The dynamic indentation can be modeled as a process in which the full indentation load is applied instantaneously. Assume the static hardness of this rigid-perfectly plastic material measured in a typical hardness test (where the load is slowly increased from zero) with the same cone to be H. Estimate the dynamic hardness of the material in terms of the static hardness H. Note: Both static hardness and dynamic hardness are defined as the load divided by the projected area of the indentation. (Hint: Consider work balance in the dynamic hardness test – external work done by the applied force is equal to the internal deformation work. The latter can be thought as pdV work, with p being identified with the resisting pressure (= static hardness H) of the material, and V with…
What’s the answer for this please ?