A dielectric sphere (Er=6) of radius 10 cm has a point charge 3 pC placed at its center. The magnitude of the force exerted by the charge on -3 pC point charge on the * sphere is 2.35 pN O 1.75 pN O 1.00 pN O 2.00 pN O 1.35 pN O

A dielectric sphere (Er=6) of radius 10 cm has a point charge 3 pC placed at its center. The magnitude of the force exerted by the charge on -3 pC point charge on the * sphere is 2.35 pN O 1.75 pN O 1.00 pN O 2.00 pN O 1.35 pN O

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Related questions

Q: A type of activity that has no duration and uses no resources is called what? O Dummy O Crossover O…

A: As we know that as there so many activities which uses resources and time duration as performed…

Q: ΤΗ ΠΩ 70 Ω 10 Ω ΦΩΣ 240 V 20 Ω 1=0) 10mF

Q: 1. True or false: In direct current (DC), the electric charge (current) only flows in one direction.…

Q: The figure above shows the percentage differential relay used for the protection of an alternator…

A: We got percentage differential relay for protection of an alternator winding. Minimum pick-up…

Q: Problem: A series RLC circuit is compose of R = 50 , XL = j40 , Xc = -j15 Q. The supply voltage is…

A: It is given that: R=50 ΩXL=j40 ΩXC=-j15 ΩVrms=240∠0° V

Q: When a 5 A current is made to flow through a coil of 20 turns produce a flux of 10 Wb. Find the…

A: Given data, Current i = 5 A Number of turns N =20 Flux ϕ=10 Wb Rate of change of current didt=8…

Q: The city of Inglewood has a total load of 10MVA. Assume that the load is supplied by a 3- phase…

A: Given: Total load, S=10 MVA Three-phase balanced source with line voltage VL=69 kV Power factor,…

Q: 7. Given the following transfer function: 6s²+66s+60 100s²+20s+1 H(s) = With an input of x(t) =…

Q: A series circuit of resistance 60 2 and inductance 75 mH is connected to a 110V, 60 Hz supply.…

A: From the question, it is given thatResistance=60 ΩInductance=75 mHVoltage=110VFrequency=60 HzWe have…

Q: 25 Given the closed-loop transfer function T(s) = s2+3s+25 Find wn, Natural Frequency wn = Damping…

A: Given: The closed loop transfer function, Ts=25s2+3s+25

Q: A system shown in Figure Q3 a) has a damping ratio of 1 and a natural frequency of 10 rad/s.…

Q: Find the capacitance (in units of pF) of a parallel plate capacitor that is made of two parallel…

A: Given data, Area of plate A=7.6×10-4 m2 Distance between plate d=2.4 mm =2.4×10-3 m Dielectric…

Q: Obtain the equivalent circuit of a 200/400V 50 Hz single phase transformer from the following test…

A: Given data: Core loss POC=55 W Copper loss PSC=400 W Short circuit current ISC=80 A Short circuit…

Q: Among the 3 systems of measurement which is/are under the English System? a. MKS or…

A: Answer: e. a & c Explanation: a. MKS system is a measurement system used in USA. So it is part…

Q: -qV 4. Find the current through the resistor and an output voltage si 9V A Ge B Vo 35kr

Q: a current element J.dv is measured in terms of

A: given current element J.dv

Q: Find the voltage across 20 resistor due to 20V source 20 W 20V 10

A: Given circuit,

Q: The current flowing through a device is i(t) = 5 sin 6rt A. Calculate the total charge flow through…

A: Given data, Current is given it=5sin6πt A Time is given t=0 to t=10 ms

Q: In a balanced three-phase system, the source is a balanced Y with an abc phase sequence and a line…

Q: The quantum efficiency (n) and responsivity (R) at a wavelength 2 (in µm) in a p-i-n photodetector…

A: Given Responsibility Quantum efficiency wavelength

Q: Problem 4: Find /, using Thevenin's or Norton's theorem

Q: With the 3V source acting alone, find Vx. 5 Q M 6.92V 3V 3.45V 2.08V 4Q + Vx M + 33Ω 10 9 V + 3 V

Q: A resistance oven employing nichrome wire is to be operated from 220 V single phase supply and is to…

A: All the steps are shown below

Q: can i see the solution?

Q: A coil of inductance 100 mH and resistance 800 ohm is connected in parallel with a variable The…

Q: Frequency modulated signal with single-tone modulation has a frequency deviation of 15 kHz and…

A: Given data, Frequency deviation △f=15 kHz Bandwidth B.W=50 kHz

Q: Que 2.23. What should be the value of R, so the maximum po can be transferred from the source to R,…

A: The given circuit is shown below. Find the value of RL so the maximum power will flow.

Q: 1) Evaluate the circumstance shown in the illustration and come up with 3 key features of this…

A: The given image is shown below,

Q: Q.4: Use the mesh analysis on a circuit at Figure 1 to find: a- Currents on resistors R1, R2, and…

A: The required parameters can be calculated by applying kirchhoff's voltage law to the meshes and the…

Q: A lossless transmission line having 50 Ω characteristic impedance and length λ/4 is short-circuited…

Q: Q4. An 8-pole DC generator has 400 armature conductors and a useful flux of 0.05 Wb. What will be…

Q: Que 4.10. Consider the network shown in Fig. 4.10.1. Determine the transfer function. VEN R₁ -WWW C₁…

Q: E5.3 Compute V, in the circuit in Fig. E5.3 using superposition. www 3 ΚΩ Figure E5.3 12 V (+ www 4…

Q: A single phase transmission line delivers 1500 kW at 33 kV at 0.8 p.f. lagging. The total resistance…

A: Given P = 1500kW V = 33kV Pf = 0.8 lagging ZL = (10+j15)Ω Sending end voltage(VS): ? Sending end…

Q: 1) An SCR has a circuit fusing rating of 90 A²s. The device is being used in a circuit where it…

Q: Find the Z parameters of the network shown in Fig. 3.

Q: Find Leq (in Henry). Give only the numeric value. 4 H 20 H m Leq m 8 H 7 H m 10 H 12 H

Q: 2. series RLC circuit has a resistance of 60 ohms, a capacitance of 10-2 Farads, an inductance of 5…

A: Series RLC circuit has the following parameters : R=60 ΩC=10-2 FL=5 Happlied voltage=20sin5t volts =…

Q: Que 4.20. Find the Y-parameter model. A the Y-parameter I 13 YA of the following -circuit and draw…

Q: In Figure , if Vz = 50 V a. Determine the maximum possible value the capacitor C₁ can charge to (VGK…

A: Given: VGK = 0.7V R3=8.2kΩ C1=0.1μF

Q: Que 4.10. Consider the network shown in Fig. 4.10.1. Determine the transfer function. R₁ VIN C₁ = R₂…

Q: x (n) = сos nлn и (n)? COS

Q: Subtract (5 + j2) - ( 6 - j7), find the answer in rectangular and polar forms NFTOC in polar form,…

Q: answer number 3 asappoo

Q: connected in parallel with an 90 Q resistor across a Vrms = 230<0° V, f = 60 Hz supply. Calculate…

A: Given R= 90 ohms C = 25 microF V= 230 v F = 60 Hz

Q: A wave traveling in free space with parallel polarization is incident upon a pefectly conducting…

Q: Find i at t=0" 4V 126.32mA 400mA 336.84mA 10 Ω Μ t=0 Χ. 3Ω 5 Ω www ell 36 nH

A: So first we have to draw the condition before the switching happened so that we can find the given…

Q: 54. Design a single-stage common-emitter amplifier with a voltage gain of 40 dB that operates from a…

A: Circuit diagram of single-stage common emitter amplifier : Where R1=R2=330Ω Here, we have to design…

Q: Example 3.1 Consider a 40% efficient heat engine operating between a large, high-temperature…

A: We have got an heat engine operating between a large with, High Temperature(TH) = 1000 k Cold…

Q: A factory that is fed by a three-phase generator connected in Δ with Vac equal to 240 V with an…

Question

A dielectric sphere (Er=6) of
radius 10 cm has a point
charge 3 pC placed at its
center. The magnitude of the
force exerted by the charge
on -3 pC point charge on the
* sphere is
2.35 pN O
1.75 pN O
1.00 pN O
2.00 pN O
1.35 pN O

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
mp?attempt=2176198&cmid%3D1088508page%3D6 Question 7 Not yet anwend Marked out of 10.00 Hlag question The line shown in the figure has a linear charge distribution of 101 nC/em. If R=8 cm, find the Electric Potential at the point indicated by the dot. Scan clearly your detailed answers and upload it in question 8. R. 2R V=224016.68 V V=134410.01 V V=448033.36 V V=672050.04 v
Each of three insulators forming a string has self-capacitance of "C" farad. The shunt capacitance of each cap of insulator is 0-25 C to earth and 0-15 C to line. Calculate the voltage distribution across each insulator as a pecentage of line voltage to earth and the string efficiency.
6 6 - A dielectric is a material that is: A) a semiconducting B) a nonconducting C) a superconducting D) none of them E) a conducting
Four point charges are placed at corners of a square . At the top left is a charge of - 1 C, at the top right is a charge of - 2 C, at the bottom right is a charge of -3 Cand at the bottom left is a charge of - 4 C. What is the direction of the net electric force due to the four point charges on a positive charge Q located at the center of square ? O due North O due South O Sw O SE
Two positive point charges q1=4.40 uC and q2=6.40 uC are separated in vaccum in distacne of 6.0m find the magnitude of the net electric at point r!=4.80m from q1 in N/C
Question A suspension type insulator has three units with self-capacitance C and ground capacitance 0.1C. What will be the string efficiency?
A negative charge of -0.0005 C exerts an attractive force of 9.0 N on a second charge that is 10 m. away. What is the magnitude of the second charge?
1 what must be the dis tance between paint charge 94=26.0 MC and point charge 92 = -47.0 MC for the electrostatic force between them to have a magnitude of 5.70N ? %3D
A wire has a circular cross-section of radius r= 3.53 mm. The conductivity of the wire is 1x10^5 (Ohm, meter) and its lengthis 2m. The total resistance of the wire in Ohms is:O a. 0.51O b. 0.72ç. 0.26O d. 5136.07O e. 797497.60
Find the hall coefficient of a silicon material used in a Hall generator with a gap distance is 2.0 cm. When a current of 300 A flows, the hall voltage is recorded as 10 V and a magnetic flux density of 0.2 T is produced. Lütfen birini seçin: a. 0.0461 b. 0.0074 c. 0.0695 d. 3.3333 e. 0.0033
Solve the following values in figure 1.0. Total Capacitance, Ct. Total Charge, Qt. Individual Charge of C1 Individual Charge of C2 Individual Charge of C3