The application that is not suitable for titanium alloy.

Question

Want to see the full answer?

Answer 1

Question

Chapter 8, Problem 14ETSQ

To determine

The application that is not suitable for titanium alloy.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

i need quickly please please please Which of these cast iron would allow the greatest amount of plastic deformation before fracture . Nodular cast iron Grey cast iron White cast iron None of them can be worked. If the diameter of steel specimen stretched by tension load is doubled , then it’s tensile strength will be Halved Remain unaffected Doubled Become four times Temperature is proportional with Percent of elongation Tensile strength Modulus of elasticity All above The tensile strength of a steel specimen that have a 182 HB , equals to 490 MPa 910 MPa 627 MPa Not given…

98) What is another name for austenitic stainless steels?A) p91 steelsB) 18-8 steelsC) p92 steelsD) o1 steelsE) h11 steels 99) which is more important for assembly than its values?A) yield strengthB) hardnessC) sizeD) elastic modulusE) wear behavior 100) which is not one of the general properties shown by almost every metal?A) satietyB) high hardness and strengthC) good wear resistanceD) good thermal conductivityE) good electrical conductivity

What would you expect if you have a 6061 aluminum alloy bar, heat it for 1 hour in the oven forming a single phase, then severely temper it in water and then heat it at 150 ° for 6 hours. ? a) ductility is increased b) increases yield stress c) hardness is reduced d) the material is over-aged and the yield stress is reduced