Chemical Principles in the Laboratory
11th Edition
ISBN: 9781305264434
Author: Emil Slowinski, Wayne C. Wolsey, Robert Rossi
Publisher: Brooks Cole
expand_more
expand_more
format_list_bulleted
Question
Chapter 2, Problem 3ASA
Interpretation Introduction
Interpretation:
The reason as to why the experiment should not be stopped if the solvent moves
Concept introduction:
Chromatography is the technique used to identify the components of a mixture. The chromatography technique has the efficiency to segregate the mixture containing the different components. Every component has different polarity. The separation of mixture is based upon the polarity of the components present in the mixture.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
5pz is the correct answer. Please explain why. Thank you.
Would this be solved using n=MV??
Explain the difference between random sampling and haphazard sampling as used in Analytical chemistry.
Chapter 2 Solutions
Chemical Principles in the Laboratory
Knowledge Booster
Similar questions
- The proton NMR spectrum of a compound, C3H6Cl2, has a pentet at d 2.19 and a triplet at & 3.72 with a 1:2 integration ratio, respectively. Which compound below best matches the data? A) CH₂CH₂CHC1₂ B) CICH₂CH₂CH₂C1 C) CH3CHCH₂C1 Cl C1 D) CH3CCH3 C1arrow_forwardTime(s) [X3] (mole/L) 0 0.600 500 0.481 1000 0.392 1500 0.336 2000 0.273 2500 0.230 3000 0.181 3500 0.156 4000 0.120 4500 0.106 5000 0.072 plot ln[X3] vs time plot 1/[X3] vs. timearrow_forwardthe heat of combustion of benzoic acid. based on the data and the graph, what is the drift rates the initial and final drift rates (??⁄??)? and (??⁄??)?arrow_forward
- PAPER CROMATOGRAPHY • Define chromatography • Demonstrate an understanding of the process of chromatography • Describe the steps involved in a chromatography investigation Explanation Coloured inks are often made up of several different inks. Each colour of ink will get carried a different distance by the water, allowing you to see all of the different inks. Try this with different colours to see what actually goes into a colour. This technique is called chromatography and can be used in chemistry to find out what is in an unknown mixture. II. Materials .Felt tip pens (non-washable) . Kitchen roll .A bowl or cup . Water • Scissors III. Health and safety • Make sure that you thoroughly clean any equipment after the experiment before using for food IV. Procedure Method 1 1. Take a sheet of kitchen roll and draw a simple picture with a non-washable felt tip pen. 2. Place the sheet over an empty bowl. This is to keep the paper from getting too wet. 3. Carefully add a few drops of water…arrow_forwardThe diffusion rate for a solute is 4.0 × 10-11 kg/s in a solvent-filled channel that has a cross-sectional area of 0.50 cm2 and a length of 0.20 cm. What would be the diffusion rate m/t in a channel with a cross-sectional area of 0.30 cm2 and a length of 0.10 cm?arrow_forwardYou work in a research organization that is looking for markers of various diseases that can be used as a diagnostic for the disease. It has been reported in the past that high levels of Cu are found in the sweat of people with cystic fibrosis. One of the research projects is focused on looking for high levels of Cu in samples that can be obtained non-invasively such as saliva, sweat, hair, nails, etc. The lab will analyze large samples for Cu. What instrument would you recommend purchasing to support this work, Atomic absorption spectrophotometer or an inductively coupled plasma atomic spectrophotometer? Explain the basis for your decision.arrow_forward
- Which of the following compounds has the shortest Xmax? O II OI ||| CONV III IVarrow_forwardTrial [I0:] [HSO: ] Time Rate [HSO3 ]/time 1 49 25 3 16.9 Table-2 Find the concentrations of [IO3] and [HSO3] and enter into the table. Divide the concentration of HSO3 with the time in seconds to get the rate. Volume is assumed to be additive in this experiment. Thus, the total volume of all the solutins is assumed to be 20.0 mL. This introduces a small error that can be considered insignicant. The concentrations of IO; and HSO, (after mixing but before the reaction begins) can be calculated using the relationship: Mailute Vdilute= Mcone Vcone. A sample calculation is shown below for the concentration of IO, in Trial 1: Mailute to be calculated Vdilue 20.0 mL 0.020 M x 2.0 mL Mcone 0.020M V conc 2.0 mL %3D diluted [IO, ] = = 0.0020 M IO, %3D 20.0 mL Similarly, the concentration of HSO; in Trial 1 is calculated thus: 0.010 M x 2.0 mL diluted [HSO, ] =0.0010 M HSO, 20.0 mLarrow_forward2. The goal behind suction filtration is to remove soluble impurities that are on the surface of the crystals. Therefore, why can't you simply use suction filtration instead of recrystallization to purify an impure solid?arrow_forward
- here is the question: Below you will find some data that was found in the lab going through that exact same experiment . The t1 references the temperature the substance had at the start of the data collection as it came out of th solution and left to evaporate. The t2 refers to the temperature lowest temperature that is achieved as the compounds evaporate. Fill out the rest of the table and use the data to answer the followng questions: I AM ATTACHING THE TABLE WITH THE T1 AND T2 VALUES AND THE QUESTIONS THAT FOLLOW 1-7. IF IT TAKES MORE OF MY QUESTIONS FROM MY ALLOTED AMOUNT FROM BARTELBY THAT IS OK TO FINISH THIS WORKSHEETarrow_forwardThe experiment involves diluting a 16% sugar solution, prepared by dissolving 16 g of sugar in 100 mL water. Three different solutions are prepared by mixing the 16% sugar solution with various volumes of water.Make appropriate choices from the dropdowns. Work from left to right. Each answer can be calculated from numbers to the left of it in the row. The objective is to calculate the number in the right-hand most column in each row (% sugar in the solution). 16% sugar solution taken / mL water added/ mL diluted solution / mL Dilutionfactor % sugarin diluted solution 25 25 [ Select right answer] ["50", "25", "100", "150"] [ Select right answer] ["1", "0.5", "2"] [ Select right answer] ["8", "50", "12.5", "25"] 25 8.3 [ Select right answer]…arrow_forwardWhy is it necessary for users to understand the principles behind statistical calculations in chemistry?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Chemical Principles in the LaboratoryChemistryISBN:9781305264434Author:Emil Slowinski, Wayne C. Wolsey, Robert RossiPublisher:Brooks Cole
Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage Learning
Chemical Principles in the Laboratory
Chemistry
ISBN:9781305264434
Author:Emil Slowinski, Wayne C. Wolsey, Robert Rossi
Publisher:Brooks Cole
Chemistry: The Molecular Science
Chemistry
ISBN:9781285199047
Author:John W. Moore, Conrad L. Stanitski
Publisher:Cengage Learning