Find the capacitance (in units of pF) of a parallel plate capacitor that is made of two parallel plates that have each an area of 7.6 X10-4 m² and separated by 2.4 mm sheet of Mylar (K=3,2), use En =

Find the capacitance (in units of pF) of a parallel plate capacitor that is made of two parallel plates that have each an area of 7.6 X10-4 m² and separated by 2.4 mm sheet of Mylar (K=3,2), use En =

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 35RQ: Which of the following is the capacitance of two 20-microfarad running capacitors connected in...

See similar textbooks

Related questions

Q: G1 파 H R₁ H G₂

Q: What will be the meters reading? Voltmeter V, 24 V XMM1 Xid www R₁ = 1.5k2 R₂ = 2.5k2 XMM2 Ammeter

A: Given circuit,

Q: 2. Given: A certain liquid weighs 7.95 kN/m³ Required: a) Specific volume (m³/kg) b) Specific…

A: 2) It is given that: m=7.95 kNm3=7950 Nm3

Q: Identify the correct nodal equation that applied to the circuit below. 투 a +1 R₁ ww V C R₂ ww V₂( V₂…

A: Given circuit,

Q: Two lamps A and B are hung at a height of 9 m from the floor level. The distance between lamps is…

Q: Figure 3 illustrates a thyristor phase control circuit and associated waveforms. Describe the…

A: Thyristor:- It is a four-layer power electronics device. A gate, a cathode, and an anode are the…

Q: A DC motor takes an armature current of 130 A at 460 V. The armature circuit resistance is 0.4 Q.…

A: Given that: Armature current, Ia=130 A Voltage, V= 460 volt Armature resistance, Ra=0.4 ohm Pole,…

Q: Figure (a) shows a phasor diagram ir which the current I lags the applied voltage V by angle p. The…

Q: An oscillator employs ..... 1. Positive 2. Negative 3. Neither positive nor negative 4. Data…

A: An oscillator employs…………..feedback. A feedback signal can be added in phase or out of phase with…

Q: An ac supply of 220 V is applied to a half-wave rectifier circuit through transformer with a turns…

Q: Consider the feedback control system Select one: O R(s). a. c, = 3.26 rad/sec b. wy = 5.49 rad/sec…

Q: Obtain Zin for the circuit in Le Fig. 9.67. Zin j15 Ω 25 Ω wwwm -j50 Ω 20 Ω 30 Ω 110 Ω

A: Given, The circuit is,

Q: ZT- 20 www j20 20 -j40 O a. ZT 1,38 +j1,08 O b. ZT 3,38 +j1,08 = O c. None of the alternatives are…

A: Given:

Q: In the circuit shown, 12 R = 4 N, R2 = 5 Q, R3 = 6 1,ɛ =8 V,ɛ2 = 5 V and ɛz = 12 V. R %3D R2 R3 A.…

A: Given- R1 = 4 ohm R2 = 5 ohm R3 = 6 ohm E1 = 8 V E2 = 5 V E3 = 12 V

Q: ) Two feedback configurations are shown in Figures Q1.a(i) and Q1.a(ii). Derive the closed-loop gain…

A: Here Given two figures having feedback.

Q: If an AC signal has a peak voltage of 55V, what is the average value voltage? a. 110 V b. 17.5070 V…

A: Given thatPeak voltage of AC signal (Vm)=55VWe have to find the average voltage.

Q: EAD= 208 V 20 ECA = 208 V / 120° 000 W₁ Enc208 V-120 W₂ voo ell Ice 1202 ww 150 120 100 000 2002

Q: 1) Draw the compete circuit with the op-amp included. 2) Obtain equations for the contribution made…

A: According to the question, we need to solve the given circuit of the OP-AMP.

Q: In a Q-meter measurment to determine the self capacitance of a coil, the first resonance occurred at…

A: Given in a Q-meter measurement. The first resonance occurred at Frequency, f1 Capacitance, C1 = 300…

Q: Grade the resistance of a 5 section starter for a 3.7 kW, 250 V, 1000 rmp D.C. shunt motor from the…

Q: A delta-connected unbalanced load is connected across a three-phase balanced source. The sequence…

Q: The common-mode gain is ........... 1. very high 2. very low 3. always unity 4. unpredictable

Q: Manganese(IV) is an even stronger oxidizing agent than manganese(III). Itoxidizes zinc to Zn2+ in…

A: The reaction is shown below: Zn→Zn2++2e- The work done by the battery is, W=E∆Q The charge…

Q: Analog signal may be converted into digital signal by a. Sampling b. Amplitude modulation c.…

Q: For the circuit shown below, The current (1) can be calculated as: Vin O a. Vin O b. O C. Vin R1 O…

A: Given, The circuit shown

Q: Calculate the percentage slip of an induction motor having 6 poles fed with 50 cycles supply…

Q: If an aluminum sheet is held between the poles of a largebar magnet, it requires some force to pull…

A: When the aluminum sheet is held between the poles of a large bar magnet even though the sheet is not…

Q: V R ww 2₁ + Vcc Vo - ↓ A ww Q2 R V+ -VEE 1. Show that the voltage VO has the form: Vo = R*IA*tanh(Vd…

Q: Find the Z parameters of the network shown in Fig. 3.

Q: Find the minimum value of Kt

Q: A small signal equivalent circuit of single common-emitter amplifier is hown in Figure Q1.b with…

Q: There are two different box answers, which is the final answer?

A: According the 1st question which was solved by one of the expert ,he give two answers for first…

Q: Make an active bandpass filter to pass frequencies between 250Hz and 3000 Hz with a magnitude gain…

Q: Express the answers in polar form! Find Thevenin's resistance. 25/30° V j20 Ω m 10 Ω 10 Ω οι

A: Given,

Q: 1. For the circuits (a) through (d) in the figure below (Figure 1). Assume a = 50, and Varl = 0.7…

Q: For the circuit shown, calculate the magnitude of line current at line Bb

A: It is given that:

Q: Find Thevenin's resistance.

Q: 1. Discuss the functions and application of at least 3 protective relays that are being used in 13.2…

A: The protective relays in an Electrical distribution system are used for preventive management of…

Q: A series RLC circuit has a resistance of 60 ohms, a capacitance of 10-2 Farads, an inductance of 5…

A: Given: Series RLC circuit with R=60 Ω,L= 5 H and C=10-2 FaradsVoltage source V=20sin5t

Q: For the circuit shown, calculate the magnitude of line current at line Aa. TAG EAB = 208 V 0° ECA =…

Q: R₁ 5.0 Ω a R₂ 78 Ω U Τ Εξ Εξ 0.1002 Τη ww 0.50 Ω 1005 Ω h R₂ Μ 40 Ω R₂ - 20 Ω e *0.20 Ω ΣΑ

Q: A load impedance ZL = 200 + J160Ω must be married on a 100Ω line using an open parallel estub tuner.…

A: A load impedance ZL=200+j160 Ω must be matched on a 100 Ω line using an open parallel stub. We need…

Q: 1.2 mA 177 3 ΚΩ AM Given the current to voltage converter, determine the load voltage.

Q: how many luminaires are required?

A: Here given amount of luminaries is of size 40ft by 20ft in meter 12.1m by 6m and as you mentioned…

Q: Determine the current I in the given circuit, using the superposition theorem 3Ω Μ 10 V 1Ω 19 ΖΩ ww…

A: When multiple source act on circuit then circuit parameter can be obtained by using superposition…

Q: QUESTION 7 Give the decimal equivalent of the binary number 101.101

A: Given, The binary number is 101.1012

Q: One of the disadvantages of PCM is

A: The correct option along with the explanation is provided in the following section.

Q: 3E

A: Nyquist Stability Criterion can be expressed as: Z = N + P Where: Z = number of roots of 1+G(s)H(s)…

Q: Three-phase unbalanced currents are: la 20 cis(-45°); 10; 1= 20 cis (60°). What is the phase b…

Q: 2000 G (s) = (8²+48+81) (c) Low Frequency Phase = ? ° (d) High Frequency Phase = ? ° (e) Frequency 2…

A: Given: Gs=2000s2+4s+81

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Find the capacitance (in units of pF)
of a parallel plate capacitor that is
made of two parallel plates that have
each an area of 7.6 X10-4 m² and
separated by 2.4 mm sheet of Mylar
(K=3.2). use &o =
8.8542x10-12 F.m-1.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
List the five capacitor replacement rules.
Capacitors C1 = 10.33 uF and C2 = 10.77 uF are connected in series. After some time, the engineer decided to connect capacitor C3 = 4.93uF across C1 and C2. Find the total charge, in uC, of the group of capacitors if they are connected across 18.13 V battery.
Find the voltage across and the charge on each capacitor in the following network. C₁ C3 300 pF 500 pF- QT = 18000 PC C2 C4 600 pF 500 pF-
Find the capacitance (in units of pF) of a parallel plate capacitor that is made of two parallel plates that have each an area of 7.6 X10-4 m² and separated by 2.4 mm sheet of Mylar (K=3.2). use &o = 8.8542x10-12 F.m-1.
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW