10 ig Vo 2V Z #1V Sine wavel if vr=0, rf=1D, Q. Vo, Lo., LP₂ = ?

Give me the wave diagram with the solution not just a theoretical solution Vin +154 Ri=9kn +12v Vo 20vp.p. 20VP.P. R2=1Kn -12V Drwa the output wave

A full-wave rectified voltage of 18 V peak is connected to a 400micro F filter capacitor. What are the ripple and dc voltages across the capacitor at a load of 100 mA?

Draw a square wave and point out or Label the amplitude, duty cycle, and period of the waveform. Draw a “high sweep-rate" image of a square pulse and indicate by labeling its overshoot, pulse width, rise-time and fall-time and the points on the waveform where these values are measured. Name and Draw a square wave that has a 25% duty cycle, a 1 Vpeak voltage, and a 10 mSec period.

You have a complex waveform made up of a 500 Hz signal with an 8Pa peak amplitudeand 0 deg starting phase and a 1000 Hz signal with a 2Pa peak amplitude and 90degstarting phase.a.What is the amplitude of the complex waveform at 15ms?

H.W: A resistor of resistance R=1000 2is maintained at 17 °C and it shunted by 100 uH inductor. Determine the ms noise voltage across the inductor over a frequency bandwi dth of: Ans: 182 x10° volt Ans: 9.22 x10 volt Ans: 2.34 x10 volt i) 15.9 kHz ii) i) 159 kHz 1590 kHz

Determine the waveform, theoretical, of the peak output voltage at Resistor L. 120 V rms 5:1 ooooo elele D₁ D3 D21 DA 4 R₁ WWW II Vout

Two voltage waveforms are displayed on CRO as shown in Figure A6. The vertical sensitivity is 5V/DIV and the timebase is 1ms/DIV. Determine: (a) the peak-to-peak voltage displayed in Channel 1; (b) the phase angle difference between two voltage signals. Channel M Channel 2

A triangular pulse waveform is shown in figure by waveform analysis draw the component function and write the corresponding equation of the component function. ( Proper steps)

Q/ Draw the input and the output waveform of the circuit below and analyze the signal flowing in both half-cycles Using two different colors, and label the voltage on the waveform, then determine Vay and Vrms (Vin=5V, frequency= 1kHz) 17 ww