Sustainable Energy
2nd Edition
ISBN: 9781337551663
Author: DUNLAP, Richard A.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Question
Chapter 20, Problem 5P
a.
To determine
Find the mass of hydrogen fuel needed to give a vehicle range of 300 km.
b.
To determine
Find the fuel volume if hydrogen is stored in the form liquid hydrogen, compressive hydrogen gas CHG at 500 atm, and
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Q3: B:
A 208 g of C6H6 (78 g/mol.) burns in air according to the equation:
CHs + O2 - CO2 +H2O
What mass of CO2 (44 g/mol.) is produced?
If the average fuel burn of an aircraft is
4,250 pounds / hour and the average speed
of 700 miles per hour, then fuel burn rate
can be calculated and will be one of the
following options
6.071ib/mi
7.061ib/mi
6.571ib/mi
Determine the properties of propane in gaseous state with the help of generalized
compressibility charts according to the conditions given below. Compare the results obtained
with the ideal gas equation of state.
Temperature at 0.006 m³/kg, 7 MPa
Knowledge Booster
Similar questions
- Gasoline a mixed with 9 ft^3 kerosene so that the volume of the mixture in the tank becomes 23ft^3. Determine the specific weight of the mixture in lb/ft^3 (Specitc gravily of Gasoine=0.7and Specific gravily of Kerosene = 0.8 )arrow_forwardWrite an expression for the ratio for ideal combustion of any alkane fuel with chemical formula CxH2x+2. You are essentially looking for a simple function f(x) that satisfies the following relation for any value of x (see attach pic). Show that your function f(x) works for the following alkanes: a. Methane – CH4 b. Ethane – C2H6 c. Propane – C3H8arrow_forwardA mass of gasoline equal to 450kg is stored in a tank. What is its weight in newtons and in pounds on the earth's surface? What would its mass and weight be if located on the moon's surface whre the local acceleration due to gravity is approximately one-sixth that at the earth's surface?arrow_forward
- Discuss the implications of difference in the EROI or efficiency for electric and hydrogen carsarrow_forwardYou are designing an afterburner to treat 2 m³/s of air at 1.02 atm and 20 °C. The pollutant concentration in the air stream is 3 g/m³. The fuel to be added is methane at a volumetric treated air-to-fuel (AF) ratio of 80. Its heat of combustion is 50,100 kJ/kg (you can assume the same for the pollutant). The reaction chamber following the combustion zone is a cylinder. The design flow velocity is 5 m/s and the residence time for the gas stream is to be 1 s. Find (a) the average temperature of the gas leaving the combustion zone and entering the reaction zone in degrees K; (b) the diameter of the reaction chamber in m, and (c) the length of the reaction chamber in m. You can assume that the polluted air to be treated has the properties of air (so the specific heat is 1.1 kJ/kg-K; also use this for the specific heat of the methane, your added fuel).arrow_forwardAn instrumental for the analysis of trace hydrocarbons in air, or in the products of combustion uses a flame ionization detector. The flame in this device is fueled by mixture of 40% (vol.) hydrogen and 60%(vol)helium. The fuel mixture is contrained in a 42.8-liter tank at 1500psig and 298K. The atmospheric pressure is 1000kPa. What is the partial pressure of each constituent in the tank and the total mass of the mixture. Assume Ideal gas behavior for the mixture.arrow_forward
- Question 4 2.5 pts Nitrogen gas can be combined with oxygen to form nitric oxide (NO) as shown in the following chemical reaction: N2 (g) + O2 (g) 2 NO (g) When the reaction is in equilibrium, the concentration of N2, O2 and NO are 280 g/L, 640 g/L, and 750 g/L, respectively. If the concentration of oxygen gas dropped to half, calculate the concentration of nitric oxide (NO) in g/L when the system returns to equilibrium. (N=14, O=16 g/mol) Enter your final answer with 2 decimal places.arrow_forwardThe enthalpy of combustion of benzoic acid (C6 H5 COOH) is commonly used as the standard for calibrating constant-volume bomb calorimeters; its value has been accurately determined to be −3226.7 kJ/mol. When 1.9862 g of benzoic acid are burned in a calorimeter, the temperature rises from 21.84°C to 25.67°C. What is the heat capacity of the bomb? (Assume that the quantity of water surrounding the bomb is exactly 2000 g.)arrow_forwardHenry Ford’s Model T was originally designed and built to run on ethanol. Today, ethanol (190-proof alcohol) can be produced with domestic stills for about $0.85 per gallon. When blended with gasoline costing $4.15 per gallon, a 20% ethanol and 80% gasoline mixture costs $3.28 per gallon. Assume fuel consumption at 25 mpg and engine performance in general are not adversely affected with this 20–80 blend (called E20). How much money can be saved for 15,000 miles of driving per year?arrow_forward
- A certain gasoline weighs 46.91 lb/ft³ What is its mass densityislug/ft³)arrow_forward2. The combined mass of a car and its passengers travelling at 72 km/hr is 3000 Ibm- Find the kinetic energy in BTU of this combined mass.arrow_forwardThe Bunsen burner in your labs are fueled by natural gas, which is mostly methane, CH4. The thermochemical equations for the combustion of methane (burning in oxygen) is: CH4(g) + 2 O2(g) ➔ CO2(g) + 2 H2O (g) ΔH = – 890.3 kJ/mole Calculate ΔH in kJ when 5.00 g CH4 react with an excess oxygen.arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
