(a) Interpretation: Calculate the Percentage of excess air feed to reactor? Concept introduction: CO is burned with excess air at 1 atm. Reactant enters at 25°C and leaves at 1500 °C. One carbon oxide molecule plus half oxygen molecule will give one carbon dioxide molecule. Using this concept, we will find out excess air feed to reactor.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 9.73P

Interpretation Introduction

(a)

Interpretation:

Calculate the Percentage of excess air feed to reactor?

Concept introduction:

CO is burned with excess air at 1 atm.

Reactant enters at 25°C and leaves at 1500 °C.

One carbon oxide molecule plus half oxygen molecule will give one carbon dioxide molecule.

Using this concept, we will find out excess air feed to reactor.

Interpretation Introduction

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A chemical reaction takes place in a container of cross-sectional area 50.0 cm2. As a result of the reaction, a piston is pushed out through 15 cm against an external pressure of 121 kPa. Calculate the work done (in J) by the system.

Example 7.2 Steam is generated in a high pressure boiler containing tubes 2.5 m long and 12.5 mm internal diameter. The wall roughness is 0.005 mm. Water enters the tubes at a pressure of 55.05 bar and a temperature of 270°C, and the water flow rate through each tube is 500 kg/h. Each tube is heated uniformly at a rate of 50 kW. Calle (a) Estimate the pressure drop across each tube (neglecting end effects) using (i) the homogeneous flow model and (ii) the Martinelli-Nelson correlation. (b) How should the calculation be modified if the inlet temperature were 230°C at the same pressure?

Please solve this question by simulation in aspen hysys

Answer 2

Question

Chapter 9, Problem 9.73P

Interpretation Introduction

(a)

Interpretation:

Calculate the Percentage of excess air feed to reactor?

Concept introduction:

CO is burned with excess air at 1 atm.

Reactant enters at 25°C and leaves at 1500 °C.

One carbon oxide molecule plus half oxygen molecule will give one carbon dioxide molecule.

Using this concept, we will find out excess air feed to reactor.

Interpretation Introduction

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 3

Question

Chapter 9, Problem 9.73P

Interpretation Introduction

(a)

Interpretation:

Calculate the Percentage of excess air feed to reactor?

Concept introduction:

CO is burned with excess air at 1 atm.

Reactant enters at 25°C and leaves at 1500 °C.

One carbon oxide molecule plus half oxygen molecule will give one carbon dioxide molecule.

Using this concept, we will find out excess air feed to reactor.

Interpretation Introduction

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 4

Question

Chapter 9, Problem 9.73P

Interpretation Introduction

(a)

Interpretation:

Calculate the Percentage of excess air feed to reactor?

Concept introduction:

CO is burned with excess air at 1 atm.

Reactant enters at 25°C and leaves at 1500 °C.

One carbon oxide molecule plus half oxygen molecule will give one carbon dioxide molecule.

Using this concept, we will find out excess air feed to reactor.

Interpretation Introduction

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 5

Chapter 9, Problem 9.73P

Interpretation Introduction

(a)

Interpretation:

Calculate the Percentage of excess air feed to reactor?

Concept introduction:

CO is burned with excess air at 1 atm.

Reactant enters at 25°C and leaves at 1500 °C.

One carbon oxide molecule plus half oxygen molecule will give one carbon dioxide molecule.

Using this concept, we will find out excess air feed to reactor.

Interpretation Introduction

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Answer 6

Chapter 9, Problem 9.73P

Interpretation Introduction

(a)

Interpretation:

Calculate the Percentage of excess air feed to reactor?

Concept introduction:

CO is burned with excess air at 1 atm.

Reactant enters at 25°C and leaves at 1500 °C.

One carbon oxide molecule plus half oxygen molecule will give one carbon dioxide molecule.

Using this concept, we will find out excess air feed to reactor.

Answer 7

Chapter 9, Problem 9.73P

Interpretation Introduction

(a)

Interpretation:

Calculate the Percentage of excess air feed to reactor?

Concept introduction:

CO is burned with excess air at 1 atm.

Reactant enters at 25°C and leaves at 1500 °C.

One carbon oxide molecule plus half oxygen molecule will give one carbon dioxide molecule.

Using this concept, we will find out excess air feed to reactor.

Answer 8

Interpretation Introduction

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Answer 9

Interpretation Introduction

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Answer 10

Expert Solution & Answer

Answer 11

Expert Solution & Answer

Answer 12

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 13

Ch. 9 - The standard heat of the reaction...Ch. 9 - Prob. 9.2P Ch. 9 - Prob. 9.3P Ch. 9 - The standard heat of the reaction...Ch. 9 - Prob. 9.5P Ch. 9 - Prob. 9.6P Ch. 9 - Prob. 9.7P Ch. 9 - Prob. 9.8P Ch. 9 - The standard heat of combustion of gaseous ethane...Ch. 9 - The standard heat of combustion (AH°) of liquid...

Solution Summary: The author explains how to calculate the percentage of excess air feed to reactor.

Concept explainers

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Want to see the full answer?

Chapter 9 Solutions

Solution Summary: The author explains how to calculate the percentage of excess air feed to reactor.

Concept explainers

(b) Interpretation: Change in adiabatic flame temperature if % of excess air increased. Concept introduction: Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.

Want to see the full answer?

Chapter 9 Solutions

(b)

Interpretation:

Change in adiabatic flame temperature if % of excess air increased.

Concept introduction:

Adiabatic flame temperature is inversely proportional to air flow rate, that is,if the percentage excess were increased, the adiabatic flame temperature would decrease.