Cardiopulmonary Anatomy & Physiology
Cardiopulmonary Anatomy & Physiology
7th Edition
ISBN: 9781337794909
Author: Des Jardins, Terry.
Publisher: Cengage Learning,
bartleby

Videos

Textbook Question
Book Icon
Chapter 2, Problem 1RQ

The average compliance of the lungs and chest wall combined is

0.1 L/cm H2O.

0.2 L/cm H2O

0.3 L/cm H2O

0.4 L/cm H2O

Expert Solution & Answer
Check Mark
Summary Introduction

Introduction:

The pulmonary ventilation process depends upon the elastic properties of the lungs and the chest wall. The presence of a pressure gradient allows the gas to move from a higher pressure to a lower pressure, and this is the primary principle of ventilation. The lungs and the chest wall expand when air is taken in, and collapse when air is expelled out, and therefore, they act as springs. The air applies an elastic force to the walls which are clinically evaluated to study the compliance of lungs.

Answer to Problem 1RQ

Correct answer:

0.1 L/cm H2O.

Explanation of Solution

Justification/ Explanation for the correct answer:

Option (a) is given 0.1L/cm H2O. Lung compliance refers to the ability of the lung’s wall to readily accept the elastic force. It is denoted as CL and can be defined as the change in the volume of lungs per unit change in the pressure.

The compliance is expressed in liters per centimeter of water pressure (L/cm H2O). A normal person generates a negative pleural pressure change during inspiration, which is equal to 5 cm H2O. The lungs accept about 500 milliliters or 0.5 liters of volume at this change. Therefore, the compliance can be calculated by using the formula:

Compliance=change in volume in liters (ΔV)change in pressure, ΔP (cm H2O)=0.5 L of gas5 (cm H2O) = 0.1L/cm H2O

Hence, option (a) is the correct answer.

The explanations for the incorrect answers:

Option (b) states that the average compliance is 0.2L/cm of water, which is possible because of the opposing effect of the lungs. The above value is the unopposed compliance of the lungs and because the lungs are attached to the thoracic wall and the lung’ wall and thoracic wall both acts as springs and recoil each other. This decreases the compliance to half value. So, it is an incorrect option.

Option (c) states that the average compliance of the lung and the chest wall is 0.3 L/cm of water, and from the calculation shown above, it cannot be true. So, it is an incorrect option.

Option (d) states that the average compliance of the combined lung and chest wall is 0.4L/cm of water. The unopposed compliance is 0.2 L/cm of water, which is reduced to half, that is, 0.1L/cm of water because of the opposing effects of the lung and thoracic wall. So, it is an incorrect option.

Hence, options (b), (c), and (d) are incorrect.

Conclusion

The combined average compliance of the lung and chest wall is 0.1L/cm of water, which is half of the average compliance of the lung’s wall because the lung and thoracic wall show opposing effects and recoil.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
Students have asked these similar questions
Using any of the wing shape phenotypes. Think carefully about your experimental set-up, which includes the phenotypes of the parents and the expected proportions in the offspring. You will need to propose which trait is dominant, either the wild-type or the mutant. (Note, many of the fruit fly traits are controlled by multiple factors, so you may not get the expected results.) Now answer the questions below:                                                       a) Describe your experimental setup   b) Complete the table showing your observed and expected results.                                         Phenotypes Observed Expected                Use the chi-square calculator to analyze your results.    c) Provide a summary that includes whether you support or reject the hypothesis
a)In general, why do you think GWAS is useful? What kinds of problems could GWAS be used to solve? b) Why do you think SNPs are referred to as “markers” or “signposts”? c) Which types of SNPs affect protein production or function for the gene of interest?
a) Cross a female VG, BL fly with a wild-type male. (ggbb x GGBB).  What are the genotypes and phenotypes of the offspring?   b) Draw a punnett square or a visual representation of the alleles involved in this cross (insert below) to make a prediction about the offspring (assuming genes are unlinked.)   c) Complete the table (ignore sex). Phenotype Observed Proportion + (wild type)     Vestigal wings (B_gg)     Black body (bbG_)     VG, BL (bbgg)                                                           d) How does crossing-over affect the observed outcomes? Explain why the observed flies do not match your predictio
Knowledge Booster
Background pattern image
Biology
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, biology and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Cardiopulmonary Anatomy & Physiology
Biology
ISBN:9781337794909
Author:Des Jardins, Terry.
Publisher:Cengage Learning,
Text book image
Biomedical Instrumentation Systems
Chemistry
ISBN:9781133478294
Author:Chatterjee
Publisher:Cengage
Text book image
Basic Clinical Lab Competencies for Respiratory C...
Nursing
ISBN:9781285244662
Author:White
Publisher:Cengage
Text book image
Biology 2e
Biology
ISBN:9781947172517
Author:Matthew Douglas, Jung Choi, Mary Ann Clark
Publisher:OpenStax
Respiratory System; Author: Amoeba Sisters;https://www.youtube.com/watch?v=v_j-LD2YEqg;License: Standard youtube license