All parameters associated with the instrumentation amplifier in Figure 9.26are the same as given in Exercise Ex 9.8, except that resistor
The value of maximum common mode gain.
Answer to Problem 9.72P
The maximum value of the voltage gain is
Explanation of Solution
Calculation:
The given diagram is shown in Figure 1
Mark the voltages and current and redraw the circuit.
The required diagram is shown in Figure 2
The expression for the voltage
The expression for the current at the node
Substitute
Apply KCL at the node
Substitute
The expression for the value of the current
The expression for the voltage
Substitute
The expression for the voltage
Substitute
Substitute
The expression for the common mode voltage is given by,
The expression for the differential voltage is given by,
The expression for the voltage
The expression for the voltage
Substitute
The general expression for the output equation is given by,
From above and from equation (3), the expression for the common mode gain is evaluated as,
Substitute
From above the range of the common mode voltage gain is given by,
The maximum value of the voltage gain is given by,
Conclusion:
Therefore, themaximum value of the voltage gain is
Want to see more full solutions like this?
Chapter 9 Solutions
MICROELECT. CIRCUIT ANALYSIS&DESIGN (LL)
- Calculate the total offset voltage for the circuit shown below for op-amp specification values of input offset values, VIO=2.8 mV and IIO=110 nA with RF=14000 ohm and Rin= 3000 ohm.arrow_forward3. A simple current bias reference circuit based on the base-emitter junction voltage is depicted in Figure 9.3. Determine the sensitivity S of the output current to supply voltage Vcc. It is given that Is = 5 x 10-15A and assume that VT = 26 mV. (Hint: Assume that Vcc >> VBE(on) and use this to simplify the calculation.) Vcc= 15 V I R₁ Q₁ 10 ΚΩ 22 J R₂ 1 ksz Figure 9.3arrow_forwardQ2// Answer the following questions about voltage-feedback bias circuit for the figure below. 1-Determine Ver and VCB. 2- What happens to the voltage Ve if the resistor Rp is open? 22 K 3- What might cause VCE to become nearly 9 V? 4- Determine the change in Ie from 25° to 75° C, if Ico 0.2 HA, and VBE = 0.7V. 10 ul B-80arrow_forward
- 10. Refer to the JFET transfer characteristic curve in Figure 9–16(a) and determine the peak-to- peak value of I, when Ves is varied ±1.5 V about its Q-point value.arrow_forwardA voltage follower is to be designed to provide a gain error of less than 0.005 percent. Develop a set of minimum required specifications on open-loop gain and CMRR.arrow_forwarda- Zero. b- Slightly different from zero. O Maximum positive or negative. d- An amplified sin wave. 9-Negative feedback reduces @ The feedback fraction. b- Distortion. c- The input offset voltage. d- The open-loop gain. 10-The input impedance of a current-voltage converter is Small. b- Large. c- Ideally zero. d- Ideally infinite. a- 11-In a linear op-amp circuit, the @ Signal are always sin wave. b- Op-amp does not go into saturation. c- Input impedance is ideally infinite. d- Gain-bandwidth product is constant.arrow_forward
- 9- Results and Discussion:- 1-what are the differences between the inverting and non-inverting operation amplifier? 2- The output signal of the inverting amplifier is out of phase with its input signal by a) 0° b)90° c)180° d)270° 3-what are the differences between the integrator and differentiator operation amplifier? 4-lf a triangle waveform is applied to the differentiator circuit. What is the output signal will be?arrow_forward1- Mention any two advantages of Integrated Circuit . 2- For the circuit given below : Vin is a sine wave Vinpp=6 V and Vref=-2.4 V , Assume Vsat=±12V Name the circuit and draw the input and output waveforms . Vin Vref 3- Explain why open-loop op-amp configurations are not used in linear applications? Draw the block diagram of opamp and define the function of each blockarrow_forwardIn the difference amplifier shown in Figurea) Compute the differential mode gainb) Compute the common mode gainc) the CMRRarrow_forward
- Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSONDelmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningProgrammable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
- Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill EducationElectric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSONEngineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,