During the midday 2pm, the temperature of the water that is left out on a table is 18° If the temperature of the surrounding is 34°C and the water’s temperature heated up to 26°C at 2:25pm. After how many minutes will the water’s temperature be 32°C?

During the midday 2pm, the temperature of the water that is left out on a table is 18° If the temperature of the surrounding is 34°C and the water’s temperature heated up to 26°C at 2:25pm. After how many minutes will the water’s temperature be 32°C?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A 50-L electrical radiator containing heating oil is placed in a 50-m³ room. Both the room and the…

A: Heater is kept on approximately 41 minutes Thankyou! Feel free to ask if you have any…

Q: Sanitary Engineering laboratory the test " Relative Humidity of Air" discuss

Q: Problem 8 Water enters the tubes of a cold plate at 65°C with an average velocity of 50 ft/min and…

Q: A hot pie that was cooked at a constant temperature of 325° F is taken directly from an oven and…

Q: A well-insulated and perfectly sealed room is installed with 4-hp fan to circulate air for 1.5…

Q: The air coming out of the distillery has 60% relative humidity. How much water will you need to…

A: Consider the given data The air coming out of the distillery has 60% relative humidity 0.69g/kg…

Q: Given inside and outside design temperature, 5°C, 23°C, respectively. The temperature of an unheated…

A: Given: The inside design temperature is 5oC. The outside design temperature is 23oC.

Q: room 3.6m x 5m x 8m fully replaces inside air after 3 hours. If the temperature from the outside is…

Q: Problem 3 Refrigerant-134a enters a diffuser steadily as saturated vapor 500 kPa with a velocity of…

Q: A water well is 6.2 meters deep. If the temperature at the bottom of the water, 16°C and at the…

Q: Find the dew point temperature for the following air/water vapor mixture for 85°F dry bulb and 50%…

A: Given data- Current temperatue(T)=85oFRelative Humidity(RH)=50% To Find- The dew point temperature.

Q: At a certain station, the mean of the average temperature is 25° C and mean of the maximum daily…

Q: At 9:00PM., a thermometer reading 70oF is taken outdoors where the temperature is 15oF. At 9:05PM.,…

Q: At a climate station, air pressure is measured as 100 kPa, air temperature as 24°C, and the wet-bulb…

Q: What is the thermometer reading at 1:09 P.M.?

A: This question is based on Newton's law of cooling

Q: 8. Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1800…

A: The height into the atmosphere = 1800 mThe total pressure = 101 kPaThe air temperature = 25°CThe dew…

Q: Which of the following pans gives the best representation of the lake evaporation? Select the…

A: Ans = USGS floating pan. Out of all options usgs floating pan gives best representation of lake…

Q: At 10 A.M. a woman took a cup of hot instant coffee from her microwave oven and placed it on a…

Q: Thermal Loading Calculation: Roof Cooling Load A 56 ft. by 82 ft. roof on a building in Miami, FL is…

A: Size of roof thickness of lightweight concrete used inside air temperature

Q: Problem 8-10) Consider 2 kg of air has a decrease of internal energy of 25 kJ during a reversible…

A: To solve this problem, we will use the reversible non flow isobaric formula. The value of Cv will be…

Q: Turnover time for the humidity in the atmosphere is equal to? A- Evapotranspiration rate/volume of…

A: Given data : - Turnover time for the humidity in the atmosphere is equal to? A- Evapotranspiration…

Q: saturated) it is at 68°F (barometer reads 745 mmHg), what percent

A: data given Barometric pressure at 90 F , P1 =739mm HgBarometric pressure at 68 F , P1 =745 mm Hg…

Q: urface where temperature is 18°C. If the volume increases by 88.39% upon reaching he water surface.…

Q: Calculate the AQI and give a description of air that contains 5 ppm CO (8-hour average), 300 pg/m3…

A: AQI : AQI means Air Quality Index which is a measurement of various pollutants that are present in…

Q: A tank 200 liters of fresh water . BRINE containing 2kg/liter of salt enters the tank at the rate of…

A: A tank system is important in fluid mechanics for its discharge of flow and to maintain a proper…

Q: *1-8. The bottle tank has a volume of 1.12 m³ and contains oxygen at an absolute pressure of 12 MPa…

Q: What is passive cooling of buildings? explain various passive cooling technologies with the help…

A: Passive cooling of building: Passive cooling can be an alternative cooling system of the building…

Q: A mains fed 12000 litre tank supplies hot rinse water (450C) for a food processing operation.…

A: Answer We are given Volume of water = 12000 litre Required raised temperature = 45oC Given time = 3…

Q: A filter press with an effective filtering area between 350m^2 operates constantly maintaining a…

A: The objective of the question is to calculate the filtration velocity at a given time (t=120m) for a…

Q: Determine the correction due to temperature.

A: solution Given Length L = 100.000mts co-efficient of linear expannsion α=11.6×10-6/°Cmean…

Q: Convert a (15.5 °C+ 17) temperature into °F temperature.

A: The temperature in degree Celcius with a constant (15.5 °C+ 17) As we know, °F-32180=°C100

Q: 14. A fire detector cannot detect: A. O Radiation А. В. O Heat С. O Light D. O Smoke

A: Fire detector cannot detect

Concept explainers

Temperature as a Fundamental Dimension

There are certain rules to write dimensions of a physical quantity using the fundamental dimensions. They are outlined below.

Question

During the midday 2pm, the temperature of the water that is left out on a table is 18° If the temperature of the surrounding is 34°C and the water’s temperature heated up to 26°C at 2:25pm. After how many minutes will the water’s temperature be 32°C?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1800 m into the atmosphere. The total pressure is 101 kPa, air temperature is 25°C and the dew point temperature is 15°C near the ground, the lapse rate 7.5°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Relative Humidity at 1500m, in % Round to one (1) decimal place Add your answer
2- A 25 ml water sample is placed in a dish that wt. 50g, after evaporation and drying at 103°C, and cooling in desiccator, the dish wt. 50.02g. Then the dish is fired at 5500 C for one hour, after which it weight 50.005g. Estimate in (mg/l): volatile solids (VS) and fixed solids (FS) of the water sample.
Water initially contains 140 L of water. Now equal rates of cold and hot water enter the tank for a period of 30 minutes while warm water is discharged from the tank at a rate of 25 L/min. The amount of water in the tank at the end of 30 min period is 50 L. The rate of hot water entering the tank in L/min is _____. Include the diagram in your solution. A.11 B.25 C.7 D.5
Determine the height of the building in feet, if the barometer reading at the top of the building is 751 mmHg while the barometer reading at the bottom of the building is 101,325 Pa. Assume the density of the air is 1.8 kg/m³ and that of mercury is 13,600 kg/m³.
Please provide a clear and complete solution. Answer quickly for I have 30 minutes left. Thank you.
A small metal bar, whose initial temperature was 20° C, is dropped into a large container of boiling water. How long will it take the bar to reach 90° C if it is known that its temperature increases 2° in 1 second? Select the correct response: 83.2 sec 88.2 sec 82.1 sec 75.2 sec none of the choices
Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1800 m into the atmosphere. The total pressure is 101 kPa, air temperature is 25°C and the dew point temperature is 15°C near the ground, the lapse rate 7.5°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Air Density at 1500m, in kg/m³ Round to three (3) decimal places Add your answer
11-3. A water treatment plant is designed to treat a flow of 20,000 m³/day. The chlorine dosage is 1 mg/L. What size containers should be used in this plant? What is the minimum weight of chlorine which should be kept on hand? 11-6. Estimate the energy cost to disinfect the flow of radiation. The water, film is 100 mm thick. Solve 11-3 nt for using ultraviolet
Environmental engineering sol
I need the answer as soon as possible
1 Which of the following produces pure water day and night? a. Passive solar water still b. Solar dryer c. Forced circulation water heater d. Active solar water still
What is the airport reference temperature, if the monthly mean of average daily temperature for the hottest month of a study year = 24°C and the monthly mean of the maximum daily temperature for the same month of the same year = 30°C