5. When the current through an inductor is cut in half, the amount of energy stored in electromagnetic field. is 6. What is the inductance of 5H and 100 milli H coil connected in parallel. 7. If your wish to increase the amount if current in a resistor form 120Ma to 160Ma by changing the 24V source, what should the new voltage setting be?

5. When the current through an inductor is cut in half, the amount of energy stored in electromagnetic field. is 6. What is the inductance of 5H and 100 milli H coil connected in parallel. 7. If your wish to increase the amount if current in a resistor form 120Ma to 160Ma by changing the 24V source, what should the new voltage setting be?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
1. A purely resistive circuit the current is leading by 90° with respect to voltage. 2. A purely inductive circuit the current is lag behind the voltage by 90°. 3. A purely capacitive circuit the current is lead by 90° with respect to the voltage. 4. A capacitor element stored magnetic energy. 5. An inductor element stored electrical energy. 6. Resistor elements consume power. 7. Angle between current and voltage is called power. 8. The power factor angle for a purely resistive is zero. 9. The power factor angle for a purely inductive load is -90°. 10. The power factor of a purely capacitive is leading.
C) A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad. The full scale deflection is 110°. Determine the inductance of the instrument while measuring a current of 20 A. The mutual inductance at 0° deflection is 4 u H and the change in mutual inductance is linear with the deflection.
How much is the inductance of a coil that induces 500 V when thje current changes at the rate of 5 mA in 2-µs?
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
5. What capacit in series with a 1.5-k2 resistor will draw 50 mA from a 120-V, 60-Hz source?
When the switch is closed in above circuit, what is the voltage on the inductor, resistor R1 and R2 after 2.2us , assuming 0 V on the inductor to start?
Calculate the voltage at 1.5¹ (milliseconds) for the following RC Circuit. Assume switch is closed and capacitor is in a charge state. t=0 LE -10 V oto R1 1kQ C1 1uF
An iron ring elecromagnet has a relative permeability of 1250 when it is excited by a coil having 500 turns at 0.8 A. the mean length of iron parts is 48 cm, the cross-section of the core is 10 square cm and the air gap is 0.5 cm. What is its total reluctance?
AC Circuits Sine-wave generator f- 25 kHz V₁ = 3.0 V VR 888 100 mH Figure 6-Test Circuit 3. Using a two-channel oscilloscope, measure the peak-to-peak voltage VR across the resistor and the peak-to-peak voltage VL across the inductor. Measure the voltage across the inductor using the difference technique described in a previous experiment. Record the voltage readings in Table 2. VL 10 k 1 XL Table 2- Measured and Calculated Values (f = 25 kHz) ZT
Electrical Engineering I'm reading about the electronics in touch screen. It says when i touch the panel it distorts the electrostatic field and thus will have a change in capacitance. This is how it detects My question is the electrostatic field same as electric field? Please explain in details How did the capacitance change when i just touch the panel
How much voltage is taken by capacitor #4 (c4)? Select one: a. 7.2 volts b. 6.36 volts c. 5.65 volts d. 4.8 volts