An iron ring elecromagnet has a relative permeability of 1250 when it is excited by a coil having 500 turns at 0.8 A. the mean length of iron parts is 48 cm, the cross-section of the core is 10 square cm and the air gap is 0.5 cm. What is its total reluctance?

Q: Determine the following DC: Vg Vgs Idq Ie Ib Ic Vd Vc Vb Vds

A: The required parameters can be calculated by using DC analysis of cascaded amplifier circuit.

Q: State and explain the two parameters that characterise the design core thermal performance of a…

A: It is asked to state two parameters that characterize the design core thermal performance of a power…

Q: a) The network shown in Figure 1 has a total active power of 2253 W. Determine: i) the total…

A:

Q: Question 1: A) Derive the transfer function of the electrical circuits shown in Figure below and…

A:

Q: HWI/ Consider the unity-feedback system with the open loop transfer function: 1 G(s) = = s+5 Obtain…

A:

Q: na has a Gain of 30dB. What is the EIRP with 1mW input power if the transmission line insertion loss…

A: Given, Antenna gain, Ga=30 dB Input power, PT=1 mW=10-3 W=-30 dB Transmission line insertion loss,…

Q: Determine the approximate amount of collector current for this transistor circuit, given the…

A:

Q: 4. A 3-phase bundled transmission line of 200 km length consists of three ACSR conductors as shown |…

A:

Q: 1. The position of a point in cylindrical coordinates is specified by (4,2π/3,3). What is the…

A: given the position of the point in cylindrical coordinates is specified by  4 , 2π3 , 3 generally in…

Q: A capacitor is connected to an AC square wave voltage source and a resistor, thus realising the…

A: The value of resistor can be calculated by using transient analysis of RC circuit.

Q: Determine Zi, Zo, and Vo for the network of Figure below if Vi = 4 mV, VGso = -0.95 V +15 V 3.3 k

A: The required parameters can be calculated by using the AC analysis of the amplifier circuit.

Q: 1. Compare the methods for power transmission with respect to usage, cost, connection, stability,…

A: Transmission Line: A transmission line is a specialized cable or other structure used in electrical…

Q: The full-load copper losses and iron losses of a transformer are 6400 W and 5000 W respectively. The…

A: Given, Full load copper loss, Pcufl=6400 W Full load Iron loss, Pifl=5000 W Load factor at half…

Q: VII. PROBLEMS : 1. The IR drop in the line due to the reactive current is one disadvantage of low…

A: In this question we will write why low power factor load is undesirable...

Q: 1. In Fig. 4.19, solve for RT, IT, 12, 14, and P₁ R₁-750 R₂ = 1500 www V, 12V R-3300 Figure 4.19…

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: Find the Transfer Function of the system modeled by the following differential equation: dy(t)…

A:

Q: Q8- The electric field intensity of a linearly polarized uniform plane wave propagation in the +z…

A:

Q: Q3: Design a full adder with two 4/1 MUX.

A:

Q: A four-pole, lap-would DC machine has 462 conductors in the armature. The average flux per pole is…

A: Given a DC machine with, Number of pole, P = 4 Lap wound, so number of parallel path, A = P = 4…

Q: b) A 20kVA 8000/277V distribution transformer has the following resistances and reactances: Rp = 320…

A: This question is related to single phase transformers

Q: if an input signal ranges from 20-40 UA * (microamps), with an output signal ranging from .5-1.5 mA…

A:

Q: Determine the collector bias current. Assumeß = 50 and IS = 10^(-17)A

A:

Q: 9. Compute the bias point of the circuit depicted in Figure Vcc= 2.5 V 100 k 23 1 ΚΩ Ка + 0.5 V-…

A:

Q: 1. The position of a point in cylindrical coordinates is specified by (4,27/3,3). What is the…

A:

Q: A 50-horsepower, 460V, 60Hz, 3-phase induction motor has a Nameplate Rating of 60 amperes. The…

A: Given information, Rated output power is P=50 HP. The rated voltage is VL=460 Volts. Three-phase…

Q: Explain the operation of both signal- and three-phase rectifier circuit by making reference to the…

A: Three Phase Rectifier: The technique of transforming a balanced 3-phase power supply into a fixed…

Q: A 500 hp, 3-phase, 440 V, 50 Hz induction motor has a speed of 950 rpm on full-load. The machine has…

A:

Q: What the range of values of Vi that will maintain the Zener diode in the "on" state. R "L + 220 Ω P…

A:

Q: Find I in the circuit shown in the figure below using superposition. 6 ki 2 kf2 2 kil www 30 V (+ 12…

A:

Q: * The device (or element) that used to protect electronic components which are vulnerable to reverse…

A: The device that used to protect electronics components which are vulnerable to reverse voltage is…

Q: A 50-horsepower, 460V, 60Hz, 3-phase induction motor has a Nameplate Rating of 60 amperes. The…

A: Given information, Rated output power is P=50 HP. The rated voltage is VL=460 Volts. Nameplate…

Q: circuit is used to shift vertically of the input signal. Your answer

A:

Q: O27.00v to 56.8v Find the current through the diode in the circuit shown. Assume the diode to be…

A:

Q: circuit is used to shift vertically of the input signal.

A:

Q: The effective resistance seen looking into the primary of a 15: 1 transformer connected to an 8 Q…

A:

Q: Find the particular solution of the differential equation y" + 16y=cos² (x) yp Acos (2x) + B sin…

A:

Q: The area of cross-section of copper wire is 3 x 10-6 m². It carries a current of 4.2 A. Calculate…

A:

Q: The transfer functions of two compensators are given below: G₁ (8) = 10(s+1) (s+10) and G₂ (s) =…

A: Given, The transfer function of two compensators G1s=10s+1s+10G2s=s+1010s+1

Q: * For the circuit shown determine D1 current (ID1.) 330 11 R ID1 ID2 D2 Si Vo 16.7 mA O 28.2 MA O…

A: given here diode based circuit and asked to determine the current through the diode D1 .

Q: Q.3: For the magnetically coupled circuit shown, find the values of coupling coefficient "k" when…

A:

Q: jwL j48 1) [5pts] Determine the steady-state voltage v(t) in the circuit below. 40 cos(250t -15°) V…

A:

Q: ILS gives lateral and vertical guidance towards the runway To use ILS aircraft must contain the…

A: ILS stands for instrument Landing system these are for aircrafts while landing it helps to provide…

Q: (s + 1) 100 s² + 110s + 1000 A) Find the factors of Bode stander transfer function? B) For each…

A:

Q: In this Design, the value of RB is determine +Vcc Relay coil 2₂ RB Intensity of illumination 2₁ Ο ΙΕ…

A: Consider the given diagram for the transistor with the photo-transistor.

Q: Determine VCB in the transistor circuit shown. The transistor is of silicon and has 3 = 150. Rc 100…

A:

Q: An AM-DSB-LC modulator has a carrier frequency of (fc) Hz, with amplitude of (Ac) volt, and the…

A:

Q: Q8- The electric field intensity of a linearly polarized uniform plane wave propagation in the +z…

A:

Q: 4. A certain load takes 10 kw at 75% pf. In the power contract, the pf penalty is applied only to…

A:

Q: Find I in the circuit shown in the figure below using superposition. 6 kil 2 kft 2 kf2 30 V + 12 ks…

A: In this question we need to find a current Io by using superposition . In superposition principal we…

Q: = Determine Zi, Zo, and Vo for the network of Figure below if Vi= 4 mV, Vaso = -0.95 V derive the…

A: