Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 21, Problem 2TF
True or False? The ABS lamp turns on whenever the system is actively regulating drive torque and braking force.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Describe the 4 distinct modes the vehicle should be operated in during a road test when diagnosing final drive problem
Technician a says that the malfunction of the ABS can cause the control module to shut off or inhibited the system technician B says the loss of the hydraulic fluid or power booster pressure disables to antilock brake system who is correct
True or False? In most transmissions and transaxles,there is one synchronizer assembly for each speedgear
Chapter 21 Solutions
Automotive Technology
Ch. 21 - What is the purpose of an IVR?Ch. 21 - Explain how an air-core gauge works.Ch. 21 - What are two ways to provide input for the...Ch. 21 - Describe the two types of instrument panel...Ch. 21 - What is the device found in some fuel tanks to...Ch. 21 - What is the correct way to check a coolant...Ch. 21 - What type of sending unit is typically used to...Ch. 21 - What is the major difference between an indicator...Ch. 21 - True or False? A driver information center...Ch. 21 - True or False? The ABS lamp turns on whenever the...
Ch. 21 - The indicator needle on a speedometer is held to...Ch. 21 - Which of the following uses a permanent magnet and...Ch. 21 - What type of memory is used to store the...Ch. 21 - Which of the following is not a true statement...Ch. 21 - Which of the following statements about oil gauge...Ch. 21 - While discussing what the maintenance reminders...Ch. 21 - None of the engines gauges works: Technician A...Ch. 21 - The oil pressure light stays on whenever the...Ch. 21 - A digital speedometer constantly reads 0 mph:...Ch. 21 - All gauges operate but read lower than normal:...Ch. 21 - When testing an engine temperature sensor:...Ch. 21 - The coolant temperature gauge stays low (cold)...Ch. 21 - While discussing the instrumentation on a Toyota...Ch. 21 - The TPM warning lamp is lit: Technician A says...Ch. 21 - The yellow electronic throttle control warning...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- True or False? To eliminate the drain of engine power during times when cooling fan operation is not needed, many of todays belt-driven fans have a fan clutch that prevents the operation of the fan when the engine and radiator are heated up.arrow_forwardTechnician A says that if a drive belt does not have the proper tension, it may produce squealing and chirping noises. Technician B says belt tension should be checked even if the engine has an automatic belt tensioner. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhat four things should be checked before replacing the computer in an ABS?arrow_forward
- Which type of transmission uses pulleys to change engine speed? Dual-dutch Manual Continuously varaible Automaticarrow_forwardTrue or False? The neutral safety switch and reverse lamp switch are typically part of a digital transmission range sensor.arrow_forwardWhich of the following could cause the 4WD indicators not to operate correctly? a. A faulty control module (PCM) b. Inoperative locking hubs C. Worn transfer case clutch d. Damaged transfer case shift leverarrow_forward
- Which of the following would not cause noise while driving in 2WD under a heavy throttle? a. Faulty ignition switch b. Worn transfer case clutch c. Inoperative locking hubs d. Bad front half shaftarrow_forwardName the three main driveline components that are added to a RWD vehicle to make it a 4WD vehicle.arrow_forwardTechnician A says that each ABS has its own diagnostic procedure involving use of the brake and antilock warning lamps, special testers, breakout boxes, scan tools, troubleshooting charts, and wiring diagrams. Technician B says that ABSs vary in the number of codes they can store and whether they will retain the code in memory when the ignition is turned off. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forward
- The yellow electronic throttle control warning lamp comes on occasionally while the vehicle is driven; Technician A says that this means there is a problem with the system. Technician B says that the system is actively regulating drive torque and engine power when the lamp is lit Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardTechnician A says that the accumulator in an ABS is used to store hydraulic fluid to provide residual pressure for power-assist braking. Technician B says that the booster pump in an antilock system provides pressurized hydraulic fluid for the ABS. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forward-occurs When the clutch is fully engaged, the driven disc does not rotate at the same speed as the driving members * Slipping Grabbing Dragging Abnormal noises Skip Defective Thermostat, Obstructed air passage through Radiator, Defective Temperature Gauge are reasons for * Engine overheating Engine overcooling Engine overrating None of them Skiparrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Mechanical Design (Machine Design) Clutches, Brakes and Flywheels Intro (S20 ME470 Class 15); Author: Professor Ted Diehl;https://www.youtube.com/watch?v=eMvbePrsT34;License: Standard Youtube License