(a)
The resistors with maximum current.
Answer to Problem 5TP
Explanation of Solution
Given:
Parallel combination of two
Source voltage =
Calculations:
With the given information, following circuit diagram can be drawn:
Here, the resistors
The resistor which provides the maximum current is
Conclusion:
Thus,
(b)
The resistor with maximum voltage drop.
Answer to Problem 5TP
Each of the resistor connected in parallel have the maximum voltage drop.
Explanation of Solution
Given:
Parallel combination of two
Source voltage =
Calculations:
With the given information, following circuit diagram can be drawn:
Here, the resistors
To find the voltage drop in the above circuit, compare the voltage across of
So, for finding the voltage drop, find the equivalent resistance separately as follows:
Conclusion:
Thus, the equivalent resistance of
(c)
The power dissipated in each of the resistor and total power dissipated in all resistor.
Answer to Problem 5TP
20 W in each
Output power source = 144 W.
Yes, they are equal as per law of conservation of energy.
Explanation of Solution
Given:
Parallel combination of two
Source voltage =
Calculations:
With the given information, following circuit diagram can be drawn:
Here, the resistors
The voltage source is
To find the power dissipated in each of the resistor and the total power dissipated in each of the resistor, follow some steps one by one as below:
- Find the equivalent resistance and then find the total current.
- Voltage across parallel combination of resistance.
- Calculate the power dissipated in each resistor are:
- Total power dissipated in all the resistor.
- Find the total power output of the source as follows:
Conclusion:
The power dissipated of all the resistor and the total power output source are equal by the law of conservation of energy.
(e)
The values of all the resistors and the source voltage are doubled.
Answer to Problem 5TP
No effect.
Explanation of Solution
Given:
Parallel combination of two
Source voltage =
Calculations:
With the given information, following circuit diagram can be drawn:
Here, the resistors
If the values of all the resistors and the source voltage are doubled, then there would be no effect on the current.
Want to see more full solutions like this?
Chapter 21 Solutions
COLLEGE PHYSICS
- A 500 resistor, an uncharged 1.50F capacitor,and a 6.16-V emf are connected in series, (a) What is the initial current? (b) What is the RC time constant? (c) What is the current after one time constant? (d) What is the voltage on the capacitor after one time constant?arrow_forwardA 500- resistor, an uncharged 1.50-F capacitor and a 6.16-V emf are connected in series, (a) What is the initial current? (b) What is the RC time constant? (c) What is the current after one time constant? (d) What is the voltage on the capacitor after one time constant?arrow_forwardA flashing lamp in a Christmas earring is based on an RC discharge of a capacitor through its resistance. The effective duration of the flash is 0.250 s, during which it produces an average 0.500 W from an average 3.00 V. (a) What energy does it dissipate? (b) How much charge moves through the lamp? (c) Find the capacitance, (d) What is the resistance of the lamp? (Since average values are given for some quantities, the shape of the pulse profile is not needed.)arrow_forward
- Three 100- resistors are connected as shown in Figure P21.41 The maximum power that can safely be delivered to any one resistor is 25.0 W. (a) What is the maximum potential difference that can be applied to the terminals a and b? (b) For the voltage determined in part (a), what is the power delivered to each resistor? (c) What is the total power delivered to the combination of resistors?arrow_forwardA battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?arrow_forwardA homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters, separated by paper, 0.05 mm thick, of the same area and a dielectric constant of 3.7. The homemade capacitor is connected in series with a 100,00- resistor, a switch, and a 6.00-V voltage source, (a) What is the RC time constant of the circuit? (b) What is the initial current through the circuit, when the switch is closed? (c) How long does it take the current to reach one third of its initial value?arrow_forward
- Consider a series RC circuit as in Figure P18.35 for which R = 1.00 M, C = 5.00 F, and = 30.0 V. Find (a) the time constant of the circuit and (b) the maximum charge on the capacitor after the switch is thrown closed. (c) Find the current in the resistor 10.0 s after the switch is closed. Figure P18.35 Problem 35 and 38.arrow_forwardThe circuit in Figure P21.59 has been connected for a long time. (a) What is the potential difference across the capacitor? (b) If the battery is disconnected from the circuit, over what time interval does the capacitor discharge to one-tenth its initial voltage?arrow_forwardConsider a circuit that consists of a real battery with an emf and an internal resistance of r connected to a variable resistor R. (a) In order for the terminal voltage of the battery to be equal to the emf of the battery, what should the resistance of the variable resistor be adjusted to? (b) In older to get the maximum current from the battery, what should the resistance variable resistor be adjusted to? (c) In order for the maximum power output of the battery to be reached, what should the resistance of the variable resistor be set to?arrow_forward
- Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.arrow_forwardA student makes a homemade resistor from a graphite pencil 5.00 cm long, where the graphite is 0.05 mm indiameter. The resistivity of the graphite is =1.38102/m . The homemade resistor is place inseries with a switch, a 10.00-mF capacitor and a 0.50-V power source, (a) What is the BC time constant of the circuit? (b) What is the potential drop across the pencil 1.00 s after the switch is closed?arrow_forwardA circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The capacitors are connected in parallel, and the parallel connection of capacitors are connected in series with the switch, the resistor and the battery, (a) What is die equivalent capacitance of the circuit? (b) What is the KC time constant? (c) How long before the current decreases to 50% of the initial value once the switch is closed?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegePhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning