Answered: 3. The uniform bar has a mass m and…

3. The uniform bar has a mass m and length /. If it is released from rest when 0 = = 0°, determine its angular velocity as a function of the angle before it slips. 2/3 3

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The small end rollers of the 6.2-lb uniform slender bar are constrained to move in the slots, which lie in a vertical plane. At the instant when e = 30°, the angular velocity of the bar is 2.6 rad/sec counterclockwise. Determine the angular acceleration of the bar, the reactions at A and B, and the accelerations of points A and B under the action of the 5.1-lb force P. Neglect the friction and mass of the small rollers. The angular acceleration is positive if counterclockwise, negative if clockwise. The acceleration of A is positive if downward, negative if upward. The acceleration of B is positive if down the slot, negative if up the slot. The reaction at A Is positive If to the right, negative If to the left. The reaction at 8 Is positive If up and to the right, negative If down and to the left. L= 5.2 ft 107 P= 5.1 lb Answers: Jad/sec? F = Fg =
The 23-kg uniform thin hollow square plate is pinned at point O, and its side L = 0.3 m. If it is subjected to the constant moment M = 82 N·m and is released from rest from the position as shown, determine its angular velocity W (in rad/s) when it has rotated 45 Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. Take g = 9.81 m/s². M Your Answer: Answer
If P = 30 lb, determine the angular acceleration of the 50-lb roller. Assume the roller to be a uniform cylinder and that no slipping occurs
The 18-kg rod AB is pin-connected at A and subjected to a couple moment of M =15 N- m The rod is released from rest when the spring is unstretched at 0 = 30°. As the rod rotates, the spring always remains horizontal, because of the roller support at C. (Figure 1) Determine the rod' s angular velocity, measured clockwise, at the instant 0 = 60°. Express your answer using three significant figures. Enter positive value if the angular velocity is clockwise and negative value if the angular velocity is counterclockwise. vec rad/s k = 40 N/m 0.75 m M = 15 N- m
1000 lb -8 ft +2ft A beam that weighs 300 lbs is supported by a roller and pin B and A respectively while being subjected to a force of 1000 lbs. If the pin at A is suddenly removed, determine the beams angular acceleration, the force exerted by support B and the horizontal acceleration just after A is removed. Assume the beam is a slender rod of negligible thickness. Please don't use angle measurements when solving. Use the 3-4-5 triangle to solve, if that makes sense. Thank you! Choutranco impgo tout
The system is made up of the 1-m, 6.5-kg uniform rod AB and the two uniform disks (each of 0.19 m radius and 1.5 kg mass). If the system is released from rest when = 80°, when rod AB has just become horizontal, determine the coefficient C in the expression Cw² which is the kinetic energy of rod AB at this instant. Assume the disks roll without slipping. Your answer must include 2 places after the decimal point. Please pay attention: the numbers may change since they are randomized. AB' Take g= 9.81 m/s². A-L B m Your Answer: Answer
The racing vehicle has a mass of 750 kg and center of mass in G. If there is no slippage, determinate the normal reaction, in Newtons, presented on each of the front wheels in A, when an acceleration of a = 6.4 m/s².
The uniform 50-kg sphere has radius r = 0.2 m and is welded to the center of the uniform 30-kg shaft as shown. When a constant couple moment M is applied to the shaft, its angular velocity reaches 74 rad/s after 4 s. Determine the magnitude of the moment M. Write your answer in N.m but do not write the units. M R= 0.1 m Taylor e m Te am Answer: Answer
The spring-mounted 0.89-kg collar A oscillates along the horizontal rod, which is rotating at the constant angular rate θ˙=8.2θ˙=8.2 rad/s. At a certain instant, r is increasing at the rate of 700 mm/s. If the coefficient of kinetic friction between the collar and the rod is 0.63, calculate the friction force F exerted by the rod on the collar at this instant.
1- The bucket is hoisted by the rope that warps around a drum wheel. If the angular displacement of the wheel is 9 =(3t2-7t) rad, where t is in seconds, determine the velocity and acceleration of the bucket when t= 5 sec
The pavement compactor is traveling down the incline at VG = 5 ft/s when the motor is disengaged. The body of the compactor, excluding the rollers, has a weight of 8000 lb and a center of gravity at G. Each of the two rear rollers weighs 400 lb and has a radius of gyration of KA = 3.3 ft. The front roller has a weight of 800 lb and a radius of gyration of kg = 1.8 ft. The rollers do not slip as they rotate. (Figure 1) Figure 3.8 ft 5 ft A GT 10 ft 1 of 1 30 730 ▼ Part A Determine the angular velocity of the roller B when the compactor has traveled 16 ft down the plane. Express your answer in radians per second to three significant figures. WB = Submit IVE ΑΣΦ | Η Provide Feedback Request Answer P Pearson vec ? rad/s Next >
The uniform 80 kg slender rod is at rest in the position shown when P = 450 N is applied. Determine the value of angular velocity, w2 the rod if L1 = 5.5 m and L2 = 6.5 m. A L L2 L1 B