Traffic and Highway Engineering
5th Edition
ISBN: 9781305156241
Author: Garber, Nicholas J.
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 8, Problem 15P
To determine
From given problem
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
The total cycle time of an intersection is 60 seconds, the green time for the phase is 27 seconds
and the corresponding yellow time is 4 seconds. If the saturation headway is 2.4 seconds/
vehicle, the startup lost time is 2 seconds/phase and the clearance lost time is 1 second/phase
then the capacity of the movement is
(a) 1500 veh/hr/lane
(c) 500 veh/hr/lane
(b) 700 veh/hr/lane
(d) 300 veh/hr/lane
A signalized intersection approach has two lanes with no exclusive left- or right-turning lanes. The approach has a 50-second green out of a 90-second cycle. The yellow plus all-red intervals for the phase total 4.0 s. If the start-up lost time is 2.0 s/phase, the clearance lost time is 1.5 s/phase, and the saturation headway is 2.25 s/veh under prevailing conditions, what is thecapacity of the intersection approach.
A two-lane minor street crosses a four-lane major street, with traffic conditions
of volumes for each eight hours of an average day (both directions on major
street) is 450 veh/h and the volume minor-street approach (one direction only)
is 96 veh/h. With pedestrian volume of 198 ped/hr during (two hours in the
morning and two hours in the afternoon) and the nearest traffic signal is located
250 ft from this location. The intersection is warranted for:
Select one:
O a.A traffic signal for warrant 4
O b. Not warranted since the nearest intersection is too close
O C.A traffic signal for 70% of the condition of warrant 1
O d. None
Chapter 8 Solutions
Traffic and Highway Engineering
Ch. 8 - Prob. 1PCh. 8 - Prob. 2PCh. 8 - Prob. 3PCh. 8 - Prob. 4PCh. 8 - Prob. 5PCh. 8 - Prob. 6PCh. 8 - Prob. 7PCh. 8 - Prob. 8PCh. 8 - Prob. 9PCh. 8 - Prob. 10P
Ch. 8 - Prob. 11PCh. 8 - Prob. 12PCh. 8 - Prob. 13PCh. 8 - Prob. 14PCh. 8 - Prob. 15PCh. 8 - Prob. 16PCh. 8 - Prob. 17PCh. 8 - Prob. 18PCh. 8 - Prob. 19PCh. 8 - Prob. 20PCh. 8 - Prob. 21PCh. 8 - Prob. 22PCh. 8 - Prob. 23PCh. 8 - Prob. 24PCh. 8 - Prob. 25PCh. 8 - Prob. 26PCh. 8 - Prob. 27PCh. 8 - Prob. 28P
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.Similar questions
- 6. Design signal timing for an intersection with the following details. Assume a total loss time of 3 seconds per phase. Width of lanes are 12 ft each. Assume that there are 20 pedestrians crossing each of the approaches per cycle. Check the signals for pedestrian crossing time. Take pedestrian walking speed as 4 ft/s. Saturation flow rates are: Left-turning: 1600 veh/hr/ln, Through: 1800 veh/hr/In, and Right-turning: 1700 veh/hr/In 488 488 234- 115 C 1051 217 N 338 -338 Phase I Phase II Phase III 11 AN J|| Narrow_forwardFour-phases signal with a cycle time of 80 sec, Inter Green = 4 sec/phase, lost time / phase = 2 sec. Saturation flow on all approaches are similar, but the maximum traffic flows on two of the phases are triple the maximum traffic flows on the remaining two approaches, what will be actual green time on each phase ?arrow_forwardA signalized intersection approach has three lanes with no exclusive left or right turning lanes. The approach has a 40- second green out of a 75-second cycle. The yellow plus all-red intervals for phase total 4.0 seconds. If the start-up lost time is 2.3s/phase, the clearance lost time is 1.1s/phase, and thesaturation headway is 2.48 s/veh under prevailing conditions, a. Calculate the saturation flow rate (veh/hr and whole number) b. Calculate the effective green time (sec and in 1 decimal) c. what is the capacity of the intersection approach? (veh/h/In and 2 decimals)arrow_forward
- 5. Design signal timing for an intersection with the following details. Assume a total loss time of 3 seconds per phase. Width of lanes are 12 ft each. Assume that there are 20 pedestrians crossing each of the approaches per cycle. Check the signals for pedestrian crossing time. Take pedestrian walking speed as 4 ft/s. Saturation flow rates are: Left-turning: 1600 veh/hr/ln, Through: 1800 veh/hr/In, and Right- turning: 1700 veh/hr/In A 488 488 115 1051 217 N 338 -338 (В Phase I Phase II Phase III J!!! J↓↓ Yrarrow_forwardPlease calculate the level of service and delay for the westbound left lane group, the westbound approach, and the whole intersection. I provided LOS chart for reference.arrow_forward5. Design signal for the intersection shown in Figure 1. Assume no pedestrian activity. Assume amber time as 3s and all-red time as 1s for each phase. 750 820 850 765 335 ➖➖➖➖➖➖➖➖ '250 Lane width = 3m Sat. flow rate: ΤΗ -1,800 pcuphgpl TH, RT-1,650 pcuphgpl TH, LT-1,700 pcuphgpl IL tr Phase A Phase Barrow_forward
- The maximum flow that could pass through an intersection from a given approach, if that approach was allocated all of the cycle time as effective green with no lost time. Saturation flow B) cycle flow Peak flow (D Approach capacityarrow_forwardA two-phase signalized intersection is designed with a cycle time of 100 s. The amber and red times for each phase are 4 s and 50 s, respectively. If the total lost time per phase due to start-up and clearance is 2 s, the effective green time of each phase is s. (in integer)arrow_forwardThree-phase a pretimed signalized system for T- intersection, the total lost time per phase is 15 sec. Given that PHF for intersection is 0.91. The table below shows information for all movements included in each phase. (Assume the intersection is isolated, and the traffic flow accounts for the peak 15-min period, and there is no initial queue at the start of the analysis period.) 1 Phase Direction Lane group Number of Lanes Volume (veh/h) 2 Northbound Southbound Northbound LT TH & RT ΤΗ I I 250 1800 390 1800 1 270 1600 2- Determine the average vehicle delay for each traffic lane. 3- Evaluate the level of service (LOS) for each traffic lane. 3 Westbound LT 1 250 2500 Saturation flow (veh/lane/hr) 1- Using the Webster method, determine the optimum cycle length and the effective green time for each phase.arrow_forward
- A traffic signal control is being designed for a four-leg intersection on a divided highway with the characteristics shown in the table below. N-S Approaches E-W Approaches 16 12 3 2 50 40 0% 3% Determine the minimum green times (in s) for each approach if the effective crosswalk width in each direction is 8 ft and the number of pedestrians crossing during an interval is 24 in the N-S direction and 29 in the E-W direction. (Assume the average speed of pedestrians is 3.5 ft/s, and that it is feasible to disregard the yellow change and red clearance intervals.) S G min, N-S Gmin, E-W = Median width, (ft) Number of 12 ft lanes on each approach Design speed, mph Grade = Sarrow_forwardThe following calculations are taken at the approach of an intersection during the morning rush hour. Determine (a) the hourly volume, (b) the peak flow rate in one hour, and (c) the peak hour factor.arrow_forwardThe average normal flow of traffic on cross roads A and B during design period are 400 and 250 pcu per hour; the saturations flow values on these roads are estimated as 1250 and 1000 pcu per hour respectively. The all-red time required for pedestrian crossing is 12 secs. Design two phase traffic signal by Webster's method.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Traffic and Highway EngineeringCivil EngineeringISBN:9781305156241Author:Garber, Nicholas J.Publisher:Cengage Learning
Traffic and Highway Engineering
Civil Engineering
ISBN:9781305156241
Author:Garber, Nicholas J.
Publisher:Cengage Learning