Principles of Foundation Engineering (MindTap Course List)
8th Edition
ISBN: 9781305081550
Author: Braja M. Das
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
thumb_up100%
Chapter 8, Problem 8.10P
The subgrade reaction of a sandy soil obtained from the plate load test (plate dimensions 1 m × 0.7 m) is 18 MN/m3. What will be the value of k on the same soil for a foundation measuring 5 m × 3.5 m?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the
laboratory report stated that the Cc = 0.2, Cr = 0.04 and OCR = 4.5. The existing vertical effective stress in the
field was 130 kPa. A building foundation was designed to construct above the soil condition. This will increase
the vertical stress at the center of the clay by 150 kPa. The thickness of the clay layer is 2 m and its water
content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if
OCR value were 1.5 instead 4.5.
75% consolidation in a laboratory test?
11.21 Refer to Figure 11.48. A square foundation, 2.5 × 2.5 m in size, supports a col-
umn load of 478 kN. The soil characteristics are given in the figure. Field moni-
toring indicated that the foundation settlement was 46 mm at the end of 2 years
a. Estimate the average stress increase in the clay layer due to the applied load.
b. Estimate the primary consolidation settlement.
c. What is the degree of consolidation after 2 years?
d. Estimate the coefficient of consolidation for the pressure range.
e. Estimate the settlement in 3 years.
478 kN
2.5 m x 2.5 m
1.5 m
Y = 16 kN/m
GWT
1.75 m
Yu = 18.8 kN/m³
w = 19%
G, = 2.71
LL = 37
3.5 m
o = 65 kN/m?
C,= 1/SC.
%3D
O Sand A Clay
Figure 11.48
A square foundation, 2.5x2.5m in size, supports a column load of 478 kN. The soil characteristics are given in the following figure. Field monitoring indicated that the foundation settlement was 46mm at the end of 2 years.
(a) Estimate the average stress increase in the clay layer due to the applied load.
(b) Estimate the primary consolidation settlement.
(c) What is the degree of consolidation after 2 years?
(d) Estimate the coefficient of consolidation for the pressure range.
(e) Estimate the settlement in 3 years.
Chapter 8 Solutions
Principles of Foundation Engineering (MindTap Course List)
Ch. 8 - Prob. 8.1PCh. 8 - Following are the results of a standard...Ch. 8 - Repeat Problem 8.2 for an allowable settlement of...Ch. 8 - Prob. 8.6PCh. 8 - Prob. 8.7PCh. 8 - From the plate load test (plate dimensions 1 ft ×...Ch. 8 - Refer to Problem 8.8. If the full-sized foundation...Ch. 8 - The subgrade reaction of a sandy soil obtained...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.Similar questions
- From the plate load test (plate dimensions 1 ft × 1 ft) in the field, the coefficient of subgrade reaction of a sandy soil is determined to be 60 lb/in3. What will be the value of the coefficient of subgrade reaction on the same soil for a foundation with dimensions of 20 ft × 20 ft?arrow_forwardA plate loading test was carried out on a medium dense sand, using a 1 ft wide square plate, and k1 was determined as 350 lb/in3. Determine the coefficient of subgrade reaction for a 7.5 ft wide square foundation and a 7.5 ft × 10.5 ft rectangular foundation.arrow_forwardA 300 mm X 450 mm plate was used in carrying out a plate loading test in a sand, where the plate settled 5 mm under the applied pressure of 250 kN/m?. a. What is the coefficient of subgrade reaction for a 300 mm wide square plate? b. What would be the coefficient of subgrade reaction of a 2 m X 3 m foundation?arrow_forward
- A foundation (Figure 1) transmits a stress of 100 kPa on the surface of a soil deposit. a. Evaluate increases of vertical stresses points A, B, and C at the depth of 2m and Sm (2 points) b. At what depth is the increase in vertical stress below A less than 10% of the surface stress? 6 m +2 m- A 2 m -4 m- Figure 1: Plan of foundationarrow_forwardA foundation with dimensions BxL supporting a column load, P. The foundation rests on a sandy soil underlain by a clay layer (consolidation test result in Problem 2). • Estimate the primary consolidation settlement of the clay due to the foundation load. • What is the void ratio at the end of primary consolidation? • Calculate the secondary Consolidation settlement after 6 years knowing that the primary consolidation settlement took 2.5 years. Given: P = 350 kN, B =L=2.5 m, Df= 2 m, H1= 3 m, and H2=4.5 m. The soil properties are as follows: Sand: ya = 16.4 kN/m³; ysat = 18.8 kN/m³ Clay: Ysat = 17.6 kN/m²; eo = 0.82, Ca=0.02 Sand D Yd H GWT BxL Ysat Clay Ysat Sandy gravelarrow_forward10.10 A 300 mm × 450 mm plate was used in carrying out a plate loading test in a sand, where the plate settled 5 mm under the applied pressure of 250 kN/m². a. What is the coefficient of subgrade reaction for a 300 mm wide square plate? b. What would be the coefficient of subgrade reaction of a 2 m x 3 m foundation?arrow_forward
- Question 3 a) In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the laboratory report stated that the Ce= 0.2, C, -0.04 and OCR = 4.5. The existing vertical effective stress in the field was 130 kPa. A shallow foundation was designed to construct above the soil condition. This will increase the vertical stress at the center of the clay by 50 kPa. The thickness of the clay layer is 2 m and its water content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if OCR value were 1.5 instead 4.5.arrow_forwardA 300 mm 450 mm plate was used in carrying out a plate loading test in a sand, during which the plate settled 5 mm under the applied pressure of 250 kN/m2. a. What is the coefficient of subgrade reaction for a 300 mm wide square plate? b. What would be the coefficient of subgrade reaction of a 2 m 3 m foundation?arrow_forwardRefer to Problem 8.8. If the full-sized foundation had dimensions of 70 ft × 30 ft, what will be the value of the coefficient of subgrade reaction? 8.8 From the plate load test (plate dimensions 1 ft × 1 ft) in the field, the coefficient of subgrade reaction of a sandy soil is determined to be 60 lb/in3. What will be the value of the coefficient of subgrade reaction on the same soil for a foundation with dimensions of 20 ft × 20 ft?arrow_forward
- The initial principal stresses at a certain depth in a clay soil are 100 kPa on the horizontal plane and 50 kPa on the vertical plane. Construction of a surface foundation induces additional stresses consisting of a vertical stress of 45 kPa, a lateral stress of 20 kPa, and a counterclockwise (with respect to the horizontal plane) shear stressof 40 kPa. Determine the change shearing stress in kPa.arrow_forwardKINDLY GET THE REAL ANSWER WITH EXPLAIN STEP Given that B =1 m, L = 3 m, and Q = 110 kN, the soil characteristics given in the figure are Cs = 1/5 Cc, Ꝺ’c= 40 kN/m2. Field monitoring indicated that the foundation settlement was 19 mm during the first 12 months. Estimate the average stress increase in the clay layer due to the applied load. Estimate the primary consolidation settlement. What is the degree of consolidation after 12 months? Estimate the coefficient of consolidation for the pressure range. Estimate the settlement in 24 months.arrow_forward3. There is a rectangular foundation, foundation soil stratification, self-weight stress and additional stress calculation results are shown below (stress in kPa), foundation soil compression test results are shown in the following table, the requirement of the basic formula of one-way compression using the sum of stratification method to calculate the compression of the second layer of soil. Results of foundation soil consolidation test p (kPa) 0 200 e 1.00 First layer Second layer The third layer 50 34 48 0.93 0.85 0.80 18 100 26 27 35 150 52 100 0.4m 0.4m 0.6m 0.77 0.9m C C tarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Principles of Foundation Engineering (MindTap Cou...Civil EngineeringISBN:9781305081550Author:Braja M. DasPublisher:Cengage Learning
Principles of Foundation Engineering (MindTap Cou...Civil EngineeringISBN:9781337705028Author:Braja M. Das, Nagaratnam SivakuganPublisher:Cengage Learning
Principles of Geotechnical Engineering (MindTap C...Civil EngineeringISBN:9781305970939Author:Braja M. Das, Khaled SobhanPublisher:Cengage Learning
Fundamentals of Geotechnical Engineering (MindTap...Civil EngineeringISBN:9781305635180Author:Braja M. Das, Nagaratnam SivakuganPublisher:Cengage Learning
Principles of Foundation Engineering (MindTap Cou...
Civil Engineering
ISBN:9781305081550
Author:Braja M. Das
Publisher:Cengage Learning
Principles of Foundation Engineering (MindTap Cou...
Civil Engineering
ISBN:9781337705028
Author:Braja M. Das, Nagaratnam Sivakugan
Publisher:Cengage Learning
Principles of Geotechnical Engineering (MindTap C...
Civil Engineering
ISBN:9781305970939
Author:Braja M. Das, Khaled Sobhan
Publisher:Cengage Learning
Fundamentals of Geotechnical Engineering (MindTap...
Civil Engineering
ISBN:9781305635180
Author:Braja M. Das, Nagaratnam Sivakugan
Publisher:Cengage Learning
Types of Foundation in building construction in detail - Civil Engineering Videos; Author: Civil Engineers;https://www.youtube.com/watch?v=7sl4KuM4UIE;License: Standard YouTube License, CC-BY
Types of Foundation || Foundation Engineering; Author: Civil Engineering;https://www.youtube.com/watch?v=AFLuAKGhanw;License: Standard Youtube License