Physical Chemistry
2nd Edition
ISBN: 9781133958437
Author: Ball, David W. (david Warren), BAER, Tomas
Publisher: Wadsworth Cengage Learning,
expand_more
expand_more
format_list_bulleted
Question
Chapter 22, Problem 22.11E
Interpretation Introduction
Interpretation:
The change in pressure on coalscence of two
Concept introduction:
Surface tension is the tension of a liquid surface that causes due to the attraction of liquid particles in the liquid surface by the liquid particle present in the bulk of the liquid. The surface tension tries to attain a minimum surface area. The formula of surface tension is given by the expression as shown below.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Liquid A is known to have a lower surface tension and lower vapor pressure than Liquid B.
Use these facts to predict the result of each experiment in the table below, if you can.
experiment
Identical wire loops are dipped into Liquid A
and Liquid B, so that a film of liquid forms
across the loops (like the bubble solution on a
child's bubble blowing wand). The width of
each loop is increased slowly and the forces
F and F needed to make the loops 5%
wider are measured.
Small amounts of Liquid A and Liquid B are
sprayed into the air, where they form perfect
spheres with a volume of 45.0 μL. The
diameters of these drops are measured with
a high-speed camera, and their surface areas
SA and Sg calculated.
A
A
predicted outcome
will be greater than FB
will be less than F
will be equal to F
It's impossible to predict whether For FB will
be greater without more information.
SA will be greater than S
Swill be less than Sp
SA will be equal to S
It's impossible to predict whether Sor S will
be…
Using 2 mols of ice, a student performed an experiment to determine the molar
enthalpy of fusion for water. The percent error for the experiment was 4.5%, and
the measured value was larger than the accepted value, AH6.01 How much
heat (q), in joules, was absorbed during the experiment?
mol
a).
- 12,561 J
O b) + 270 J
Oc) + 8374
d) + 12,561 J
O e) - 270 J
What is the correct order for the surface tension of the following substances?
Question 1 options:
C8H18 < CHCl3< H2O
H2O < CHCl3 < C8H18
C8H18 < H2O < CHCl3
CHCl3 < C8H18< H2O
CHCl3 < H2O < C8H18
Chapter 22 Solutions
Physical Chemistry
Ch. 22 - Using the explanation of unbalanced forces as the...Ch. 22 - Show that the right side of equation 22.1 has...Ch. 22 - The text claims that surface tension varies with...Ch. 22 - Prob. 22.4ECh. 22 - Prob. 22.5ECh. 22 - Prob. 22.6ECh. 22 - Prob. 22.7ECh. 22 - Equation 22.6 defines surface tension in terms of...Ch. 22 - Prob. 22.9ECh. 22 - Prob. 22.10E
Ch. 22 - Prob. 22.11ECh. 22 - Prob. 22.12ECh. 22 - Prob. 22.13ECh. 22 - Prob. 22.14ECh. 22 - Prob. 22.15ECh. 22 - Prob. 22.16ECh. 22 - Prob. 22.17ECh. 22 - Prob. 22.18ECh. 22 - Prob. 22.19ECh. 22 - Determine the pressure difference on a droplet of...Ch. 22 - Prob. 22.21ECh. 22 - Prob. 22.22ECh. 22 - Prob. 22.23ECh. 22 - Prob. 22.24ECh. 22 - Prob. 22.25ECh. 22 - Prob. 22.26ECh. 22 - Prob. 22.27ECh. 22 - The Young-Dupr equation, equation 22.16, is...Ch. 22 - Why are capillary rises and depressions not seen...Ch. 22 - Prob. 22.30ECh. 22 - Prob. 22.31ECh. 22 - Prob. 22.32ECh. 22 - Prob. 22.33ECh. 22 - Prob. 22.34ECh. 22 - Prob. 22.35ECh. 22 - Prob. 22.36ECh. 22 - Prob. 22.37ECh. 22 - Prob. 22.38ECh. 22 - A china cup breaks when the ionic or covalent...Ch. 22 - Satellites in space often suffer from vacuum...Ch. 22 - Prob. 22.41ECh. 22 - Prob. 22.42ECh. 22 - Prob. 22.43ECh. 22 - Are the following processes examples of...Ch. 22 - Prob. 22.45ECh. 22 - Early attempts to coat metals with Teflon, poly...Ch. 22 - Prob. 22.47ECh. 22 - Prob. 22.48ECh. 22 - Prob. 22.49E
Knowledge Booster
Similar questions
- Why are steam burns so much worse than water burns even if the H2O is at the same temperature for both phases? Hint: Consider the heat of vaporization of water.arrow_forward101 Chem101 Pt Periodic Table - Ptable Answered: Using the data in the cf2o lewis structure - Google Sea X O X A app.101edu.co Question 13 of 34 Submit What amount of heat (in kJ) is required to convert 10.1 g of an unknown solid (MM = 83.21 g/mol) at -5.00 °C to a liquid at 52.3 °C? (specific heat capacity of solid = 2.39 J/g-°C; specific heat capacity of liquid = 1.58 J/g•°C; AHfus = 3.72 kJ/mol; normal freezing point, Tf = 10.3°C) 2.539 kJ 1 2 4 C 7 8 9. +/- х 100 8:02 PM 12/13/2021 ...arrow_forwardQuestion 7 of 28 Submit How much heat (in kJ) would be required to convert 26.0 g of ice to water at 0.00°C? (AHfus = 6.01 kJ/mol for water) kJ 1 2 3 4 5 C 7 8 9 +/- х 10 0 Tap here or pull up for additional resourcesarrow_forward
- (a) If 83.0 g of ice at 0.0oC is placed in 235mL of water at 28.0oC, find the final temperature of water when all of the ice melts. DHfus=6.01 kJ/mol and assume for liquid water density= 1.00 g/mL HINT: you have two parts to find the heat.(remember that the heat lost must equal the heat gained). Part a- find the heat for 83 g of ice melting and then the heat for the liquid to warm up Part b- find the heat for 235 mL H2O to cool down (b) What is the interpretation/finding from this problem?arrow_forward3.) How much heat (J) is required to convert a 90.10 g sample of ice at –45.0°C into to water at 0.0°C? Somepotentially useful physical data for water are: ssolid = 2.03 J/g∙°C; sliquid = 4.18 J/g∙°C; sgas = 1.99 J/g∙°C; ΔHfus =6.01 kJ/mol ; ΔHvap = 40.6 kJ/molarrow_forwardThe temperature of 1.9 kg of water is 100.0°C, but the water is not boiling, because the external pressure acting on the water surface is 3.0 x 105 Pa. Using the vapor pressure curve for water given in the figure, determine the amount of heat that must be added to the water to bring it to the point where it just begins to boil. Pressure, Pa 4 x 105 3 x 105 2 x 105- 1.01 x 105 0.53 x 105 0 50 50 83 100 Temperature, C 100 °C 150 1.01 x 105 Pa 83 C 0.53 x 105 Paarrow_forward
- The surface tension and viscosity of water at several different temperatures are given in this table. Water Surface Tension (mN/m) Viscosity (mPa s) 0 °C 75.6 1.79 20 °C 72.8 1.00 60 °C 66.2 0.47 100 °C 58.9 0.28 As temperature increases, what happens to the surface tension of water? Explain why this occurs, in terms of molecular interactions and the effect of changing temperature. а.arrow_forwardA student performs an experiment to determine the melting point of ice in order to investigate the strength of electrostatic between its molecules. Once the student completes the experiment, which additional action should the student take? O The student should perform experiments using different amounts of ice, then use the result closest to 0°C. The student should perform experiments using different amounts of ice, then take the average of all of the Item results. O The student should perform multiple trials of the same experiment, then use the result closest to 0°C. Item O The student should perform multiple trials of the same experiment, then take the average of all of the results. Item 2 Item 2 Item 26 https://prodpc-cdn-learnosityassessmentvitwer.emssvc.connexus.com/index.html# Type here to search 61 Farrow_forwardChemistry The vapor pressure, P, of a certain liquid was measured at two different temperatures, T. The data is shown in this table. T (K) P (torr) 293.6 145.3 356.9 783.5 If you were going to graphically determine the enthalpy of vaporization, AHmp, for this liquid, what points would you plot? To avoid rounding errors, use three significant figures in the x values and four significant figures in the y values. point 1: x = point 1: y = point 2: x = point 2: y = Determine the rise, run, and slope of the line formed by these points. rise: run: slope: What is the enthalpy of vaporization for this liquid? AHap = J/molarrow_forward
- which one will have the higher value for surface tension when it is in the liquid phase? CS2 or XeO3arrow_forwardAt 1 atm, how much energy is required to heat 41.0 g H2O(s) at −22.0 ∘C to H2O(g)at 119.0 ∘C? Use the heat transfer constants found in this table. ?= _______ kj Transfer Constants- Quantity per gram per mole Enthalpy of fusion 333.6 J/g 6010. J/mol Enthalpy of vaporization 2257 J/g 40660 J/mol Specific heat of solid H 2 O (ice) 2.087 J/(g·°C) * 37.60 J/(mol·°C) * Specific heat of liquid H 2 O (water) 4.184 J/(g·°C) * 75.37 J/(mol·°C) * Specific heat of gaseous H 2 O (steam) 2.000 J/(g·°C) * 36.03 J/(mol·°C) *arrow_forward1 Intermolecular Forces Water is a polar molecule. It has an electric dipole strength of p = 6 x 10-30 C - m. This is roughly equivalent to a proton and an electron separated by a distance of d = 4 x 10-11 m (about the radius of a hydrogen atom). In this problem, we will use Coulomb's law to compare the force between two protons (H*), a proton and a water molecule, and two water molecules. Use the arrangement of the charges shown in the figure for your calculations. (a) r (b) (c) r (a) First, consider interactions at "short" distances. A chemical bond has a length on the order of r = 0.1 nm. • What is the force between two protons separated by a distance of r = 0.1 nm? • What is the force between a proton and a water molecule separated by a distance of r = 0.1 nm? What is the force between two water molecules separated by a distance of r = 0.1 nm? (b) Now consider a "long" distance: a separation of R = 1.0 nm. (This is about the length of ten hydrogen atoms lined up next to each…arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physical ChemistryChemistryISBN:9781133958437Author:Ball, David W. (david Warren), BAER, TomasPublisher:Wadsworth Cengage Learning,Chemistry by OpenStax (2015-05-04)ChemistryISBN:9781938168390Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark BlaserPublisher:OpenStaxChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
Physical Chemistry
Chemistry
ISBN:9781133958437
Author:Ball, David W. (david Warren), BAER, Tomas
Publisher:Wadsworth Cengage Learning,
Chemistry by OpenStax (2015-05-04)
Chemistry
ISBN:9781938168390
Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser
Publisher:OpenStax
Chemistry & Chemical Reactivity
Chemistry
ISBN:9781133949640
Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel
Publisher:Cengage Learning
Chemistry & Chemical Reactivity
Chemistry
ISBN:9781337399074
Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel
Publisher:Cengage Learning