(a)
Interpretation:
The amount by which
Concept introduction:
Limiting condition of operational amplifier as a comparator implies that the comparator output voltage reaches the limiting value of output which is given here as +13 V on the positive side and
We have,
Corresponding to the positive saturation value and negative saturation value respectively. We need to find the difference in input voltage in each case.
Answer to Problem 3.1QAP
Explanation of Solution
Given the open loop gain A is 100,000
Operational amplifier as a comparator compares two voltages at its respective input terminals
We have to find the amount by which
Case 1: For
Here,
Hence,
This implies
Case 2: For
Here,
Hence,
This implies
(b)
Interpretation:
The amount by which
Concept introduction:
Limiting condition of operational amplifier as a comparator implies that the comparator output voltage reaches the limiting value of output which is given here as +13 V on the positive side and
We have,
Corresponding to the positive saturation value and negative saturation value respectively. We need to find the difference in input voltage in each case.
Answer to Problem 3.1QAP
Explanation of Solution
Given the open loop gain A is 600,000.
Operational amplifier as a comparator compares two voltages at its respective input terminals
We have to find the amount by which
Case 1: For
Here,
Hence,
This implies
Case 2: For
Here,
Hence,
This implies
(c)
Interpretation:
The amount by which
Concept introduction:
Limiting condition of operational amplifier as a comparator implies that the comparator output voltage reaches the limiting value of output which is given here as +13 V on the positive side and
We have,
Corresponding to the positive saturation value and negative saturation value respectively. We need to find the difference in input voltage in each case.
Answer to Problem 3.1QAP
Explanation of Solution
Given the open loop gain A is
Operational amplifier as a comparator compares two voltages at its respective input terminals
We have to find the amount by which
Case 1: For
Here,
Hence,
This implies
Case 2 : For
Here,
Hence,
This implies
Want to see more full solutions like this?
Chapter 3 Solutions
INSTRUMENTAL ANALYSIS-ACCESS >CUSTOM<
- The molar absorptivity for aqueous solutions of phenol at 211 nm is 6.17 × 103 L cm-1 mol-1. Calculate the permissible range of phenol concentrations if the transmittance is to be less than 85% and greater than 7% when the measurements are made in 1.00-cm cells.arrow_forwardConsider a one-dimensional spin 1 model, defined by the Hamiltonian N N H = -JES;Si+1+DES}, where J> 0, D > 0 and Si = -1, 0, 1 (a) Use of periodic conditions of contour, calculate the automatic values of the transfer matrix. (b) Calculate the internal energy and entropy per spin. (c) What is the ground state (T = 0) of this model as a function of the parameter d = DIJ www Get an asymptotic form of the eigenvalues of the download matrix, t → 0 in the d-axis regionsarrow_forwardP1B.1 A rotating slotted-disc apparatus consists of five coaxial 5.0 cm diameter discs separated by 1.0 cm, the radial slots being displaced by 2.0° between neighbours. The relative intensities, I, of the detected beam of Kr atoms for two different temperatures and at a series of rotation rates were as follows: v/Hz 20 40 80 100 120 I (40 K) 0.846 0.513 0.069 0.015 0.002 I (100 K) 0.592 0.485 0.217 0.119 0.057 Find the distributions of molecular velocities, f(v,), at these temperatures, and check that they conform to the theoretical prediction for a one-dimensional system for this low-pressure, collision-free system.arrow_forward
- 3) The solution taken from a factory waste sample to prepare an internal standard contains Pb + 2 and Ag + 2, and the analysis peaks were determined as 298 mAU and 324 mAU. To analyze the unknown, a solution containing 0.150 M, 50.0 mL of Ag + 2 is put into the unknown liquid and completed to 100.0 mL. When the peaks are measured again, 670 mAU and 856 mAU signals are read from the samples. What is the concentration of Pb + 2 in the unknown liquid?arrow_forwardThe molar absorptivity for aqueous solutions of phenol at 211 nm is 6.17 x 103 L cml mol-'. Calculate the permissible range of phenol concentrations if the transmittance is to be less than 85% and greater than 7% when the measurements are made in 1.00-cm cells.arrow_forwardA 1.00 kg weight is traveling at a constant velocity of 10.0 ms-1, in a cubic room 3.00 m on an edge.(a). Determine the sum of the squares of its three quantum numbers.(b). What would be the ground state energy for this weight?arrow_forward
- The student was supposed to measure the pH of a 0.1 M hydrochloric acid solution. For this purpose, he used a pH-meter and obtained the following results: 0.90, 0.93, 1.04, 1.02. Present the appropriate graphic and statistical elaboration of the performed analysis and confirm whether the applied pH-meter worked properly.arrow_forward2. A gas at 300 K and 1 bar (state 1) flows through an adiabatic compressor and exits at 20 bar and 700 K (state 2). The gas obeys the following equation of state, where a and B are constants. v-B The values are given as a = 10-3 _m³k bar mol the gas at 1 bar is Cp = 30 mol K RT ар + P T and B = 8 x 10-5 m³. The heat capacity of molarrow_forward(B) A 0.05 mM solution of DCPIP was placed in a 1 cm spectrophotometer cuvette and a beam of light at 600nm was passed through the cuvette. The extinction coefficient for DCPIP is 3500 L/mole/cm under the specific conditions used. What proportion (as a percentage) of light would emerge from the other side of the cuvette?arrow_forward
- Given the equation of a calibration curve y=5.63x + 0.006, identify the variable that equates to the absorbance value of the Beer's law equation.arrow_forwardWhat is the value of the Born exponent for Fr+?arrow_forwardGiven these two equations, calculate Cv for CO2 and N2 using the velocity of sound. 6. According to statistical mechanics, the contribution to Cy due to the ith vibrational mode of a molecule is c ee;/T Cv,vib,4 = R(7) ³ (e®,/T — 1)² › where Oi = hcv./kB, h is Planck's constant, and c is the speed of light in cm s-¹. v; is the vibrational frequency of the ith vibrational mode in wavenumbers (cm-¹). The quantity O, has dimensions of temperature and is sometimes referred to as the vibrational tem- perature (of the ith vibrational mode). The total vibrational contribution to the molar heat capacity for an N-atom (linear) molecule is then Cy,vib Cv,vib,i Calculate Cy for CO₂ at 300 K, assuming that the translational and rotational con- tributions are (3/2)R and R, respectively, and use the preceding equations to obtain the vibrational contribution. Four vibrational modes for CO₂ are expected (3N- 5). How- ever, three fundamental frequencies are observed at v= 667.3, 1340, and 2349.3 cm-¹.…arrow_forward
- Principles of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage Learning