3. At 2:00P.M, a thermometer reading is 80°F is taken outside where the air temperature is 20°F. At 2:03P.M, the thermometer reading yielded by the thermometer is 42°F. Later, the thermometer is brought inside where the air is at 80°F. At 2:10P.M, the reading is 71°F. When was the thermometer brought indoors?

3. At 2:00P.M, a thermometer reading is 80°F is taken outside where the air temperature is 20°F. At 2:03P.M, the thermometer reading yielded by the thermometer is 42°F. Later, the thermometer is brought inside where the air is at 80°F. At 2:10P.M, the reading is 71°F. When was the thermometer brought indoors?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter6: Fundamental Dimensions And Units

Section: Chapter Questions

Problem 20P

See similar textbooks

Similar questions

During the midday 2pm, the temperature of the water that is left out on a table is 18° If the temperature of the surrounding is 34°C and the water’s temperature heated up to 26°C at 2:25pm. After how many minutes will the water’s temperature be 32°C?
A steel tape is 30 meters long at 20 degree Celsius with a pull of 60 N. A rectangular lot is measured using this tape. The sides are recorded as 145 meteres and 113 meters. The average temperature of the tape during measurement is 29.4 degree Celsius with a pull of 60 N.
A thermometer reading is 60oF at 3:00 AM and a Civil Engineering student takes it outside where the air temperature is 20oF. At 3:10, the reading is 30oF. At 3:15, the thermometer is taken back indoor where the thermometer is 60oF. What is the thermometer reading at 3:20AM. a. What is the value of the constant of proportionality? b. The temperature of the thermometer at any time t is given by ____________?
4.2. What is the normal range of the air relative humidity for residential premises? Choose the correct answer:1. 20-40%;2. 20-50%;3. 30-60%;4. 35-70%;5. 40-80%;
A thermometer reading 18°F is brought into a room where the temperature is 70°F. One minute later the thermometer reading is 31°F. Determine the: a) temperature reading as a function of time b) temperature reading 5 minutes after the thermometer is first brought into the room.
A reporter carried an aneroid barometer from the ground floor to his office atop a building. On ground floor, the barometer read 30.15 in. Hg absolute while on the top of the building, it read 28.607 in. Hg absolute. Assume that the average atmospheric air density was 0.075 lb/ft3 and estimate the height (in feet) of the building.
Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1500 m into the atmosphere. The total pressure is 100 kPa, air temperature is 28°C and the dew point temperature is 16°C near the ground, the lapse rate 6°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Relative Humidity at 1500m, in % Round to one (1) decimal place
Sanitary Engineering laboratory the test " Relative Humidity of Air" discuss
Sanitary Engineering laboratory the test " Relative Humidity of Air" help me
A room 3 m X 6 m X 10 m has walls of average absorptivity 0.05. The floor is covered with a rug (a = 0.6), and the ceiling is wood (a = 0.1). ( a ) Calculate the average absorptivity. (b) Calculate the reverberation time from (12.3.4). (c) Calculate the reverberation time from (12.4.2) and compare with the answer to (b).
A weatherman carried aneroid barometer from the ground floor to his office atop in the SEARS TOWER in Chicago. On the ground level, the barometer read 29.78 in.Hg. Absolute, topside it read 28.60 in. Hg. Abs. Assume that the averages atmospheric air density was 0.075 lb/ft 3 and estimate the height of the building. Ans. 1113.112 ft. approx. Please give me the solution.
Calculate the AQI and give a description of air that contains 5 ppm CO (8-hour average), 300 pg/m3 PM-10 {24-hour average), and 0.10 ppm SO2 (24-hour average).