EBK PHYSICS FOR SCIENTISTS & ENGINEERS
5th Edition
ISBN: 9780134296074
Author: GIANCOLI
Publisher: VST
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 25, Problem 10Q
(a)
To determine
The connection of wires from a battery to obtain the least resistance.
(b)
To determine
The connection of wires from a battery to obtain the greatest resistance.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
The potential difference across the terminals of a battery is 20.0 V when the circuit is open. When a current of 2.0 A flows, the potential difference across the battery drops to 16 V. (a )What is the terminal voltage of the battery? (b) What is the internal resistance of the battery? (c) What external resistance R has been connected to the battery?
(Can I get the answer in not more than 45 mins please? or asap. Thank you!)
cube is made of 12 equal resistors of resistance 1 kΩ in such a way, that each edge of the cube is one resistor, and the resistors are soldered to each other at the vertices. Determine the net resistance of the cube across
(a) an edge(b) a face diagonal(c) a body diagonalof the cube.
6. (a) Charge Q coulombs at time t seconds
is given by the differential equation
Õp
dQ Q
RE+
=0, where C is the capaci-
dt
tance in farads and R the resistance in
ohms. Solve the equation for Q given
that Q=Qo when t=0.
(b) A circuit possesses a resistance of
250 × 10³ 2 and a capacitance of
8.5 x 10–6F, and after 0.32 seconds
the charge falls to 8.0C. Determine
the initial charge and the charge after
1 second, each correct to 3 significant
figures.
-t
Chapter 25 Solutions
EBK PHYSICS FOR SCIENTISTS & ENGINEERS
Ch. 25.2 - If 1 million electrons per second pass a point in...Ch. 25.2 - Prob. 1BECh. 25.3 - Return to the Chapter-Opening Question, page 651,...Ch. 25.4 - Prob. 1DECh. 25.4 - Prob. 1EECh. 25.4 - Prob. 1FECh. 25.4 - How many 60-W 120-V lightbulbs can operate on a...Ch. 25.6 - Each channel of a stereo receiver is capable of an...Ch. 25 - What quantity is measured by a battery rating...Ch. 25 - When an electric cell is connected to a circuit,...
Ch. 25 - When a flashlight is operated, what is being used...Ch. 25 - One terminal of a car battery is said to be...Ch. 25 - When you turn on a water faucet, the water usually...Ch. 25 - Can a copper wire and an aluminum wire of the same...Ch. 25 - The equation P = V2/R indicates that the power...Ch. 25 - What happens when a lightbulb burns out?Ch. 25 - If the resistance of a small immersion heater (to...Ch. 25 - Prob. 10QCh. 25 - Explain why lightbulbs almost always burn out just...Ch. 25 - Which draws more current, a 100-W lightbulb or a...Ch. 25 - Electric power is transferred over large distances...Ch. 25 - A 15-A fuse blows repeatedly. Why is it dangerous...Ch. 25 - When electric lights are operated on low-frequency...Ch. 25 - Driven by ac power, the same electrons pass back...Ch. 25 - The heating element in a toaster is made of...Ch. 25 - Is current used up in a resistor? Explain.Ch. 25 - Compare the drift velocities and electric currents...Ch. 25 - A voltage V is connected across a wire of length l...Ch. 25 - Why is it more dangerous to turn on an electric...Ch. 25 - Prob. 1PCh. 25 - Prob. 2PCh. 25 - Prob. 3PCh. 25 - Prob. 4PCh. 25 - Prob. 5PCh. 25 - Prob. 6PCh. 25 - Prob. 7PCh. 25 - Prob. 8PCh. 25 - Prob. 9PCh. 25 - Prob. 10PCh. 25 - Prob. 11PCh. 25 - Prob. 12PCh. 25 - Prob. 13PCh. 25 - Prob. 14PCh. 25 - Prob. 15PCh. 25 - (II) A rectangular solid made of carbon has sides...Ch. 25 - (III) A hollow cylindrical resistor with inner...Ch. 25 - Prob. 63GP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Suppose you wish to fabricate a uniform wire from 1.30 g of copper. The wire is to have a resistance of R = 0.460 N and all the copper is to be used. (a) What must be the length of this wire? (b) What must be the diameter of this wire? umarrow_forwardSuppose you wish to fabricate a uniform wire out of 1.00 gof copper. If the wire is to have a resistance R= 0.500Ω, andif all the copper is to be used, what will be (a) the length and(b) the diameter of the wire?arrow_forwardV-I Curve for two conductors A and B is shown. Which of the two conductors will have more resistance : A 60 30% (В) В (D) None of these (A) A (C) Both have same resistancearrow_forward
- The wires of our appliances are insulated with a material mixed with rubber, which has a very high resistivity. If a certain wire has a length of 2.5m, the outer diameters is 5mm and its inner diameter is 0.5mm, what is its resistance? Note that the inner diameter is present to leave a hollow place where the conducting wire (usually copper) is present.arrow_forwardDry air is a pretty decent insulator; it has a very high resistivity of 3×10^13Ω⋅m . Consider a capacitor that has square plates 15 cm on a side, separated by 0.8 mm of dry air. The capacitor is charged such that it has a potential of 320 V between the plates. Assuming the voltage on the plates is held fixed, what fraction of the total energy stored in the capacitor is dissipated via conduction through air between the plates in 1 minute? (precision 0.01, already know total energy is 80*10^-6 J) *Answer isn't 0.05 or 0.23arrow_forwardYou want to use three resistors in a circuit. If each of them has a resistance of 3 0, the configuration that will give you an equivalent resistance of 1 Q is ww w - (1) (2) (3) (4) (1) (2) (3) (4) none of these are correct. O o o o oarrow_forward
- Why would batteries with high current capacity have a lower internal resistance than batteries with a low current capacity? Consider the difference between 12 V car batteries and 12 V flashlight batteries. While both batteries supply the same voltage (12 V) of EMF, they have considerably different applications. Use V = E - Ir to explain the answerarrow_forwardA wire with a resistance of 7.6 Q is drawn out through a die so that its new length is 3 times its original length. Find the resistance of the longer wire, assuming that the resistivity and density of the material are unchanged.arrow_forwardCalculate the resistance of 100 m length of a wire having a uniform cross-sectional area of 0.1 mm^2 if the wire is made of manganin having a resistivity of 50 x 10^-8 Ω-m. If the wire is drawn out to three its original length, by how many times would you expect its resistance to be increased?arrow_forward
- The circuit below consists of a battery and a tungsten wire. As shown in the figure, the tungsten wire has a thin (small radius) section in the middle. As charges move from the thick section of wire to the thin section, what happens to the drift velocity? (a) The drift velocity decreases. O (b) The drift velocity increases. (c) More information is needed. O (d) The drfit velocity is unchanged. (e) The drfit velocity is zero.arrow_forwardCarbon-zinc dry cells (sometimes referred to as non- alkaline cells) have an emf of 1.54 V, and they are produced as single cells or in various combinations to form other voltages. (a) How many 1.54-V cells are needed to make the common 9-V battery used in many small electronic devices? (b) What is the actual emf of the approximately 9-V battery? (c) Discuss how internal resistance in the series connection of cells will affect the terminal voltage of this approximately 9-V battery.arrow_forwardWire B has twice the length and twice the radius of wire A. Both wires are made from the same material. If wire A has a resistance R, what is the resistance of wire B? (a) 4R (b) 2R (c) R (d) 1/2R (e) 1/4R.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning